Tuning the singlet oxygen quantum yield of near-IR-absorbing porphyrazines

We report the quantum yields for singlet oxygen production by a series of porphyrazines (pz) of the form M[pz(An;B4-n)] (Scheme 1), where the peripheral substituent A is [S-R]2 with R = (CH2CH2O)3H, B is a fused alpha,alpha'-dialkoxybenzo group and M = 2H, Mg or Zn. These compounds show intense near-IR absorbance/emission (longest wavelength emission, approximately 830 nm). Their solubilities vary with R, whereas their optical properties do not. We show that singlet oxygen sensitization by these luminescent compounds can be "tuned" from essentially off to on by varying n and selection among M = 2H, Mg or Zn. The quantum yields vary ca 60-fold within the set of compounds studied, from phidelta = 0.007 for compound 3 to phidelta = approximately 0.4 for compound 11.     

Molecular and Biochemical Characteristics of Recombinant β-Propeller Phytase from Bacillus licheniformis Strain PB-13 with Potential Application in Aquafeed

Phytic acid is the major storage form of organic phosphorus in nature- and plant-based animal feed. It forms insoluble complexes with nutritionally important metals and proteins that are unavailable for monogastric or agastric animals. Phytases initiate the stepwise hydrolysis of phytic acid and release inorganic orthophosphate. In the present investigation, the phytase gene from a phytase producing Bacillus licheniformis strain PB-13 was successfully expressed in Escherichia coli BL21. Recombinant phytase ‘rPhyPB13’ was found to be catalytically active, with an activity of 0.97 U/mL and specific activity of 0.77 U/mg. The rPhyPB13 was purified to 14.10-fold using affinity chromatography. Similar to other β-propeller phytases, purified rPhyPB13 exhibited maximal activity at pH 6.0–6.5 and 60 °C in the presence of 1 mM Ca²⁺ and was highly active over a wider pH range (pH 4.0–8.0) and high temperature (80 °C). It has shown maximum activity towards Na-phytate as substrate. The observed K _m , V _max and k _cat of purified rPhyPB13 were 1.064 mM, 1.32 μmol/min/mg and 27.46 s^?1, respectively. PhyPB13 was resistant to trypsin inactivation, activated in presence of Ca²⁺ and inhibited in presence of EDTA. Crude rPhyPB13 has good digestion efficiency for commercial feed and soybean meal. These results indicate that PhyPB13 is a β-propeller phytase that has application potential in aquaculture feed.     

Effect of Additives on the Activity of Tannase from <Emphasis Type="Italic">Aspergillus awamori</Emphasis> MTCC9299

Tannase from Aspergillus awamori MTCC 9299 was purified using ammonium sulfate precipitation followed by ion-exchange chromatography. A purification fold of 19.5 with 13.5% yield was obtained. Temperature of 30 °C and pH of 5.5 were found optimum for tannase activity. The effects of metals and organic solvents on the activity of tannase were also studied. Metal ions Mg⁺², Mn⁺², Ca⁺², Na⁺, and K ⁺ stimulated the tannase activity, while Cu⁺², Fe⁺³, and Co⁺² acted as inhibitors of the enzyme. The addition of organic solvents like acetic acid, isoamylalcohol, chloroform, isopropyl alcohol, and ethanol completely inhibited the enzyme activity. However, butanol and benzene increased the enzyme activity.     

Densities, speeds of sound and viscosities of binary liquid mixtures of octan-2-ol with benzene and halobenzenes at 298.15 and 303.15 K

Densities ρ, speeds of sound u, viscosities η and refractive indices n_D of binary mixtures of octan-2-ol with benzene, chlorobenzene and bromobenzene have been measured over the entire range of composition at 298.15 and 303.15 K and atmospheric pressure. From the experimental data, excess molar volumes V^E, isentropic compressibilities κ_S, excess isentropic compressibilities κ_S^E, and deviations of speeds of sound u^D, have been calculated at 298.15 and 303.15 K. These excess functions have been fitted to the Redlich-Kister polynomial equation. The viscosity data have been correlated using Kendall-Monroe, Grunberg-Nissan, Tamura-Kurata, Hind-Mclaughlin Ubbelohde and Katti-Chaudhary viscosity models, and McAllister's three-body interaction model at different temperatures.     

BIODISTRIBUTION AND PDT EFFICACY OF A KETOCHLORIN PHOTOSENSITIZER AS A FUNCTION OF THE DELIVERY VEHICLE

Abstract C8KC is a new ketochlorin photosensitizer that must be formulated with an emulsifier because of its poor water solubility. In this report, we compare properties of Cremophor EL (CRM) and Tween 80 as delivery vehicles for C8KC. Unlike Tween 80, CRM altered the physical properties of both human and mouse plasma lipoproteins, resulting in decreased electrophoretic mobility of the individual lipoproteins along with the formation of a l ipoprotein degradation product: a phospholipid fraction of low buoyant density. In human plasma, where there was sufficient low-density lipoprotein (LDL) for a distinction to be made, CRM caused a shift in binding of a ketochlorin from albumin to LDL and the degraded lipoprotein fraction. In mice bearing the RIF tumor, the use of CRM for drug formulation was associated with longer plasma and tissue persistence of C8KC, and enhanced photodynamic therapy (PDT) efficacy. These results indicate the importance of both sensitizer and vehicle as determinants of PDT efficacy.     

Thin-layer chromatography of isomeric pairs of chalkones and flavanones

Summary A fundamental two-dimensional thin-layer chromatographic technique using silica gel as adsorbent for the detection and identification of isomeric pairs of chalkones and flovanones is described. The proposed method is simple, inexpensive and needs no sophisticated instruments.     

