Equilibrium point damage prognosis models for structural health monitoring

Most structural dynamic systems are of high order; however, they often exhibit phenomena that can be dealt with effectively using low order models. This paper presents a method for describing certain kinds of damage evolution in mechanical systems. The method relies on a simple principle that as damage evolves in a structural dynamic system, the damage indicator (i.e., diagnostic feature) behaves like a stable quasi-stationary equilibrium point in a subsidiary non-linear bifurcating system within the so-called damage center manifold. It is shown that just as linear normal modes govern the behavior of linear structures with idealized damping, so too do non-linear normal forms govern the evolution of damage within structures in many instances. The method is justified with citations from the literature on certain types of mechanical failure and then applied in an experimental case involving reversible damage in a bolted fastener. Off-line experiments on a rotorcraft fuselage show that the evolution of damage is sensitive to both temporal and spatial bifurcation parameters. A diagnostic sensing strategy whereby output-only transmissibility features are used to decrease the order of high order structural dynamic measurements is also described.     

Bei der Zuckerbestimmung

Ohne Zusammenfassung     

Negative luminescence from mid-wave infrared HgCdTe diode arrays

A self-referencing, optical modulation technique was used to measure the negative luminescence efficiencies of an array of mid-wave infrared HgCdTe photodiodes with cutoff wavelength 4.6 μm as a function of sample temperature. The internal efficiency at a wavelength of 4 μm was 93% at 295 K, and nearly independent of temperature in the 240–300 K range. This corresponds to an apparent temperature reduction >50 K at room temperature and >30 K at 240 K. Moreover, the reverse-bias saturation current density was only 0.13 A/cm². The measured transmission and emission spectra were simulated using empirical HgCdTe absorption formulas from the literature.     

Thin film synthesis and the influence of irradiation-induced defects on the superconductivity of La1.8Sr0.2CuO4

Thin superconducting films of La_1.8Sr_0.2CuO₄ have been prepared by magnetron sputter deposition and subsequent temperature treatment. The composition of the films has been determined by Rutherford backscattering and the structure by thin film X-ray diffraction. The onset of superconductivity was about 32 K and the midpoint near 28 K. Defect production in the films by He ion bombardment revealed a drasticT _c reduction with a sensitivity similar to that observed in the Chevrel phases. Oxygen implantation and subsequent annealing led to an enhancement of theT _c onset.     

Zinn und Antimon in Legierungen

Ohne Zusammenfassung