Modification of the surface state of rough substrates by two different varnishes and influence on the reflected light

Modification of the visual appearance when a rough surface is covered by a varnish is mostly attributed to the levelling of the substrate surface, which depends on the molecular weight of the varnish. The topography of varnished surfaces, however, has never been measured directly. Surfaces of varnishes applied over glass substrates of varying roughness were studied, therefore, using mechanical profilometry. Two different varnishes made with a low and a high molecular weight resin were studied. Both varnishes lower the r.m.s. roughness of the substrates and filter the high spatial frequencies. These results are amplified for the varnish containing the low molecular weight resin. The light reflected by the varnished samples is modelled from these topographical data. Its angular distribution, calculated from the probability density of slopes is presented, taking into account separately the air/varnish and the varnish/substrate interfaces. These analyses are presented in a back-scattering configuration. They show that varnishing significantly reduces the angular width of the reflected light and that this effect is magnified for the low molecular weight resin. Modelling furthermore shows that the influence of the roughness of the varnish/substrate interface is negligible in the total reflected light.     

Fibre raman amplifier properties for applications to long-distance optical communications

This paper reviews recent theoretical and experimental studies on optical amplification by stimulated Raman scattering (Raman amplification) in single-mode optical fibres, and discusses its possible applications to long-distance optical communications. The fibre Raman amplifier can be used as an in-line optical amplifier in both repeaterless and non-regenerative all-optical repeater configurations. In the former application, signal transmission of over 400 km has been predicted theoretically, although high-power pump sources are considered to be required. In the latter configuration, in which optical fibre losses are compensated for by Raman gains, it has been shown that extremely long-distance transmission over more than 1000 km is feasible in terms of signal-to-noise ratio, where the distance achievable is mainly limited by the accumulation of Raman noise. Recent experimental demonstrations including bit-error rate measurements on the Raman amplified signal, and laser-diode pumped amplification, etc., are also reviewed. The results confirm the effectiveness of fibre Raman amplifiers in future long-haul systems.     

On the group extension of the transformation associated to non-archimedean continued fractions

Summary Let F_q be a finite field with q elements. We consider formal Laurent series of F_q -coefficients with their continued fraction expansions by F_q -polynomials. We prove some arithmetic properties for almost every formal Laurent series with respect to the Haar measure. We construct a group extension of the non-archimedean continued fraction transformation and show its ergodicity. Then we get some results as an application of the individual ergodic theorem. We also discuss the convergence rate for limit behaviors.     

Fabrication and transport properties of multiwall carbon nanotube crossroads

A multiwall carbon nanotube crossroads has been fabricated by a manipulation technique using a glass microcapillary, and the low temperature transport properties investigated. The two-terminal conductance of an individual tube shows Tomonaga–Luttinger liquid behavior G∝T^α at high temperature and dI/dV ∝V ^α at low temperature. However, no evidence of such a power-law behavior is obtained in the four-terminal conductance at the junction, where the conductance shows an almost metallic behavior ‘corrected’ by weak localization. Weak localization would essentially appear in electron states at the junctions of MWNTs.     

Local structure analysis of smoky and colorless topaz using single crystal Al NMR

The angular dependence of the ²⁷Al NMR spectrum was measured for single crystals of smoky and colorless topaz, Al₂SiO₄(F,OH)₂. Smoky topaz was obtained by irradiating high energy neutrons to colorless topaz. The quadrupole coupling constant e²Qq/h and the asymmetry parameter η were obtained from the analysis of the angular dependences of quadrupole splitting of the ²⁷Al NMR spectrum. The local structures around the aluminum atoms in smoky and colorless topaz were discussed from the magnitude and the direction of the electric field gradient. The directions of principal axes of the EFG tensor of ²⁷Al were close to the directions of Al-O and Al-F bonds. The difference in the bond lengths between Al(1)-F(1) and Al(1)-F(2) was found to affect the x and y components of the EFG tensor.     

