Statistical Analysis of the Effect of Mineral Admixtures on the Strength of the Interfacial Transition Zone

Microscopic evidence indicates that the thickness of the interfacial transition zone (ITZ) between the aggregate and the cement paste is modified when mineral admixtures partially replace portland cement. Unfortunately, there is limited information on the significance of these microscopic modifications to the mechanical properties of the ITZ. This research reports experimental results on the shear and tensile strength of the ITZ as affected by the addition of the following mineral admixtures: silica fume, fly ash, and natural pozzolan. Statistical analysis was used to identify the significant parameters affecting the tensile and shear strength of the ITZ. Experimental results indicate that not only does the incorporation of silica fume and fly ash increase the strength of the ITZ, these mineral admixtures have a greater influence on the strength increase of the ITZ than in the strength increase of the cement paste.     

Cems characterization of SnO2 films obtained by sputtering and sol-gel route

Conversion electron Mössbauer spectroscopy (CEMS) has been used to study tin oxide films prepared by sol-gel dipping and sputtering. The spectra of films prepared by sol-gel route result close to that of crystalline SnO₂ after heat treatment at a temperature as low as 150°C. The Mössbauer parameters of as sputter deposited films indicate that the structure of the deposited stannic oxide has an amorphous character more pronounced for thinner samples. The structure becomes predominantly that of crystalline SnO₂ by heating at 550°C for 30 min provided the film thickness is higher than 10 nm.     

Non-local approximation of the Mumford-Shah functional

The Mumford-Shah functional, introduced to study image segmentation problems, is approximated in the sense of -convergence by a sequence of non-local integral functionals. Received June 6, 1996 / Accepted July 11, 1996     

DRIFTS study of surface reactivity to NO2 by zinc nanoparticle aggregates and zinc hollow nanofibers

Zinc nanostructures synthesized with different morphologies from the same evaporation/condensation technique are studied with concern to surface reactivity to NO₂ by Diffuse Reflectance Infrared Fourier Transformed Spectroscopy (DRIFTS). Synthesis of nanopowders is obtained, according to previous work, by gas flow thermal evaporation at 540 °C of bulk Zn grains. Two types of Zn powders are obtained and studied in experiments. The first one is collected on the cold walls of the reactor as a deposit produced by thermophoretic effect. It is constituted by grains (∼10 μm) originated by the stratification of smaller aggregates (∼200 nm) and isolated primary particles (∼50 nm) born in the gas flow. The second type of powder is grown from the condensation of Zn chemical vapors within the expansion orifice of the quartz reactor after relatively long time (∼1 h) deposition process. It is constituted mainly by hollow Zn nanofibers with external and internal diameter about 100 and 60 nm. Preliminary characterization of the two types of powders is made by SEM, TEM, XRD. Thereafter, the two types of samples are studied by DRIFTS at variable temperature (VT). Comparison is made between the home-synthesized nanopowders with respect to commercial Zn standard dust. The Zn hollow nanofibers when exposed to NO₂ are found to exhibit dramatic reactivity, which is not observed at all either in the case of clustered aggregate zinc or of commercial Zn dust powders. Results indicate that, at increasing temperature from RT to 300 °C, the hollow nanofibers surface reacts distinctively with adsorbant gas NO₂, with contemporary formation of a progressively growing narrow absorption band at 2500 cm⁻¹ and contemporary depression of a doublet (∼1600-1628 cm⁻¹) band. In order to justify this striking spectral feature, we propose the occurring of a possible polymerization process at nanofibers surface where most probably as a consequence of pre-treatment and exposure to gas NO₂ a very thin film of ZnO is formed. The possible role of huge specific surface of hollow nanofibers as inferred by preliminary SEM, TEM, XRD studies is discussed.     

Carrier diffusion in InGaAs/GaAs quantum wells grown on vicinal GaAs(0 0 1) substrates

We have investigated the influence of vicinal GaAs substrates on the optical and electronic properties of InGaAs/GaAs quantum wells (QWs). A single In_0.10Ga_0.90As QW was grown by molecular-beam epitaxy on a vicinal GaAs(0 0 1) substrate with a miscut angle of 0° (nominal), 2°, 4° and 6° towards [1 1 0]. The carrier diffusion was obtained by a micro-photoluminescence scan technique that permits to observe the effective diffusion length characterized by the lateral spread of carriers in the QW followed by radiative recombination. The carrier diffusion length was obtained parallel (L_||) and perpendicular (L) to the atomic steps. The diffusion length decreases as the temperature increases up to 100 K. Above this temperature we found different behaviours that depend on the sample miscut angle.     

