Degradative chain transfer in vinyl acetate polymerizations using toluene as solvent

In this work, we propose that retardation in vinyl acetate polymerization rate in the presence of toluene is due to degradative chain transfer. The transfer constant to toluene (C_trs) determined using the Mayo method is equal to 3.8 × 10^?3, which is remarkably similar to the value calculated from the rate data, assuming degradative chain transfer (2.7 × 10^?3). Simulations, including chain‐length‐dependent termination, were carried out to compare our degradative chain transfer model with experimental results. The conversion–time profiles showed excellent agreement between experiment and simulation. Good agreement was found for the M_n data as a function of conversion. The experimental and simulation data strongly support the postulate that degradative chain transfer is the dominant kinetic mechanism. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 3620–3625, 2007     

Statistical Analysis of the Effect of Mineral Admixtures on the Strength of the Interfacial Transition Zone

Microscopic evidence indicates that the thickness of the interfacial transition zone (ITZ) between the aggregate and the cement paste is modified when mineral admixtures partially replace portland cement. Unfortunately, there is limited information on the significance of these microscopic modifications to the mechanical properties of the ITZ. This research reports experimental results on the shear and tensile strength of the ITZ as affected by the addition of the following mineral admixtures: silica fume, fly ash, and natural pozzolan. Statistical analysis was used to identify the significant parameters affecting the tensile and shear strength of the ITZ. Experimental results indicate that not only does the incorporation of silica fume and fly ash increase the strength of the ITZ, these mineral admixtures have a greater influence on the strength increase of the ITZ than in the strength increase of the cement paste.     

Internal standardization for the determination of cadmium,cobalt, chromium and manganese in saline produced water from petroleum industry by inductively coupled plasma optical emission spectrometry after cloud point extraction

In the present paper a procedure is proposed for the determination of traces of Cd, Co, Mn and Cr in petroleum industry produced water by inductively coupled plasma optical emission spectrometry. The procedure is based on cloud point extraction of these metals, as their dithizonate complexes, into the surfactant-rich phase of octylphenoxypolyethoxyethanol surfactant (Triton X-114). Extractions were carried out in solutions with salinities between 10‰ and 70‰. Since residual salinity in the surfactant-rich phase caused differences in its transport to the plasma, yttrium was used as an internal standard to correct for this effect. The simultaneous metal extraction procedure was optimized by response surface methodology using a Doehlert design and desirability function. Enhancement factors of 21, 21, 9 and 19, along with limits of quantification of 0.093, 0.20, 0.73 and 1.2 μg L^− 1, and precision expressed as relative standard deviation (n = 8, 20.0 μg L^− 1) of 5.8, 1.2, 1.7 and 5.7% were obtained for Cd, Co, Mn and Cr, respectively. The accuracy was evaluated by spike recovery tests on the high salinity water samples with salinity of 40 and 63‰.     

Holographic dark energy and the universe expansion acceleration

By incorporating the holographic principle in a time-depending Λ-term cosmology, new physical bounds on the arbitrary parameters of the model can be obtained. Considering then the dark energy as a purely geometric entity, for which no equation of state has to be introduced, it is shown that the resulting range of allowed values for the parameters may explain both the coincidence problem and the universe accelerated expansion, without resorting to any kind of additional structures.     

Implementation of recycling routes for scanning probe microscopy tips.

In this work, effective, yet simple, recycling mechanisms for used scanning probe microscopy (SPM) tips were implemented. Comprising a tip profile characterization methodology and specific cleaning procedures, which decontaminate SPM tips whether the contamination nature is known or not, such routes were optimized during numerous tests with brand new, previously used, and already discarded categories of SPM tips. The results show that if the used tip suffered contamination only, but no physical damages, during its scanning lifetime, it becomes readily available for reutilization after the cleansing process, characterizing a recycling route. On the other hand, if the tip went through wear and breakages during its utilization, it still can be decontaminated, but may not be directly reutilized due to its inadequate physical profile. Nevertheless, the methodology developed in this work may yet be applied as part of a more complex recycling route.     

A novel strategy to verification of adulteration in alcoholic beverages based on Schlieren effect measurements and chemometric techniques

A novel strategy to evaluation of adulteration in alcoholic beverages based on the measurement of the Schlieren effect using an automated FIA system with photometric detection is proposed. The assay is based on the Schlieren effect produced when beverage samples are injected in a single-line FIA system that uses water as carrier stream and a light-emitting diode-phototransistor photometer controlled by microcomputer as detector. The flow system presents limited mixing conditions which make possible to create gradients of refractive index (Schlieren effect) in the injected sample zone. These gradients are reproducible, characteristic of each alcoholic beverage and undergo specific modifications when adulterations with water or ethanol are imposed. Schlieren effect data of brandies, cachaças, rums, whiskies and vodkas were treated by SIMCA to elaborate class models applied in the evaluation of alcoholic beverages adulteration. Samples of the original matrix of each sort of beverages were adulterated in laboratory by adding water, methanol and ethanol in levels of 5% and 10% (v/v). These samples were used as test set to validate SIMCA class models. The verification of authenticity using Schlieren effect measurements presented good results making possible to identify 100% of the beverages samples adulterated in laboratory and 93% of the actual adulterated alcoholic beverages with confidence levels of 95%. As principal advantage, the automated system does not use reagents to carry out the analysis.     

On the growth type of entire monogenic functions

In this paper we establish an explicit relation between the growth type of general entire solutions to the generalized Cauchy-Riemann system in \mathbbRⁿ⁺¹{\mathbb{R}^{n+1}} and their Taylor coefficients. This formula then enables us to compute the growth type of some higher dimensional generalizations of the trigonometric and special functions that are null-solutions to this system.     

The algebra of implicit operations

For an ordinal and a class of topological algebras of a given type (which may be infinite and may contain inflnitary operations), an-aryimplicit operation on is any new-ary operation whose introduction does not eliminate any continuous homomorphisms between members of . The set of all-ary implicit operations on is denoted by and forms an algebra of the given type which is endowed with the least topology making continuous all homomorphisms into members of . With this topology, is a topological algebra in which the subalgebra of all-ary operations on which are induced by terms is dense, provided that is closed under the formation of closed subalgebras and finitary direct products. This is obtained by realizing as an inverse limit of-generated members of . These results are applied to pseudovarieties of topological and finite algebras.This work was supported, in part, by INIC grant 85/CEX/4. This paper was written while the author was a faculty member at the Universidade do Minho.Presented by Ralph McKenzie.