Redox behaviour of cysteine in the presence of ammonium trioxovanadate(V)

The interaction of ammonium trioxovanadate(V) with cysteine in aqueous solution was studied by cyclic voltammetry and absorption spectroscopy techniques. In the absence of cysteine, the cyclic voltammogram (CV) of ammonium trioxovanadate(V) solution in 0.1 M phosphate buffer (pH 7) gave two peaks at -0.130 V (reversible) and -0.400 V (irreversible). These peaks (-0.130 V, -0.400 V) can be attributed to V(V)/V(IV) and V(IV)/V(III) redox processes, respectively. In the presence of cysteine at low scan rate (40 mV/s), the peak at -0.780 V, which is assigned to the irreversible reduction of free cystine, was observed. In addition, the reduction peak of the disulfidic anion S(2)(2-) was seen at -0.650 V. Under aerobic conditions, the peaks of the disulfidic anion S(2)(2-) and free cystine are well separated. From electronic spectra of ammonium trioxovanadate(V) and cysteine mixtures, LMCT transition associated with V(V)-cyteine complex was obtained at 743 nm. The stoichiometry (ML(2)) and stability constant (log beta(1:2)=6.67) of V(V)-cysteine complex were determined by means of mole ratio method.     

Suzuki coupling reactions of 2,4,6-trialkoxyphenylboronic acids with enol triflates: asymmetric synthesis of a lactone template for calyxin assemblage

Suzuki coupling reactions between 2,4,6-trialkoxyphenylboronic acids and enol triflates have been found to occur in excellent yield, while the use of an enol tosylate failed to give any of the desired product. This coupling reaction has led to the synthesis of a lactone which could serve as a precursor to several calyxin analogues.     

Reference value standards for pH measurements in 10, 30, 50, and 70% (w/w) 2-propanol/water solvent mixtures at temperatures from 288.15 to 318.15 K

Reference value standards, pH (RVS), for 0.05 mol kg^?1 potassium hydrogenphthalate (KHPh) reference buffer solutions in 10, 30, 50 and 70% (w/w) 2-propanol/water solvent mixtures at temperatures from 288.15 to 318.15 K are determined from reversible e.m.f. measurements of the cell Pt¦H₂¦KHPh + KCl¦AgCl¦Ag¦Pt. The consistency of the present results is confirmed by multilinear regression analysis of the pH values obtained for each solution composition and temperature, allowing appropriate interpolation of pH (RVS) values within the range of the experiment. The ancillary values of the standard e.m.f. of the cell Pt¦H₂¦HCl¦AgCl¦Ag¦Pt are optimized through multilinear regression analysis of the available data in the literature, and the ancillary values of the first ionization constant of o-phthalic acid (H₂Ph; benzene-1,2-dicarboxylic acid) in these solvent mixtures are evaluated from reversible e.m.f. measurements of the cell Pt¦H₂¦H₂Ph + KHPh + KCl¦AgCl¦Ag¦Pt.     

Polyamide 6‐polycaprolactone multiblock copolymers: Synthesis,characterization, and degradation

This work describes the synthesis and characterization of polyamide 6 (PA 6)‐polycaprolactone (PCL) multiblock copolymers. Low molar mass, fully amine end‐capped PA 6 was prepared by the addition of a diamine monomer during ε‐caprolactam polymerization. A low molar mass PCL was selected to be incorporated as the biodegradable block and was fully end‐capped with toluene 2,4‐diisocyanate. End group analysis and molecular weight characterizations were performed for both end‐functionalized polymers by SEC, NMR and titration analysis. Incorporation of PCL into PA 6 was mainly achieved by solution mixing of the two end‐functional blocks and, was continued after the removal of the solvent with solid state polymerization (SSP) by gradual heating until about 40 °C below the melting temperature of the PA 6. Molecular weights started to grow immediately during solution mixing and only increased marginally during the SSP treatment. FTIR and SEC studies confirmed the reaction between the two components. DSC data, in combination with the enhanced molar mass during solution mixing pointed to a blocky microstructure, for which distinct melting and crystallization temperatures were observed for the PCL and the PA 6 blocks. Hydrolytic and enzymatic degradation studies were performed at 25 °C where the degree of degradation was followed by weight loss analysis, SEM and SEC. © 2011 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem, 2011     

Linear and Nonlinear Optical Properties in Spherical Quantum Dots

We calculate the energy eigenvalues and the sate functions of one-electron Quantum Dot （QD） by using a combination of Quantum Genetic Algorithm （QGA） and Hartre-Fock-Roothaan （HFR） method. The linear and the third-order nonlinear optical absorption coefficients for the 1s-1p, 1p-1d, and 1d-1f transitions are examined as a function of the incident photon energy for three different values of the stoichiometric ratio. The results show that the stoichiometric ratio, impurity, relaxation time, and dot size have great influence on the optical absorption coefficients of QDs.     

