Mechanism of BPh3-Catalyzed N-Methylation of Amines with CO2 and Phenylsilane: Cooperative Activation of Hydrosilane

BPh₃ catalyzes the N-methylation of secondary amines and the C-methylenation (methylene-bridge formation between aromatic rings) of N,N-dimethylanilines or 1-methylindoles in the presence of CO₂ and PhSiH₃; these reactions proceed at 30–40 °C under solvent-free conditions. In contrast, B(C₆F₅)₃ shows little or no activity. ¹¹B NMR spectra suggested the generation of [HBPh₃]⁻. The detailed mechanism of the BPh₃-catalyzed N-methylation of N-methylaniline ( 1 ) with CO₂ and PhSiH₃ was studied by using DFT calculations. BPh₃ promotes the conversion of two substrates (N-methylaniline and CO₂) into a zwitterionic carbamate to give three-component species [Ph(Me)(H)N⁺CO₂⁻⋅⋅⋅BPh₃]. The carbamate and BPh₃ act as the nucleophile and Lewis acid, respectively, for the activation of PhSiH₃ to generate [HBPh₃]⁻, which is used to produce key CO₂-derived species, such as silyl formate and bis(silyl)acetal, essential for the N-methylation of 1 . DFT calculations also suggested other mechanisms involving water for the generation of [HBPh₃]⁻ species.     

Roles of SiH4 and SiF4 in growth and structural changes of poly-Si films

The structural properties of polycrystalline silicon films, prepared by plasma enhanced chemical vapor deposition system, with different flow rates of SiH₄/SiF₄ mixtures at 300 °C were investigated. This study indicates that the low hydrogen coverage on the growing surface, under optimum fluorine radicals, will be leaded to an improvement of crystallized area as compared with case of high hydrogen coverage surface. Moreover, the studies of the role of SiH₄ and SiF₄ radicals show that the SiH₄ radicals are important in the nucleation and growth of grains. However, SiF₄ radicals are effective in the structural change of grain boundaries regions and by this way, in the present system, establish the growth of grains under the dominant 〈1 1 0〉 direction. The stress investigation indicates that addition of high flow rate of SiF₄ in amorphous film, results in the nearly stress free films. Finally, we found that the changes in g-value reflect the changes in the intrinsic compressive and tensile stress in the both polycrystalline and amorphous silicon films.     

Classification for dimethylarsenate-decomposing bacteria using a restrict fragment length polymorphism analysis of 16S rRNA genes.

A new monitoring system for bacterial communities involving dimethylarsinic acid (DMAA) decomposition was provided by combining the MPN (Most Probable Number) method and RFLP (restriction-fragment-length polymorphism analysis). The abundance of DMAA decomposing bacteria was estimated by the MPN method using a bacterial culture medium, which included DMAA as the sole carbon source, indicating bacterial cell densities of 1700 cells/ml in Lake Kahokugata and 330 cells/ml in Lake Kibagata. After isolating the dominant bacteria using agar plates, the isolates were classified into some genotype groups by RFLP analysis using 16S rDNA sequences. Classification of the RFLP analysis indicated that 14 isolates of Lake Kahokugata were classified into 6 types, which included 2 dominant types related to genus Pseudomonas, while 8 isolates of Lake Kibagata displayed 6 types including one or two isolates. Moreover, the RFLP types were unique for each lake, suggesting that DMAA decomposing bacteria were specific for the aquatic environment related to the arsenic cycle. The activities of DMAA decomposition mostly matched with the RFLP type category of the isolates. Accordingly, combining the MPN method with the RFLP analysis will play an important role in elucidating the distributions and dynamics of the DMAA-decomposing bacterial community.     

Effect of core-shell micelle formation on the redox properties of phenothiazine-labeled poly(ethyl glycidy ether)-block-poly(ethylene oxide)

Redox properties of phenothiazine-labeled poly(ethyl glycidy ether)-block-poly(ethylene oxide) (PT-EGE_n-b-EO_m) are reversibly changed by core-shell micelle formation. In the temperature range higher than the critical micellization temperature (cmt), the anodic potential of PT group positively shifts and concomitantly its anodic current decrease, or levels off compared to those of the reference polymer PT-EO_m without the thermo-responsive EGE_n segment. The former alteration is caused by incorporation of hydrophobic PT groups into a core of the micelle and the latter by the decrease in the diffusion coefficient of PT groups due to formation of the core-shell micelles. The cmt value and the temperature-dependent alteration in the redox properties strongly depend on the polymer structure, especially the length of thermo-responsive EGE_n segment. The electrochemically determined hydrodynamic radii of the polymer aggregates seem to be overestimated, compared to the values reported for the aggregates of other thermo-responsive polymers with similar molecular weights, implying the presence of electrochemically inactive PT groups in the copolymers having longer thermo-responsive segments.     