X-ray structure and circular dichroism of pure rotamers of bis[guanosine-5'-monophosphate(-1)](N,N,N',N'-tetramethylcyclohexyl-1,2-diamine)platinum(II) complexes that have R,R and S,S configurations at the asymmetric diamine

The use of a sterically hindered diamine ligand (Me(4)DACH) has allowed for the first time, the isolation and characterization, both in the solid state (X-ray crystallography) and in solution (circular dichroism), of pure DeltaHT rotamers of [Pt(Me(4)dach)(5'-GMP)(2)] (compounds 1 and 2 for R,R and S,S configurations of the Me(4)DACH ligand, respectively). Comparison of the CD spectra obtained for each rotamer, which differ only in the chirality of the Me(4)DACH ligand (R,R or S,S) or in the chirality of the HT conformation (Delta or Lambda), allowed us to conclude that, in the 200-350 nm range, the contributions to the overall CD spectrum that stem from diamine chirality and diamine-induced chirality of platinum d--d transitions or from sugar chirality are negligible relative to the exciton chiral coupling that occurs for pi-pi* transitions of the cis guanines. Accurate molecular structures of 1.10 D(2)O and 2.14 D(2)O (conventional crystallographic agreement indexes R(1) convergent to 2.07 % and 2.18 %, respectively) revealed that the crystallized rotamers have a DeltaHT conformation that is in agreement with all previously reported X-ray structures of [Pt(diamine)(nucleos(t)ide)(2)] complexes. This conformation allows the 5'-phosphate to be located in proximity to the Me(4)DACH ligand so that (P)O...HC(N) hydrogen-bond interactions exists in both complexes. For both structures, the canting of the guanine planes on the coordination plane is right-handed (R; canting angle (Phi) of 80.9 degrees and 73.2 degrees, respectively); this indicates that the canting direction is driven by the HT conformation chirality (Delta for both compounds) and not by the chirality of the carrier ligand (different for the two compounds). Density functional theory analysis of the conformational space as a function of Phi indicated a good agreement between the computed and experimental structures. The increase in energy for Phi values below 65 degrees and 55 degrees (for 1 and 2, respectively) is mainly due to the short intramolecular contacts between C(8)H and the cis N-Me groups on the same side of the platinum coordination plane.     

Thermochemical studies of phthalimide and two N-alkylsubstituted phthalimides (ALKYL=ETHYL AND n-PROPYL)

The standard (p⁰=0.1 MPa) molar enthalpies of formation, Δ_fH_m⁰, for crystalline phthalimides: phthalimide, N-ethylphthalimide and N-propylphthalimide were derived from the standard molar enthalpies of combustion, in oxygen, at the temperature 298.15 K, measured by static bomb-combustion calorimetry, as, respectively, – (318.0±1.7), – (350.1±2.7) and – (377.3±2.2) kJ mol^–1. The standard molar enthalpies of sublimation, Δ_cr^gH_m⁰, at T=298.15 K were derived by the Clausius-Clapeyron equation, from the temperature dependence of the vapour pressures for phthalimide, as (106.9±1.2) kJ mol^–1 and from high temperature Calvet microcalorimetry for phthalimide, N-ethylphthalimide and N-propylphthalimide as, respectively, (106.3±1.3), (91.0±1.2) and (98.2±1.4) kJ mol^–1. The derived standard molar enthalpies of formation, in the gaseous state, are analysed in terms of enthalpic increments and interpreted in terms of molecular structure.     

Synthesis and N.m.r. studies of bis-trisubstituted phosphine platinum(o) and palladium(o) complexes with push-pull olefins

Summary Platinum(0) and palladium(0) complexes of the type: P₂M(R₁R₂C=CR₃R₄) (P=trisubstituted phosphine; R₁, R₂, R₃ and R₄ are different groups having electron acceptor or electron donor properties; M=Pt or Pd) with so called pushpull olefins, have been prepared and characterized. In some cases unusual patterns in the n.m.r. spectra of olefinic protons were observed. The spectra were analyzed by computer simulation and general rules for ABMX patterns for this type of complexes are given.     

Mössbauer study of LaNiSn and NdNiSn compounds and their deuterides

Summary LaNiSn and NdNiSn compounds and their deuterides have been studied by variable temperature ¹¹⁹Sn M?ssbauer spectroscopy. The hyperfine parameters obtained experimentally are in good agreement with those derived from first principle calculations. The enlargement of quadrupole splitting observed for LaNiSn after deuteration confirms the lower symmetry of electron density around tin atoms indicated by the calculation of partial Sn-p density of states (DOS). Magnetic ordering is observed at low temperature in deuterided NdNiSn.