SERS-based sandwich immunoassay using antibody coated magnetic nanoparticles for Escherichia coli enumeration

A method combining immunomagnetic separation (IMS) and surface-enhanced Raman scattering (SERS) was developed to enumerate Escherichia coli (E. coli). Gold-coated magnetic spherical nanoparticles were prepared by immobilizing biotin-labeled anti-E. coli antibodies onto avidin-coated magnetic nanoparticles and used in the separation and concentration of the E. coli cells. Raman labels have been constructed using rod shaped gold nanoparticles coated with 5,5-dithiobis-(2-nitrobenzoic acid) (DTNB) and subsequently with a molecular recognizer. Then DTNB-labeled gold nanorods were interacted with gold-coated magnetic spherical nanoparticle-antibody-E. coli complex. The capture efficiency and calibration graphs were obtained and examined in different E. coli concentrations (10(1)-10(7) cfu mL(-1)). The correlation between the concentration of bacteria and SERS signal was found to be linear within the range of 10(1)-10(4) cfu mL(-1) (R(2) = 0.992). The limit of detection (LOD) and limit of quantification (LOQ) values of the developed method were found to be 8 and 24 cfu mL(-1), respectively. The selectivity of the developed immunoassay was examined with Enterobacter aerogenes, Enterobacter dissolvens, and Salmonella enteriditis which did not produce any significant response. The ability of the immunoassay to detect E. coli in real water samples was also investigated and the results were compared with the experimental results from plate-counting methods. There was no significant difference between the methods that were compared (p > 0.05). This method is rapid and sensitive to target organisms with a total analysis time of less than 70 min.     

Effect of residual copper on stability of molecular brushes prepared by atom transfer radical polymerization

Effect of residual copper on stability of molecular brushes with poly(n-butyl acrylate) (PBA) side chains was studied. The brushes were prepared by atom transfer radical polymerization (ATRP) using the grafting-from approach. Although the copper concentration was decreased down to below ten ppm levels by passing through alumina column, further removal was required to prevent crosslinking reactions. Further removal was performed by dialysis or precipitation.     

Gas chromatographic-mass spectrometric analysis of essential oils from Pimpinella aurea, Pimpinella corymbosa, Pimpinella peregrina and Pimpinella puberula gathered from Eastern and Southern Turkey

Essential oils from fruits, stems and leaves and roots of Pimpinella aurea DC., P. corymbosa Boiss., P. peregrina L. were analyzed by gas chromatography (GC) and gas chromatography-mass spectrometry (GC-MS) techniques. Fruits and aerial parts of P. puberula (DC.) Boiss were also evaluated. A total of 140 different compounds were identified, and significant qualitative and quantitative differences were observed among the samples. In fact, the main constituents of each species were different and only the oils extracted from roots shared the same principal compound, epoxy pseudoisoeugenyl-2-methyl butyrate (26.8-42.8%). The other fractions were dominated by different sesquiterpene compounds although in three of them, P. aurea stem and leaves, P. puberula fruits and P. puberula stems and leaves, monoterpene constituents also appear as main ones.     

WDS versus silicon drift detector EDS: a case report for the comparison of quantitative chemical analyses of natural silicate minerals

Electron probe microanalysis (EPMA) is an essential analytical approach to determine elemental concentrations of various solid specimens quantitatively in mineralogical, petrological and materials research. Either wavelength dispersive X-ray (WDS) or energy dispersive X-ray (EDS) spectrometric techniques can collect the characteristic X-rays generated from each element in the specimen by an incident electron beam in order to define chemical constituents. Although WDS has been the preferred technique because of its higher spectral resolution and ability to detect trace elements, new generation EDS systems with silicon drift detectors (SDD), equipped with thin windows and integrated digital processing electronics, are claimed to approach the WDS throughput. In this study, we compared the analytical capability of a SDD EDS system with respect to WDS equipped systems on natural silicate minerals. For this purpose, natural rock samples, in which the silicate minerals present had already been analysed by various WDS systems, were chosen to compare these results with the ones acquired with a SDD EDS system. SDD EDS yielded satisfactory results for major elements (Na, Mg, Al, Si, K, Ca, Ti, Mn and Fe) compared with the results of the same minerals obtained by various WDS systems.     

Dehydrophenylnitrenes: matrix isolation and photochemical rearrangements

The photochemistry of 3-iodo-2,4,5,6-tetrafluorophenyl azide 8 and 3,5-diiodo-2,4,6-trifluorophenyl azide 9 was studied by IR and EPR spectroscopy in cryogenic argon and neon matrices. Both compounds form the corresponding nitrenes as primary photoproducts in photostationary equilibria with their azirine and ketenimine isomers. In contrast to fluorinated phenylnitrenes, ring-opened products are obtained upon short-wavelength irradiation of the iodine-containing systems, indicative of C-I bond cleavage in the nitrenes or didehydroazepines under these conditions. Neither 3-dehydrophenylnitrene 6 nor 3,5-didehydrophenylnitrene 7 could be detected directly. The structures of the acyclic photoproducts were identified by extensive comparison with DFT calculated spectra. Mechanistic aspects of the rearrangements leading to the observed products and the electronic properties of the title intermediates are discussed on the basis of DFT as well as high-level ab initio calculations. The computations indicate strong through-bond coupling of the exocyclic orbital in the meta position with the singly occupied in-plane nitrene orbital in the monoradical nitrenes. In contrast to the ortho or para isomers, this interaction results in low-spin ground states for meta nitrene radicals and a weakening of the C1-C2 bond causing the kinetic instability of these species even under low-temperature conditions. 3,5-Didehydrophenylnitrenes, on the other hand, in which a strong C3-C5 interaction reduces coupling of the radical sites with the nitrene unit, might be accessible synthetic targets if the intermediate formation of labile monoradicals could be circumvented.