Excellent UV-absorbing cotton fabric with high durability and hydrophobicity based on surface-initiated ATRP of polymerizable organic UV-absorber

Cellulose - Ultraviolet (UV) protective cotton fabric is a convenient and reliable way to protect human body from sunlight. Herein, a polymerizable UV-absorber,...     

Microwave absorption properties of composite powders with low density

The composites of barium ferrite coated on hollow ceramic microspheres were prepared using sol-gel technique. The crystal structure, morphology and microwave absorption properties of composite powders with different weight ratio of microspheres were studied with XRD, EDS, FESEM and vector network analyzer. The results show that the microwave absorption properties of composite powders are greatly improved. The maximum microwave loss of composite powders reaches 31 dB with an amount of 50 wt.% microspheres, and its density is only about 1.80 g/cm³. The effect of hollow ceramic microspheres on the microwave absorption property is also discussed.     

Preparation and microwave absorption properties of electroless Co-Ni-P coated strontium ferrite powder

A new type of Co-Ni-P coated strontium ferrite nanocomposite was prepared with electroless plating enhanced by ultrasonic wave at room temperature. The plating process was studied carefully. The morphology, crystal structure and microwave absorption properties of the Co-Ni-P coated powder were studied with field emission scanning electron microscopy (FE-SEM), X-ray diffraction (XRD), energy dispersive analysis of X-rays (EDX) and vector network analyzer. The results show that the strontium ferrite powder was successfully coated with Co-Ni-P alloy and possesses excellent microwave absorption properties. The maximum microwave loss of the composite powder reaches −44.12 dB. The bandwidth with the loss above −10 dB exceeds 13.8 GHz.     

可用于激光核聚变的闪烁中子探测器

在当前激光核聚变实验中,中子集中在短时间内出现、且产额低。为适应这种特点,要求探测器的效率高,分辨时间短。利用闪烁中子探测器探测激光核聚变所产生的中子,能测定中子产额,记录中子能量,而且探测效率高,分辨时间短。缺点是易受γ射线、X射线的干扰。     

CuZnAl水滑石衍生催化剂上甲醇水蒸气重整制氢Ⅲ.合成水滑石用金属盐的影响

采用共沉淀法,用不同金属盐为Cu源和Zn源合成了一系列CuZnAl水滑石,以此为前体经600℃焙烧后制得相应催化剂.用硝酸盐和醋酸盐合成的水滑石结晶度高,其衍生催化剂比表面积大、Cu的分散性好且易于还原;而用硫酸盐和盐酸盐合成的水滑石结晶度差,其衍生催化剂比表面积小、Cu的分散性差且不易还原.反应评价结果显示,用硝酸盐和醋酸盐制得的催化剂活性高、反应稳定性好;而用硫酸盐和盐酸盐制得的催化剂由于低的Cu表面积以及S和Cl的毒化作用而几乎无催化活性.在醋酸盐制备的催化剂上,产物干气中CO的浓度明显较低,在250℃和WHSV=3.28 h-1的条件下约为0.03%~0.04%,仅为硝酸盐所制催化剂上CO浓度的1/5;在210℃和WHSV=0.5 h-1的条件下,该催化剂上甲醇几乎完全转化,同时CO浓度降至约0.005%.N2O滴定、CO2程序升温脱附和程序升温还原结果显示,用醋酸盐和硝酸盐制备的催化剂具有极相近的Cu表面积和表面碱性,但前者CuO的还原峰温较后者低近70℃,归因于ZnO与CuO间的强相互作用,这是催化剂具有良好选择性的可能原因.     

Direct synthesis, characterization of Cu-SBA-15 and its high catalytic activity in hydroxylation of phenol by H2O2

Transition metal copper substituted mesoporous silica (Cu-SBA-15) was synthesized using triblock copolymers surfactant as template agent under acidic condition. The result Cu-SBA-15 was characterized with XRD, ICP-AES, FT-IR and N₂ adsorption–desorption measurements, which prove that Cu(II) was mainly incorporated into the framework of Cu-SBA-15. Its catalytic activity was studied for phenol hydroxylation using H₂O₂ (30%). The substituting element (Cu²⁺) is incorporated into the framework position forming a new type of active site which raises the phenol conversion to 62.4% and the diphenol (the mixture of catechol (CAT) and hydroquinone (HQ)) selectivity to 97%. The Cu-SBA-15 has very high selectivity for catechol (about 71% selectivity), which is completely different from that of the microporous titanium silicalite zeolites (47.1% phenol conversion and about 50% selectivity to CAT under same reaction conditions). The results obtained indicate that the selective oxidation of phenol with H₂O₂ by a radical substitution mechanism.     