Altered protein synthesis in rat kidney cells exposed to semiconductor materials

It is thought that the extensive industrial use of arsenic, gallium and indium, which have applications as the materials for III–V semiconductors, will increase human exposure to these compounds in the near future. We have undertaken the development of new biological indicators for assessing exposure to these elements. Element-specific alterations in protein synthesis patterns were expected to occur following exposure to arsenic compounds. We examined alterations in protein synthesis in primary cultures of rat kidney proximal tubule epithelial cells by sodium arsenite, gallium chloride and indium chloride, utilizing two-dimensional gel electrophoresis. After incubation with the chemicals for 20 h, newly synthesized proteins were labeled with [³⁵S]methionine. A protein with a molecular weight (M_r) of 30 000 was markedly induced on exposure to 10 μM arsenite or 300 μM gallium chloride, and synthesis of proteins with M_r values of 85 000, 71 000, 65 000, 51 000, 38 000 and 28 000 were also increased by exposure to arsenite and gallium chloride. No significant changes were observed upon exposure to indium. Some of these increased proteins could be heat-shock proteins.     

Purification and characterization of gamma-enolase from various mammals.

The gamma subunit of enolase (gamma-enolase) was purified from the brain tissues of cow, dog, goat, pig, rabbit, and rat. The purification was achieved in only three steps: ammonium sulfate-precipitation, DE 53 cellulose ion-exchange chromatography, and polyacrylamide gel electrophoresis (PAGE) in a preparative mode. The purification procedure was comparatively more simple than previously reported methods, and the yield of gamma-enolase was sufficient for subsequent structural and immunological analyses. In all mammals, the purified gamma-enolase migrated in sodium dodecyl sulfate-PAGE (SDS-PAGE) with a molecular mass of 46 kilodaltons (kDa), and the immunological cross-reactivity between those gamma-enolases was very strong. The structural homology of these gamma-enolases was examined by peptide mapping using cyanogen bromide cleavage and subsequent two-dimensional electrophoresis. The resulting peptide patterns were highly similar and in cow, dog, and goat, the patterns were almost identical. These results indicate that structural homology, that is, the species non-specificity of gamma-enolase, appears to be very high.     

Synthesis of 3-hydroxyindolin-2-one alkaloids, (±)-donaxaridine and (±)-convolutamydines A and E, through enolization-Claisen rearrangement of 2-allyloxyindolin-3-ones

Claisen rearrangement triggered by enolization of 2-allyloxyindolin-3-ones with DBU was performed in order to prepare 3-allyl-3-hydroxyindolin-2-ones. Total synthesis of 3-hydroxyindolin-2-one alkaloids, (±)-donaxaridine, as well as (±)-convolutamydines A and E, was achieved by transformation of the allyl moiety of 3-allyl-3-hydroxyindolin-2-ones.     

On the Metrical Theory of Continued Fraction Mixing Fibred Systems and Its Application to Jacobi-Perron Algorithm

 We study the metrical theory of fibred systems, in particular, in the case of continued fraction mixing systems. We get the limit distribution of the largest value of a continued fraction mixing stationary stochastic process with infinite expectation and some related results. These are analogous to J. Galambos, W. Philipp, and H. G. Diamond–J. D. Vaaler theorems for the regular continued fractions. As an application, we see that these theorems hold for Jacobi-Perron algorithm. Received September 30, 2001; in revised form January 8, 2002     

Approximation of transient temperatures in complex geometries using fractional derivatives

It is shown that time-dependent temperatures in a transient, conductive system can be approximately modeled by a fractional-order differential equation, the order of which depends on the Biot number. This approximation is particularly suitable for complex shapes for which a first-principles approach is too difficult or computationally time-consuming. Analytical solutions of these equations can be written in terms of the Mittag-Leffler function. The approximation is especially useful if a suitable fractional-order controller is to be designed for the system.