Electrochemical intercalation of O2− in CuAlO2 single crystal and photoelectrochemical properties

The delafossite CuAlO₂ single crystal, prepared by the flux method, is a low mobility p-type semiconductor with a hole mobility of 1.2 × 10⁻⁵ cm⁻² V⁻¹ s⁻¹. The chronoamperometry showed an electrochemical O²⁻ insertion with a diffusion coefficient D _303K of 3.3 × 10⁻¹⁸ cm² s⁻¹. The thermal variation of D in the range 293–353 K gave an enthalpy of diffusion (ΔH) of 44.7 kJ mol⁻¹. CuAlO₂ is photoactive, and the Mott–Schottky plot indicates a flat band potential of +0.42 V vs saturated calomel electrode and a holes density (N _A) of 10¹⁶ cm⁻³. The photocurrent spectra have been analyzed by using the Gartner model from which the absorption coefficients and diffusion lengths were determined. An optical transition at 1.66 eV, indirectly allowed, has been obtained. The spectral photoresponse provides a high absorption at 480 nm. The low quantum yield (η) is attributed to a small depletion length (440 nm) and a hole diffusion width (271 nm) compared to a very large penetration depth (12 μm).     

Preparation and characterization of the system NiMn2O4/TiO2 by sol–gel: application to the photodegradation of benzamide under visible light

Journal of Sol-Gel Science and Technology - Benzamide is successfully degraded on the novel heterosystem NiMn2O4/TiO2 under visible light. The nanosized spinel is synthesized by the sol–gel...     

Vertex-edge domination in graphs

In this paper we study graph parameters related to vertex-edge domination, where a vertex dominates the edges incident to it as well as the edges adjacent to these incident edges. First, we present new relationships relating the ve-domination to some other domination parameters, answering in the affirmative four open questions posed in the 2007 PhD thesis by Lewis. Then we provide an upper bound for the independent ve-domination number in terms of the ve-domination number for every nontrivial connected K_1,k-free graph, with k ≥ 3, and we show that the independent ve-domination number is bounded above by the domination number for every nontrivial tree. Finally, we establish an upper bound on the ve-domination number for connected C₅-free graphs, improving a recent bound given for trees.     

Semiconducting and photoelectrochemical properties of the ilmenite CoTiO3 prepared by wet method and its application for O2 evolution under visible light

Journal of Solid State Electrochemistry - The ilmenite CoTiO3 was synthesized by chemical route, and the decomposition of nitrates was followed by thermal analysis (TG/DTA). The intermediate...     

Efficient diverse approach for quinoxaline‐derived glycosylated and morphinylated analogs

Sulfanyl‐glycosides have been synthesized by reaction of 2,3‐dimercaptoquinoxaline ( 1 ) with acetohalo sugars in presence of base to give the thioglycosides‐derived quinoxalines 5 , 6 , 7 and 9 . Similarly, the acyclic analogs 23 , 24 , 25 , 26 were prepared by coupling of 1 with different acyclo‐alkylating agents. The preparation of 3‐morpholinyl‐quinoxalines 10 and 11 allowed the synthesis of 3‐glycosylsulfanyl‐2‐morpholinyl‐quinoxalines 12 , 13 , 14 and 17 as well as the acyclic analogs 27 , 28 , 29 . Microwave irradiation of the reactants turned out to be preferred over the conventional method for achieving the synthetic goals. This study made an available venue to the synthesis of diverse quinoxaline derivatives. J. Heterocyclic Chem., 2011.     

Sonochemical and sonocatalytic degradation of monolinuron in water

The degradation of the phenylurea monolinuron (MLN) by ultrasound irradiation alone and in the presence of TiO(2) was investigated in aqueous solution. The experiments were carried out at low and high frequency (20 and 800 kHz) in complete darkness. The degradation of MLN by ultrasounds occurred mainly by a radical pathway, as shown the inhibitory effect of adding tert-butanol and bicarbonate ions to scavenge hydroxyl radicals. However, CO(3)(-) radicals were formed with bicarbonate and reacted in turn with MLN. In this study, the degradation rate of MLN and the rate constant of H(2)O(2) formation were used to evaluate the oxidative sonochemical efficiency. It was shown that ultrasound efficiency was improved in the presence of nanoparticles of TiO(2) and SiO(2) only at 20 kHz. These particles provide nucleation sites for cavitation bubbles at their surface, leading to an increase in the number of bubbles when the liquid is irradiated by ultrasound, thereby enhancing sonochemical reaction yield. In the case of TiO(2), sonochemical efficiency was found to be greater than with SiO(2) for the same mass introduced. In addition to the increase in the number of cavitation bubbles, activated species may be formed at the TiO(2) surface that promote the formation of H(2)O(2) and the decomposition of MLN.     