离子液体体系中1－丁烯二聚反应的研究

 研究了在强酸性AlCl3／Et2AlCl／［BMIM］Cl型离子液体体系中过渡金属化合物对1－丁烯二聚反应的催化作用．结果表明，［BMIM］Cl对强酸性AlCl3／Et2AlCl催化剂催化1－丁烯高聚反应有明显的阻聚作用，并显著提高了1－丁烯二聚的选择性．在过渡金属化合物中，含镍化合物对1－丁烯二聚反应有最好的催化效果．在最佳反应条件下，1－丁烯的转化率可达95．1％，二聚产物C8烯的选择性为85．8％．同时，对1－丁烯二聚反应的机理进行了初步探讨．     

含硫液体烃燃料水蒸气重整制氢I．Pt／Ce0．8Gd0．2O1．9催化剂的制备、表征和抗硫性能

以柠檬酸溶胶-凝胶法合成的具有萤石结构的Ce0.8Gd0.2O1.9（CGO）复合氧化物为载体，用初湿浸润法制备了负载型Pt催化剂．纯异辛烷的重整反应结果显示，600和800℃焙烧的催化剂达到了热力学平衡转化，1000℃焙烧会导致Pt的聚集和氧化物的严重烧结，因而催化剂活性较差．抗硫测试表明，800℃焙烧的催化剂抗硫性能最好，在300μg／g硫存在下，100h内异辛烷均接近完全转化；在500μg／g硫存在下催化剂仍表现出良好抗硫性能．程序升温还原和X射线分析结果显示．800℃焙烧时Pt与CGO载体间的相互作用最强，同时催化剂具有良好的热稳定性，这是催化剂具有抗硫性能并且抗硫作用持久的根本原因．反应条件下噻吩硫完全转化成H2S，硫的转化可能是通过氧化-还原机理进行的．     

Influence of demulsifiers of different structures on interfacial dilational properties of an oil-water interface containing surface-active fractions from crude oil

The influences of two commercial demulsifiers that have a straight chain and branch chain, respectively, on the dilational viscoelasticity of an oil-water interfacial film containing surface-active fractions from crude oil were investigated. The branch-chain demulsifier AE-121 could efficiently substitute surface-active fractions of different average molecular weights from the oil-water interface, while straight-chain SP-169 could only efficiently substitute those of large average molecular weight. It was apt to form a mix-adsorption layer with surface-active fractions of small average molecular weight. The results showed that the molecular size (or represented by average molecular weights) of the surface-active fractions was an important factor influencing the reciprocity of demulsifiers and surface-active fractions at the oil-water interface. This effect could be well explained by the difference between sizes of surface-active fraction molecules and vacancies between demulsifier molecules at the interface. The results of SDBS also proved this explanation.     

Amides and Heparin‐Like Polymer Co‐Functionalized Graphene Oxide Based Core @ Polyethersulfone Based Shell Beads for Bilirubin Adsorption

Excessive bilirubin in the body of patient with liver dysfunction or metabolic obstruction may cause jaundice with irreversible brain damage, and new type of adsorbent for bilirubin is under frequent investigation. Herein, graphene oxide based core @ polyethersulfone‐based shell beads are fabricated by phase inversion method, amides and heparin‐like polymer are introduced to functionalize the core‐shell beads. The beads are successfully prepared with obvious core‐shell structure, adequate thermostability and porous shell. Clotting times and protein adsorption are investigated to inspect the hemocompatibility property of the beads. The adsorption of bilirubin is systematically investigated by evaluating the effects of contacting time, initial concentration and temperature on the adsorption, which exhibits improved bilirubin adsorption amount for the beads with amides contained cores or/and shells. It is worth believing that the amides and heparin‐like polymer co‐functionalized core‐shell beads may be utilized in the field of hemoperfusion for bilirubin adsorption.