Highly meso-Diastereoselective Pinacol Coupling of Aromatic Aldehydes Mediated by Al Powder/Copper Sulfate in Water

Pinacol-type coupling reaction products presenting a high meso-diastereoselectivity (the ratio dl/meso was 4/96 up to 1/99) were obtained in fair to good yields (24–69%) using several aromatic aldehydes as starting materials and aluminium powder/copper sulfate as catalysts, in water, under reflux conditions.     

Characterization of Si-added aluminum oxide (AlSiO) films for power devices

Synthesis of Si-added aluminum oxide (AlSiO) films is attempted as an insulating film with both a wide bandgap and a high dielectric constant. Electrical characteristics of AlSiO films are investigated. Leakage current of the AlO film is suppressed by Si addition and is minimized with Si composition ratio of 12%. Capacitance versus voltage (C-V) measurements are carried out for Au/AlSiO/Si MIS structure. Both flat band shift and hysteresis of the C-V characteristics are suppressed by Si addition. A low leakage current is demonstrated for Au/AlSiO/n-SiC MIS structure.     

Emulsion Combustion and Flame Spray Synthesis of Zinc Oxide/Silica Particles

Two flame spray methods, emulsion combustion method (ECM) and flame spray pyrolysis (FSP), were compared for synthesis of pure and mixed SiO₂ and ZnO nanoparticles. The effect of silicon precursor was investigated using liquid hexamethyldisiloxane (HMDSO) or SiO₂ sol, while for ZnO zinc acetate (ZA) was used. Gas phase reaction took place when using HMDSO as Si precursor, forming nanoparticles, whereas the SiO₂ sol used as Si source was not evaporated in the flame, creating large aggregates of the sol particles (e.g. 1 m). The FSP of ZA produced ZnO homogeneous nanoparticles. Lower flame temperatures in ECM than in FSP resulted in mixed gas and liquid phase reaction, forming ZnO particles with inhomogeneous sizes. The FSP of HMDSO and ZA led to intimate gas-phase mixing of Zn and Si, suppressing each other's particle growth, forming nanoparticles of 19 nm in BET-equivalent average primary particle diameter. Nucleation of ZnO and SiO₂ occurred independently by ECM of HMDSO and ZA as well as by FSP of the SiO₂ sol and ZA, creating a ZnO and SiO₂ mixture. The reaction of ZnO with SiO₂ was likely to be enhanced by ECM of the SiO₂ sol and ZA where both Zn and Si species were not evaporated completely, resulting in ZnO, -willemite and Zn_1.7SiO₄ mixed phase.     

Self-assembled octameric cage constructed by the potassium salt of p-tert-butylcalix[6]arene p-bromophenylalanine derivative in the solid state

Potassium salts of p-tert-butylcalix[6]arene p-bromophenylalanine derivative formed sizable octameric cages in the solid state that were revealed by X-ray crystallographic analysis.     

Towards single biomolecule handling and characterization by MEMS

Applications of microelectromechanical systems (MEMS) technology are widespread in both industrial and research fields providing miniaturized smart tools. In this review, we focus on MEMS applications aiming at manipulations and characterization of biomaterials at the single molecule level. Four topics are discussed in detail to show the advantages and impact of MEMS tools for biomolecular manipulations. They include the microthermodevice for rapid temperature alternation in real-time microscopic observation, a microchannel with microelectrodes for isolating and immobilizing a DNA molecule, and microtweezers to manipulate a bundle of DNA molecules directly for analyzing its conductivity. The feasibilities of each device have been shown by conducting specific biological experiments. Therefore, the development of MEMS devices for single molecule analysis holds promise to overcome the disadvantages of the conventional technique for biological experiments and acts as a powerful strategy in molecular biology. Figure Towards single bio molecular handling and characterization by MEMS     

Quadruple Decker [3.3][3.3][3.3]Orthocyclophane Acetal—An Orthocyclophane Ladder

Through clever bridging of orthocyclophanes (in this case by acetalization), molecules such as 1 can be formed with four benzene rings in a stacked face-to-face arrangement. UV/Vis spectroscopic and electrochemical properties of 1 are governed by π–π through-space interactions within the molecule.     

Growth and properties of YAlO film synthesized by RF magnetron sputtering

YAlO films are synthesized on (1 0 0)-oriented Si substrates by RF magnetron sputtering method. Al₂O₃ wafer is used as a target material, and some small pieces of Y bulk material are put on the Al₂O₃ target to synthesize YAlO films. Y composition ratio is varied from 0 to 34%. Amorphous YAlO films are characterized. An electrical resistivity as high as 3.4 × 10¹⁴ Ω-cm is achieved for the YAlO film with Y composition ratio of 10%. The dielectric constant increases with increasing Y composition ratio, and the YAlO film with Y composition ratio of 34% has a dielectric constant of 10.2. The bandgap energy of the YAlO film is suggested to be wider than 6.5 eV. YAlO films with a surface roughness of 0.4-1.3 nm are obtained irrespective of the Y composition ratio.     

Oxidation of 7,8‐diaminotheophylline with lead tetraacetate and reaction of the oxidation product, 6‐cyanoimino‐5‐diazo‐1,3‐dimethylpyrimidine‐2,4‐dione with alcohols or amines

Oxidation of 7,8‐diaminotheophylline (1) with lead tetraacetate in refluxing toluene gave a mixture of 3‐amino‐5,7‐dimethylpyrimido[4,5‐e][1,2,4]triazine‐6,8‐dione ( 2 ) and 6‐cyanoimino‐5‐diazo‐1,3‐dimethylpyrimidine‐2,4‐dione ( 4 ). The latter was transformed to 2 by the reaction with 1‐propanethiol in quantitative yield. The reaction of 4 with methanol, ethanol and 1‐propanol in the presence of rhodium ( II ) acetate gave 5‐alkoxy‐6‐(2‐alkyl‐3‐isoureido)‐1,3‐dimethylpyrimidine‐2,4‐diones ( 7a‐c ). A similar reaction of 4 with alkylamines such as n‐propylamine, n‐butylamine, isobutylamine and n‐hexylamine gave a mixture of 7‐alkyl‐8‐aminotheophyllines ( 8a‐d ) and (5‐alkylamino‐1,3‐dimethyl‐2,4‐dioxopyrimidin‐6‐yl)cyanamides ( 9a‐d ).     

Identification of novel sesterterpenes by genome mining of phytopathogenic fungi Phoma and Colletotrichum sp.

Two homologous gene clusters for the biosynthesis of sesterterpenes betaestacins were identified from two phytopathogens, Phoma betae and Colletotrichum orbiculare. Heterologous expression of identified oxidation enzymes with previously-characterized PbTS1 (BtcA_Pb) resulted in the production of seven novel sesterterpenes. Although both strains possessed homologous enzymes, oxidation state of corresponding products were different from each other, suggesting that structural diversification of sesterterpene skeletons might be achieved by these homologous enzymes with different functions.     

First total synthesis of murisolin

The first and concise total synthesis of murisolin (1) was accomplished using asymmetric alkynylation and Sonogashira coupling as the key steps. The threo/trans/threo-type THF ring moiety was constructed with excellent stereoselectivity by asymmetric alkynylation of 1,6-heptadiyne to alpha-tetrahydrofuranic aldehyde, which was also prepared via the asymmetric alkynylation.