Graft copolymers of natural rubber and poly(dimethyl(acryloyloxymethyl)phosphonate) (NR-g-PDMAMP) or poly(dimethyl(methacryloyloxyethyl)phosphonate) (NR-g-PDMMEP) from photopolymerization in latex medium

Graft copolymers of natural rubber and poly(dimethyl(acryloyloxymethyl)phosphonate) (NR-g-PDMAMP), and natural rubber and poly(dimethyl(methacryloyloxyethyl)phosphonate) (NR-g-PDMMEP), were prepared in latex medium via a “grafting from” methodology based on the photopolymerization of dimethyl(acryloyloxymethyl)phosphonate (DMAMP) and dimethyl(methacryloyloxyethyl) phosphonate (DMMEP), respectively, used as phosphorus-containing monomers. The grafting polymerization was initiated from N,N-diethyldithiocarbamate groups previously bound in side position of the rubber chains. The effects of monomer concentration on monomer conversion and grafting rate were investigated, showing that conversion and grafting rate increased with increasing monomer concentration and reaction time. Highest conversions and grafting rates were obtained with a molar ratio [DMAMP]/[initiating units] = 7 for a reaction time of 180 min. Calculation of the graft average length () from ¹H NMR spectra of the synthesized graft copolymers showed values were in the range of 9-73. Visualizations of NR-g-PDMAMP and NR-g-PDMMEP latices by Transmission Electron Microscopy (TEM) showed that they exhibit core-shell morphologies. Degradation of NR-g-PDMAMP and NR-g-PDMMEP occurred in two steps: decomposition of dimethylphosphonate-functionalized grafts took place prior to the second step corresponding to the decomposition of NR backbone, but the degradation temperature of this last step was higher than that of pure NR.     

Dynamically cured natural rubber/EVA blends: influence of NR‐g‐poly(dimethyl (methacryloyloxymethyl)phosphonate) compatibilizer

Graft copolymer of natural rubber and poly(dimethyl(methacryloyloxymethyl)phosphonate) (NR‐g‐PDMMMP) was prepared in latex medium via photopolymerization. It was then used to promote the blend compatibility of dynamically cured 40/60 natural rubber (NR)/ethylene vinylacetate copolymer (EVA) blends using various loading levels at 1, 3, 5, 7, 9, 12, and 15 wt%. It was found that the increasing loading levels of NR‐g‐PDMMMP in the blends caused the increasing elastic modulus and complex viscosity until reaching the maximum values at a loading level of 9 wt%. The properties thereafter decreased with the increasing loading levels of NR‐g‐PDMMMP higher than 9 wt%. The smallest vulcanized rubber particles dispersed in the EVA matrix with the lowest tan δ value was also observed at a loading level of 9 wt%. Furthermore, the highest tensile strength and elongation at break (i.e., 17.06 MPa and 660%) as well as the lowest tension set value (i.e., 27%) were also observed in the blend using this loading level of the compatibilizer. Addition of NR‐g‐PDMMMP in the dynamically cured NR/EVA blends also improved the thermal stability of the blend. That is, the decomposition temperature increased with the addition of the graft copolymer. However, the addition of NR‐g‐PDMMMP in the blends caused the decreasing degree of crystallinity of the EVA phase in the blend. However, the strength properties of the blend are still high because of the compatibilizing effect. Copyright © 2009 John Wiley & Sons, Ltd.