Heterocyclic compounds from 3-(4-phenyl) benzoyl propionic acid

3-(4-Phenyl) benzoyl propionic acid was used as the starting material for the synthesisof furanones (2), pyrrolinones (5), pyridazinones (7), benzoxazinones (8) and quinazolinones (9-11). The behaviour of the derivatives of furanones and benzoxazinones toward different nucleophiles is reported.     

Influence of vanadium doping on the behavior of YBa_2Cu_3O_7-y

YBa2Cu3-xVxO7-y(x=0, 0.1, 0.2, 0.3, 0.4, 0.5 and 0.6) superconductors have been prepared. X-ray diffraction shows that the system remains orthorhombic for all compositions studied, but for x > 0.4 V2O5 was detected as an impurity phase. Substitution of V5+ for Cu2+ occurs in the Cu(2) sites on the Cu(2)-O planes. The introduction of the high valence element, vanadium, produces the extra free-electrons. These electrons recombine with the positive carrier of the system. It makes depression of the mobility and the Hall number of YBa2Cu3-xVxO7-v and also results in a depression of TC.     

CHEMILUMINESCENCE AND FLUORESCENCE OF THE EUROPIUM IONS-ADENINE NUCLEOTIDES SYSTEM AND ITS POSSIBLE BIOLOGICAL SIGNIFICANCE

Abstract— Chemiluminescence of the Eu(II)/Eu(III)-adenine nucleotide-H₂O₂ system and fluorescence of the Eu(III)-adenosine triphosphate system have been investigated. The spectral distribution of the chemiluminescence emission has shown an occurrence of three main bands (Λ=470–480,590–620 and ca. 700 nm). The energy transfer process from the adenosine triphosphate molecules to the Eu(III) ions has been observed in the fluorescence spectrum. The examined chemiluminescence and fluorescence spectra show that these both kinds of emission originate from the ⁵ D _***τ⁷F_*** ( n =1–4) transitions in the Eu(III) ions.     

Sodium sulfate influence on the electrodeposition of MnO2 films for application in Supercapacitors

Journal of Solid State Electrochemistry - Manganese dioxide (MD) was synthesized by cyclic voltammetry using 0.5 mol L−1 MnSO4·6H2O as the precursor solution, with and...     

微米铜丝的低温力学性能测试

针对纤维材料变温环境力学性能测试的需要,在华中科技大学研制的纤维材料试验机的基础上引入了温控装置,从而实现纤维材料在高低温环境下的力学性能测试。采用该装置对不同直径微米铜丝在不同温度、不同拉伸速率条件下的力学性能开展实验研究,测试结果表明弹性模量和抗拉强度随温度的降低而线性增加,屈服强度的变化不太明显。另外,低温环境下微米铜丝的力学性能表现出与其直径相关的尺度效应,而这一现象在常温下一直没有观测到。最后,还研究了拉伸速率对微米铜丝的力学性能影响,结果表明,在现有装置的许用范围之内,拉伸速率对其力学性能的影响不大。     

An adaptive control scheme for a continuous plant under Known output delay, unmodelled dynamics, and input saturation

This paper deals with robustness of adaptive control of continuoussystems subject to known output delay, input saturation, unmodelledlinear dynamics, and bounded disturbances. A simple gradient-typealgorithm with a relative deadzone is used. The relative deadzoneis built with an estimated contribution of the unmodelled dynamicsto the system output. The basic tool used for stability androbustness analysis is Gronwall's lemma.     

Morphology and performance of CoOOH films synthesized via electrochemical oxidation: substrate effects

In the present work, CoOOH films are synthesized from the electrochemical oxidation of α-Co(OH)₂ as precursor. The substrate influences on the material electrochemical properties are studied. The samples are structural and morphologically characterized using techniques of X-ray diffraction (XRD) and scanning electronic microscopy (SEM). The cyclic voltammetry, galvanostatic charge-discharge, and electrochemical impedance spectroscopy techniques are used for the electrochemical characterization. The films deposited on steel substrate grew in the vertical hexagonal platelet form. Meanwhile, films on Ti plate presented morphology in agglomerated sphere form. After electrochemical oxidation, the film initial morphology is maintained. The films deposited on steel plate have a structure which favors charge storage showing a high specific capacity value (110.92 mA h g^?1) and cyclic stability of 92% after 1000 cycles. Finally, the relaxation time constant value calculated was 5.6 s. This fact is making this material as a possible good candidate for application as electrode material or additive for other materials, in energy storage devices.     

Synthesis of Na<Subscript>2</Subscript>Ti<Subscript>3</Subscript>O<Subscript>7</Subscript> nanoparticles by sonochemical method for solid state electrolyte applications

Na₂Ti₃O₇ ceramic materials have been widely used in sodium-ion battery applications with relative good results; however, there are still several studies that might be carried out in the improvement of the Na₂Ti₃O₇ properties and the overall batteries’ performance. In this direction, we used sonochemical method following a thermal treatment in order to synthetized pure phase Na₂Ti₃O₇ nanopowders. X-ray diffraction characterization revealed that Na₂Ti₃O₇ is the primary phase in nanopowders and ceramic sample; although, a high level of amorphization was observed in the sonicated nanopowder without heat treatment process. Nanopowder-prepared ceramic sample showed a crystallite size of 50 nm after sintering at 900 °C for 1 h. The specific surface area, pore volume, and pore size were obtained from the B.E.T. measurements, being 51 m² g^?1, 0.07 cm³ g^?1, and 55 Å, respectively. The capacitance values of the nanopowder-prepared ceramic sample were in the order of microfarad. The total energy of the system was used to determine relaxation time of the sample (τ ₀ = 31 ms).     

电感耦合等离子体-发射光谱法（ICP-AES）快速测定饮用水中8种微量元素

用电感耦合等离子体-发射光谱法（ICP-AES）同时快速测定饮用水中微量的铜、铅、锌、铁、锰、镉、铬、砷,具有快速、简便、灵敏度高等优点,精密度为1．2％～8．2％（RSD,n=5）．回收率为90％～110％．