排序方式: 共有11条查询结果,搜索用时 15 毫秒
1.
We have devised a new method for bis(tributyltin)oxide (TBTO) determination in marine sediments and mussels. This technique involves an n-hexane/methylene chloride mixture extraction and extract purification with a sodium hydroxide wash in order to eliminate interfering compounds. TBTO is then extracted again by nitric acid and converted into an inorganic tin species; the analysis has been effected using Zeeman graphite furnace-atomic absorption spectrophotometry. The method detection limit for the matrices examined is 0.004 μg TBTO g?1 (wet weight) and is sufficient for the analysis in real samples. The percentage recovery of TBTO from sediments and mussels samples is higher than 85% and 95% respectively. This method has been applied to TBTO level determination in sediments and mussels (Mytilus galloprovincialis) sampled in the harbour area in Taranto, where mussel culture activities are much developed; the TBTO levels obtained in sediments and mussels were in the range 15-47 ng g?1 (wet weight) and 11-30 ng g?1 (wet weight) respectively. Such values are comparable with those found in other harbour areas in the Mediterranean Sea. 相似文献
2.
Cu12As3VS16, a New Compound in the Sulvanite-Enargite System The compound Cu12As3VS16 is formed by solid state reaction between Cu3AsS4 (enargite) and Cu3VS4 (sulvanite). The X-ray powder diagram shows a cubic pattern (a = 10.528 Å) but the compound exhibits a slight optical anisotropy. The specific resistivity of Cu12As3VS16 is 107 Ωcm, the Seebeck coefficient +390 μV/K. The i.r. spectrum has been measured. Mixed crystals and other compounds in the system enargite-sulvanite have not been observed. 相似文献
3.
Leite FL Neto Mde O Paterno LG Ballestero MR Polikarpov I Mascarenhas YP Herrmann PS Mattoso LH Oliveira ON 《Journal of colloid and interface science》2007,316(2):376-387
Understanding the adsorption mechanisms in nanostructured polymer films has become crucial for their use in technological applications, since film properties vary considerably with the experimental conditions utilized for film fabrication. In this paper, we employ small-angle X-ray scattering (SAXS) to investigate solutions of polyanilines and correlate the chain conformations with morphological features of the nanostructured films obtained with atomic force microscopy (AFM). It is shown that aggregates formed already in solution affect the film morphology; in particular, at early stages of adsorption film morphology appears entirely governed by the chain conformation in solution and adsorption of aggregates. We also use SAXS data for modeling poly(o-ethoxyaniline) (POEA) particle shape through an ab initio procedure based on simulated annealing using the dummy atom model (DAM), which is then compared to the morphological features of POEA films fabricated with distinct pHs and doping acids. Interestingly, when the derivative POEA is doped with p-toluene sulfonic acid (TSA), the resulting films exhibit a fibrillar morphology-seen with atomic force microscopy and transmission electron microscopy-that is consistent with the cylindrical shape inferred from the SAXS data. This is in contrast with the globular morphology observed for POEA films doped with other acids. 相似文献
4.
Leonardo G. Paterno Carlos J. L. Constantino Osvaldo N. Oliveira Jr. Luiz H. C. Mattoso 《Colloids and surfaces. B, Biointerfaces》2002,23(4):257-262
The interaction of poly(o-ethoxyaniline) (POEA) doped with HCl and sulfonated lignin (SL) was investigated using UV–Vis spectroscopy in order to probe the influence of pH and quantity of SL on the formation of a polyelectrolyte complex. The introduction of SL into the HCl doped POEA solution screens the positive charges of the protonated POEA allowing further protons to be pumped into the conducting polymers thus increasing its doping level. In addition, the strong interaction between these two electrolytes caused POEA to remain doped within a wide pH range. Layers were built from aqueous solutions of the complex formed by POEA and SL which were alternated with either pure POEA or sulfonated polystyrene in the form of layer-by-layer films. The resulting multilayer films remained doped even at pH 9.0, due to the strong complex formation, which prevents POEA from deprotonating. Surface potential measurements showed that the potential for the POEA+SL complex is more positive than for films with each layer investigated separately, thus confirming the strong interaction between POEA and SL. 相似文献
5.
X-ray and Vibrational Spectroscopical Investigation of the Mixed Crystal Series Cu3MxM′1-xX4 (M, M′ = V, Nb, Ta; X = S, Se) with Sulvanite Structure Solid solutions Cu3MxM′1-xX4 (M, M′ = V, Nb, Ta; X = S, Se) with Sulvanite structure have been prepared in the range 0 ≤ x ≤ 1 by solid state reaction between 600°C and 900°C. The lattice constants decrease linearly with x. The UR active antisymmetrical as well as the Raman active symmetrical M–X stretching vibrations may be attached to independently vibrating MX4 and M′X4 tetrahedrons. 相似文献
6.
