Effect of gold oxide in measurements of colloidal force

Atomic force microscopy, contact-angle, and spectroscopic ellipsometry measurements were employed to investigate the presence and properties of gold oxide on the surface of gold metal. It was found that, in agreement with available literature, unoxidized gold surfaces were hydrophobic, whereas oxidation rendered the surface highly hydrophilic. The oxide could be removed with ethanol or base but appeared to be stable over long periods in water or salt solutions between pH 3 and 7. After oxidation, the oxide layer thickness, determined using ellipsometry, was consistent with an approximate monolayer of Au-O bonds at the gold surface. The presence of gold oxide was found to alter significantly the electrical double-layer characteristics of the gold surface below pH 6 and may explain the apparent inconsistencies in observed force behavior where gold is employed as well as aiding in design of future microfluidic systems which incorporate gold as a coating.     

Copper and iron interactions with angiotensin-converting enzyme inhibitors. A study by fast-atom bombardment tandem mass spectrometry

Fast atom bombardment, combined with high-energy collision-induced tandem mass spectrometry, has been used to investigate gas-phase metal-ion interactions with captopril, enalaprilat and lisinopril, all angiotensin-converting enzyme inhibitors.Suggestions for the location of metal-binding sites are presented. For captopril, metal binding occurs most likely at both the sulphur and the nitrogen atom. For enalaprilat and lisinopril, binding preferably occurs at the amine nitrogen. Copyright 1999 John Wiley & Sons, Ltd.     

Determination of loads applied perpendicularly to the outer boundary of a ring using coefficients of influence

A procedure is explained to determined the amount of several pairs of diametrical loads applied to the outside boundary of a ring when stresses at selected points of the inside or outside boundaries are known. Coefficients of influence are used, following an approach similar to the one presented in a previous paper. Examples of application are given and the possible increase in precision is shown when the number of points of measurements is larger than the number of loads to be determined.