Characterization of cyclic and non-cyclic poly-(ether-urethane)s bio-based sugar diols by a combination of MALDI-TOF and NMR

Matrix-assisted laser desorption/ionization (MALDI) mass spectrometry and NMR spectroscopy have been applied for characterization of novel poly-(ether-urethane)s (PolyEU) based on various diols derived from starch and two diisocyanates. First, numerous polyurethanes soft and hard blocks were prepared by polyaddition of isosorbide (3), isomannide (4) or isoidide (5) with 4,4′-diphenylmethane diisocyanate (MDI) (7) or hexane-1,6-diisocyanate (HDI) (8). The polyaddition of isoidide and MDI yields 85% of polyurethane hard block with high inherent viscosity (η_inh = 0.35 dL/g) with linear chains as the main products. In the case of polyurethane based on isosorbide and MDI a large amount of cyclic compounds was formed with relatively high viscosity (η_inh = 0.29 dL/g) and good yield (77%). This polyurethane hard block presents a high glass transition temperature (T_g = 183 °C) and an excellent thermal stability until 250 °C (T_g = 77 °C of the polyurethane soft block based on isosorbide and HDI). Second, polyaddition of an aliphatic diol (6a) based on isosorbide and MDI yielded new poly-(ether-urethane) soft-hard blocks with quantitative yield (>95%). This polymer is soluble in common organic solvents and has a number-average molecular weight of 7950 Da with a polydispersity index of 1.43. The MALDI-TOF spectrum of this poly-(ether-urethane) indicated the formation of high molar fraction of cycles (Ca and Cb). The pure cyclic poly-(ether-urethane) soft-hard block presents a T_g of 141 °C.     

Physical properties of NxTiO2 prepared by sol–gel route

The compounds N_xTiO₂(x=0, 0.05, 0.1, 0.2) with the anatase structure have been synthesized by Sol–Gel method using Tri-ethyl Amine as nitrogen source and their optical, electrical and electrochemical properties are investigated. The electrical conductivity and thermoelectric power are measured in the temperature rang 300–600 K. The samples exhibit p-type behavior in contrast to TiO₂. The doped-samples exhibit two optical transitions (2.35≤E_h−Vis(eV)≤2.55; 1.97≤E_l−Vis (eV)≤2.06) directly allowed in the visible region, while only one transition is observed in UV region (E_UV∼3.00 eV). Pure TiO₂ shows direct band gap transition of 3.17 eV. The results confirm experimentally the calculations of Di. Valentin et al. [42]. The transitions E_h−Vis and E_l−Vis are attributed respectively to the promotion of electrons from the localized N 2p and π^? N–O bond to the conduction band. In all cases, E_UV is associated to the forbidden band energy. Though that the conductivity is generally improved by doping process, only N_0.05TiO₂ and N_0.1TiO₂ shows an enhanced mobility. The mechanism of conduction takes place by small polaron hopping. The band edge positions of N_xTiO₂ (x=0, 0.05, 0.1, 0.2) at room temperature is predicted from the obtained physical properties. This study proves experimentally the principal role of nitrogen in doping process and permits the electronic states localization associated with N-impurities in TiO₂ anatase.     

Electronic and magnetic properties of Fe<Subscript>2</Subscript>SiC

The electronic structure and magnetic properties of Fe₂SiC compound have been studiedusing the framework of an all-electron full-potential linearized augmented-plane wave(FP-LAPW) method within the local density (LSDA) and + U corrected(LSDA + U)approximations. An antiferromagnetic spin ordering of Fe atoms is shown to be the groundstate for this compound. From the electronic band structures and density of states (DOS),Fe₂SiC has ametallic character and from the analysis of the site and momentum projected densities, itis deduced that the bonding is achieved through hybridization of Fe-3d with C-2p states andFe-3d withSi-3pstates. It is also pointed out that the Fe-C bonding is more covalent than Fe-Si. In theFM phase, the spin polarized calculations indicate that the total magnetic moment ofFe₂SiC increasesfrom 0.41 to 4.33μ _B when the Hubbard U parameter for iron isconsidered.     

MAOS of Sugar Phenylosazones and their Derived Pyrazoles and Triazoles

Microwave‐assisted organic synthesis (MAOS) has proven to be practical to provide heterocycles from sugar osazones; an efficient method was developed for the characterization of sugars via their osazones 1–4 using microwave irradiation. The microwave‐assisted organic synthesis irradiation technique has been applied to convert d‐arabino‐hexose phenylosazone to 2‐phenyl‐4‐(d‐arabinotetrahydroxybutyl‐1,2,3‐triazole (5), which was then oxidized to the corresponding aldehyde whose oxime 9 was transformed to 4‐cyano‐2‐phenyltriazole 10. The condensation of 7 with thiosemicarbozide gave 10. Degradation of 1 afforded mesoxaldehyde 1,2‐bisphenylhydrazone 11, which cyclized to 1‐phenyl‐4‐phenylazo‐pyrazole (12) under acidic conditions. Irradiation of 6 in HBr/AcOH afforded 4‐(d‐arabino‐2′,3′‐di‐O‐acetyl‐1′,4′‐dibromobutyl)‐2‐phenyl‐2H‐1,2,3‐triazole. The acetylated phenylosazone was converted to furopyridazine 14. The irradiation of phenylosazone with acetic anhydride in pyridine gave the respective O‐acetyl derivative, whereas with boiling acetic anhydride gave the pyrazole 14, which afforded 15 and 16.