Determination of biologically active substances in roasted coffees using a diode-array HPLC system.

We studied the simultaneous quantitative analysis of biologically active substances, such as nicotinic acid, trigonelline, caffeine, qunolinic acid and tannic acid and pyrogallic acid, in several roasted coffees by an HPLC/diode-array system with a home-made sol-gel and ODS-2 columns. A simple method for simultaneous quantitative analysis of biologically active substances in the coffee brew became feasible by an HPLC/diode-array system with a sol-gel column at a single wavelength of 210 nm. The most efficient condition of the Rs value was above 1.05 when two sol-gel columns were connected. In addition, the elution behavior of nicotinic acid in brew extracted from commercially available coffee beans suggests the thermal decomposition process during roasting, and indicated the maximum value for full city roasted coffee.     

Synthesis and properties of tricyclo[6.4.1.0]trideca-1,3(6),7,9,11-pentaene

A new cyclobutene-fused 1,6-methano[10]annulene was synthesized by pyrolysis of the sulfone and sulfinate adducts of 3,4-bis(methylene)-1,6-methano[10]annulene and its physical and chemical properties were disclosed.     

Many-body calculation of the electric field gradient in the hydrogen molecule

The electric field gradient in the hydrogen molecule has been calculated by diagrammatic many-body perturbation theory (MBPT ) in Gaussian basis sets. The procedure through third order in electron correlation gives a value for the field gradient of 0.34041 a.u., which is 0.8% greater than the accurate value. The result is discussed in terms of the completeness of the basis sets and the convergence of the perturbation expansion.     

Study on the structures of 2-substituted iminothiazolidine derivatives

The reaction of 2-bromoethylamine 1 with methylisothiocyanate 2 under mild condition gave 2-methyl-amino-2-thiazoline 3 as the major product together with two kinds of byproducts, 3-(N-methylthiocar-bamoyl)-2-methyliminothiazolidine 4 and N,N′-dimethyl-N-(2-thiazolin-2-yl)thiourea 5. Thermal isomer-ization of 5 to 4 was observed. The structures of the byproducts were confirmed by X-ray crystallography.     

Optimal control of ultrafast cis-trans photoisomerization of retinal in rhodopsin via a conical intersection

Optimal control simulation is applied to the cis-trans photoisomerization of retinal in rhodopsin within a two-dimensional, two-electronic-state model with a conical intersection [S. Hahn and G. Stock, J. Phys. Chem. B 104, 1146 (2000)]. For this case study, we investigate coherent control mechanisms, in which laser pulses work cooperatively with a conical intersection that acts as a "wave-packet cannon." Optimally designed pulses largely consist of shaping subpulses that prepare a wave packet, which is localized along a reaction coordinate and has little energy in the coupling mode, through multiple electronic transitions. This shaping process is shown to be essential for achieving a high target yield although the envelopes of the calculated pulses depend on the local topography of the potential-energy surfaces around the conical intersection and the choice of target. The control mechanisms are analyzed by considering the motion of reduced wave packets in a nuclear configuration space as well as by snapshots of probability current-density maps.     

Phase Separation in Sol-Gel System Containing Mixture of 3- and 4-Functional Alkoxysilanes

The phase separation behavior of gelling systems containing the mixture of 3-functional and 4-functional alkoxysilanes has been investigated. The relation between the starting composition and resultant macroporous morphology was examined using tetramethoxysilane (TMOS) and vinyltrimethoxysilane (VTMS) as starting alkoxysilanes, formamide (FA) as an additive, under an acidic condition. Up to TMOS:VTMS molar ratio of 0.5:0.5, the phase relation remained almost unchanged from that of pure TMOS system which exhibits morphology with well-defined co-continuous macropores in a very limited concentration region. On the VTMS-rich side typically TMOS:VTMS = 0.2:0.8, however, the co-continuous macroporous morphology was obtained in a broader composition range than those of either pure TMOS or VTMS system. A dome-like pseudo binary region was obtained with the two-phase region extending toward FA-rich direction. The domain size and pore volume of the gels with macroporous morphology could be controlled by alkoxide:water ratio and total solvent fraction, respectively.     

Application of the microwave acid digestion method to the decomposition of rock samples

The microwave acid digestion method was applied to the decomposition of rock samples and optimum conditions were investigated. Samples of 10–100 mg were decomposed by changing the amount and composition of acid, heating time and number of reheating steps and then the concentrations of Si, Fe, Mn, Na, K and Mg in these samples were measured. The concentrations agreed with reported values when 10 mg of sample were decomposed by heating for 60 s with 0.3 ml of concentrated HNO₃ and 0.1 ml of concentrated HF. Similarly, 100 mg of sample were also decomposed successfully by heating for 45–110 s with 0.3–1.0 ml of concentrated HNO₃ and 0.4–0.7 ml of concentrated HF. It is concluded that the microwave acid digestion method decomposes rock samples with a very short heating time and with small amount of reagents compared with methods using conventional sealed PTFE vessels, which require several hours for the heating step and several millilitres of reagents.     

Synthesis of a novel bridged nucleoside bearing a fused-azetidine ring, 3′-amino-3′,4′-BNA monomer

A novel bridged nucleic acid monomer, 3′-amino-3′-deoxy-5-methyl-3′-N,4′-C-methyleneuridine, was successfully synthesized via a useful and convenient azetidine ring formation under Staudinger's conditions. A ¹H NMR experiment and a PM3 calculation revealed that the sugar moiety of the novel bridged nucleic acid monomer, 3′-amino-3′,4′-BNA, was restricted to S-type conformation.     

Stabilities in field electron emissions from noble‐metal covered W nano‐tips: apex structure dependence

We observed field emission microscopy (FEM) patterns of noble‐metal (NM) covered W nano‐tips with three different apex structures fabricated by field evaporation. Each of the three tips was terminated with a single atom, three atoms or ten atoms. We investigated the temporal changes in the FEM of these tips to discuss the stabilities in the spatial distributions of the field emission (FE) beams. The single‐atom tip showed two characteristics that were superior to the others. First, the beams emitted from the single‐atom tip were the most collimated among the three tips (the semi‐cone angle of 1.0° , FWHM). Second, adsorption of residual gas had little influence on FE from the single‐atom tip, while the other tips were easily contaminated even at ultra high vacuum, resulting in the emission fluctuation. Copyright © 2006 John Wiley & Sons, Ltd.     

Fluorescent Molecular Recognition and Sensing System of Bis-Dansyl Modified γ-Cyclodextrins

Flexible hosts, 6A,6B-; 6A,6C-; 6A,6D-; and 6A,6E-bis dansylglycine-modified -cyclodextrins (-1, -2, -3, and -4, respectively) have been synthesized as a sensing molecule for organic guests including terpenoids and bile acids. These host compounds show a pure monomer fluorescence whose intensity is decreased or enhanced upon addition of guest species. The value I/I₀, where I and I₀ are fluorescence intensities in the presence and absence of a guest and I is I₀- I, was used as a parameter of sensitivity. These hosts exhibit highly sensitive and selective molecular recognition ability, particularly, for lithochoic acid, chenodeoxycholic acid, and ursodeoxycholic acid. The behaviors of the appended moieties of these hosts when host–guest complexation occurs are studied by induced circular dichroism (ICD) spectra and fluorescence spectral change on accommodation of a guest. The ICD pattern of these hosts alone or on accommodation of a guest is very similar, indicating that the behavior of the appended moieties are very similar. The guest-induced variations in the fluorescence or ICD intensity suggest that the appended moieties act as a hydrophobic cap that enables the cyclodextrin to form 1 : 1 host–guest complexes.