High reflectivity phase conjugation in magnetized diffusion driven semiconductors

Optical phase conjugation via stimulated Brillouin scattering (OPC-SBS) in magnetized diffusion driven semiconductors under the off-resonant transition regime has been investigated theoretically. The model is based upon the coupled-mode approach and incorporates the effect of pump absorption through the first-order induced polarization. The linear dispersion is found not to affect the reflectivity of the phase conjugate Stokes shifted Brillouin mode. The reflectivity of the image radiation is dependent upon the Brillouin susceptibility and can be significantly enhanced through n-type doping of the crystal and the simultaneous application of magnetic field. Moreover, the threshold of the pump intensity required for the occurrence of SBS in the crystal with finite optical attenuation can be considerably diminished through a suitable choice of the excess carrier concentration and the magnetic field. Consequently, OPC-SBS becomes a possible tool in phase-conjugate optics even under not-too-high power laser excitation by using moderately doped n-type semiconductors kept under the influence of magnetic field. Numerical estimates made for n-InSb crystal at 77 K duly irradiated by nanosecond pulsed 10.6 μm CO₂ laser show that high OPC-SBS reflectivity (70%) can be achieved at pump intensities below the optical damage threshold if the crystal is used as an optical waveguide with relatively large interaction length (L ∼5 mm) which proves its potential in practical applications such as fabrication of phase conjugate mirrors.     

Spectroscopy, binding to liposomes and production of singlet oxygen by porphyrazines with modularly variable water solubility

Three novel classes of porphyrazine-like structures were synthesized to form modular structures in which lipophilicity and water solubility can be tuned. Subtle modification of solubility is an important criterion in selecting a compound for biological photosensitization. The general structure takes the form H2[pz(AnB4-n)], where the core is a porphyrazine (pz) group, A is a pyrrole ring with two sulfide linkages (SR moieties) and B is a pyrrole fused with a 4,7-bis(isopropyloxy)benzo group, with n=4, 3 and 2. These molecules possess their longest wavelength absorption band between 700 and 810 nm, hence laser beams of higher tissue penetration depth could be used to illuminate them in photodynamic therapy (PDT). Armed with absorption bands in the far-red and near-infrared (near-IR), and a capability to tune the solubility, these molecules could make for better sensitizers because of optimized uptake by lipidic membranes and better optical properties. We tested several derivatives of the A4, A3B and A2B2 structures for their singlet oxygen quantum yields in methanol and in liposomes, using 9,10-dimethyl anthracene (DMA) as a singlet oxygen target. Singlet oxygen quantum yields in liposomes ranged from 0.01 to 0.44, with the A2B2 group showing the most promise. In the binding assay to find the equilibrium binding constant, Kb, we detected fluorescence changes due to a change in environment. Peripheral long-chain moieties (the R group in the SR moieties) dominate lipid binding. These moieties range in the hydrophobicity that they induce from C8H17 and benzene, which rendered the molecule totally insoluble in water, to polyethylene glycol (PEG) and carboxylate groups, which imparted water solubility. Each molecule had between 4 and 8 such identical chains. Chains bearing an ether or ester link resulted in measurable equilibrium constants, with a higher Kb for ether substituents. Results for Kb ranged from 0.23 to 26.52 (mg mL(-1))(-1). A delicate balance exists between water solubility and good partitioning to membranes. In general, a higher oxygen-to-carbon ratio in the chains improves binding. Fewer chains and a centrally coordinated zinc ion further improve binding and singlet oxygen production.     

Simultaneous quantification of five marker compounds of Betula utilis stem bark using a validated high-performance thin-layer chromatography method

A sensitive, selective and robust densitometric high-performance thin-layer chromatographic method was developed and validated for five marker compounds, namely betulin, lupeol, oleanolic acid, 3-acetyloleanolic acid and β-sitosterol, known for their various therapeutic activities. The marker compounds have been isolated from the stem bark of Betula utilis, well characterized by the spectral analysis, and their simultaneous quantitative determination carried out by high-performance thin-layer chromatography (HPTLC) method. The resolution of marker compounds was carried out on silica-gel 60 plates, using n-hexane:ethyl acetate (8:2 v/v) as the mobile phase. The HPTLC densitometry was performed at 500-nm wavelength after the post chromatographic derivatization with ceric ammonium sulfate reagent. The optimized method provided good linear relation (r>0.9960) for all the investigated analytes. The method is simple, and reproducible, which may be applied for quantitative analysis of the above-mentioned marker compounds.     

Finite Element Analysis for Mass-Lumped Three-Step Taylor Galerkin Method for Time Dependent Singularly Perturbed Problems with Exponentially Fitted Splines

The motive of the current study is to derive pointwise error estimates for the three-step Taylor Galerkin finite element method for singularly perturbed problems. Pointwise error estimates have not been derived so far for the said method in the finite element framework. Singularly perturbed problems represent a class of problems containing a very sharp boundary layer in their solution. A small parameter called singular perturbation parameter is multiplied with the highest order derivative terms. When this parameter becomes smaller and smaller, a boundary layer occurs and the solution changes very abruptly in a very small portion of the domain. Because of this sudden change in the nature of the solution, it becomes very difficult for the numerical methods to capture the solution accurately specially in the boundary layer region. In the present study finite element analysis has been carried out for such one-dimensional singularly perturbed time dependent convection-diffusion equations. Exponentially fitted splines have been used for the three-step Taylor Galerkin finite element method to converge. Pointwise error estimates have been derived for the method and it is shown that the method is conditionally convergent of first order accurate in space and third order accurate in time. Numerical results have been presented for both the linear and nonlinear problems.