St. Cannizzaro E. Paterno J. Guareschi P. Spica D. Toscani A. Mosso A. Moriggia und L. Brieger 《Fresenius' Journal of Analytical Chemistry》1886,25(1):463
Ohne Zusammenfassung 相似文献
7.
Ribeiro Camila de Lima Santos João G. M. Souza Jurandir R. Paterno Leonardo G. 《Journal of Solid State Electrochemistry》2019,23(3):783-793
Journal of Solid State Electrochemistry - The present work reports the performance and the mechanism of detection of a voltammetric sensor for salicylic acid (SA) in a skin care product employing a... 相似文献
8.
Alcantara GB Paterno LG Afonso AS Faria RC Pereira-da-Silva MA Morais PC Soler MA 《Physical chemistry chemical physics : PCCP》2011,13(48):21233-21242
The paper reports on the successful use of the quartz crystal microbalance technique to assess accurate kinetics and equilibrium parameters regarding the investigation of in situ adsorption of nanosized cobalt ferrite particles (CoFe(2)O(4)--10.5 nm-diameter) onto two different surfaces. Firstly, a single layer of nanoparticles was deposited onto the surface provided by the gold-coated quartz resonator functionalized with sodium 3-mercapto propanesulfonate (3-MPS). Secondly, the layer-by-layer (LbL) technique was used to build multilayers in which the CoFe(2)O(4) nanoparticle-based layer alternates with the sodium sulfonated polystyrene (PSS) layer. The adsorption experiments were conducted by modulating the number of adsorbed CoFe(2)O(4)/PSS bilayers (n) and/or by changing the CoFe(2)O(4) nanoparticle concentration while suspended as a stable colloidal dispersion. Adsorption of CoFe(2)O(4) nanoparticles onto the 3-MPS-functionalized surface follows perfectly a first order kinetic process in a wide range (two orders of magnitude) of nanoparticle concentrations. These data were used to assess the equilibrium constant and the adsorption free energy. Alternatively, the Langmuir adsorption constant was obtained while analyzing the isotherm data at the equilibrium. Adsorption of CoFe(2)O(4) nanoparticles while growing multilayers of CoFe(2)O(4)/PSS was conducted using colloidal suspensions with CoFe(2)O(4) concentration in the range of 10(-8) to 10(-6) (moles of cobalt ferrite per litre) and for different numbers of cycles n = 1, 3, 5, and 10. We found the adsorption of CoFe(2)O(4) nanoparticles within the CoFe(2)O(4)/PSS bilayers perfectly following a first order kinetic process, with the characteristic rate constant growing with the increase of CoFe(2)O(4) nanoparticle concentration and decreasing with the rise of the number of LbL cycles (n). Additionally, atomic force microscopy was employed for assessing the LbL film roughness and thickness. We found the film thickness increasing from about 20 to 120 nm while shifting from 3 to 10 CoFe(2)O(4)/PSS bilayers, using the 8.9 × 10(-6) (moles of cobalt ferrite per litre) suspension. 相似文献
9.
G.B. AlcantaraL.G. Paterno F.J. FonsecaP.C. Morais M.A.G. Soler 《Journal of magnetism and magnetic materials》2011,323(10):1372-1377
Novel magnetic nanocomposite films with controlled morphology were produced via the electrostatic layer-by-layer assembly of cationic CoFe2O4 nanoparticles and anionic poly(3,4-ethylenedioxy thiophene)/poly(styrene sulfonic acid) (PEDOT:PSS) complex. The electrostatic interaction between nanoparticle and the polyelectrolyte complex ensured a stepwise growth of the nanocomposite film with virtually identical amounts of materials being adsorbed at each deposition cycle as observed by UV-vis spectroscopy. AFM images acquired under the tapping mode revealed a globular morphology with dense and continuous layers of nanoparticles with voids being filled with polymeric material. 相似文献
10.
Camila de L. Ribeiro Jurandir R. de Souza Marcelo A. Pereira-da-Silva Leonardo G. Paterno 《Electroanalysis》2021,33(3):609-617
A novel nickel phthalocyanine/iron oxide nanoparticle (NiTsPc/ION) nanocomposite electrode is proposed for the voltammetric detection of ethinyl estradiol. The method shows a wide linear range (0.07–30 μmol L−1, R2 >0.99), sensitivity of 0.308 μA cm−2/μmol L−1 and limit of detection of 7.8 nmol L−1 (3.3 Sb/b). Recoveries are above 95 % for quantification in tap and treatment plant water samples and synthetic urine. A single electrode can be used in seven consecutive runs (RSD=2.85 %) and responses of different electrodes vary only 7–9 %. The excellent sensing performance of the proposed sensor is ascribed to its porous morphology and efficient charge-transfer between ION and NiTsPc. 相似文献