High-throughput characterization of local conductivity of Nd0.9Ca0.1Ba2Cu3O7−δ thin film by the low-temperature scanning microwave microscope

We developed a scanning microwave microscope (SμM) designed for high-throughput electric-property screening as well as for rapid construction of electronic phase diagrams at low temperatures. As a sensor probe, we used a high-Qλ/4 coaxial cavity resonator to which a thin needle with ball-tip end was attached. The sensor module was mounted on the low-temperature XYZ stage, which allowed us to map out the change of resonance frequency and quality factor due to the local tip-sample interaction at low temperatures. From the measurements of combinatorial thin films, such as Ti_1−xCo_xO_2−δ and Nd_0.9Ca_0.1Ba₂Cu₃O_7−δ (NCBCO), it was demonstrated that this SμM system has enough performance for the high-throughput characterization of sample conductance under variable temperature conditions.     

Nitroxide‐mediated radical polymerization in miniemulsion: Bimolecular termination in monomer‐free model systems

Bimolecular termination in nitroxide‐mediated radical polymerization in miniemulsion has been investigated through the heating of a polystyrene–2,2,6,6‐tetramethylpiperidinyl‐1‐oxy macroinitiator and its 4‐hydroxy‐2,2,6,6‐tetramethylpiperidinyl‐1‐oxy analogue in an aqueous toluene dispersion with sodium dodecyl benzenesulfonate as a surfactant at 125 °C. The level of bimolecular termination by combination, evaluated from the high‐molecular‐weight shoulder, was higher in miniemulsion than in solution and increased with decreasing particle size. Quantitative analysis revealed that these results cannot be rationalized solely by nitroxide partitioning to the aqueous phase. The results are explained by an interface effect, by which nitroxide is adsorbed or located at the aqueous–organic interface. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 4995–5004, 2007     

Collection of iron(III) from homogeneous aqueous solutions on membrane filters using Chromazurol B with Triton X-100.

A membrane filtration method was examined concerning the effective collection of iron(III) from a homogeneous aqueous solution with Chromazurol B (CAB), one of the triphenylmethane dyes, as a precipitating reagent in the presence of a non-ionic surfactant, polyethylene glycol mono[4-(1,1,3,3-tetramethylbutyl)phenyl]ether (Triton X-100). A formed blue Fe(III)-CAB complex was collected as a precipitate on a membrane filter by filtration under suction from a homogeneous aqueous solution in the pH range over about 2. The original solution was prepared at a concentration ratio of CAB to Fe(III) of to 10, and that of Triton X-100 to CAB of 10 to 100. It was then adjusted to a pH value of between 1.0 and 6.5. A linear relationship (r = 0.999) was obtained between the initial concentration and the found one of Fe(III) in the range of 2.0 x 10(-5) to 4.0 x 10(-4) mol dm(-3) at a fixed concentration ratio of CAB to Fe(III) of 3 and that of Triton X-100 to CAB of 20. This membrane filtration with CAB and Triton X-100 may be utilized for the separation of Fe(III) as a background species.     

An experiment to measure collisionless radial transport ofenergetic electrons confined by a dipole magnetic field

A new laboratory terrella has been constructed in order to study collisionless radial diffusion of particles trapped within a dipole magnetic field. Columbia's collisionless terrella experiment (CTX) aims to reproduce the process of wave-induced radial transport and does not try to simulate magnetospheric structure. The first experiment planned for CTX is the direct measurement of stochastic radial diffusion induced from wave-particle drift resonances. The motivation for the CTX experiment is described, and the procedures to be used to measure the intensity and spectrum of fluctuations generating chaos, the rate of radial transport, and the evolution of the density and pressure profiles are illustrated. Because of the success of similar experiments conducted earlier in a long thin magnetic mirror, these dipole experiments can be performed with a high degree of confidence. An example from these earlier experiments is presented     

Mu spin exchange in polarized media

A study has been made of highly nitrogenated pure iron and iron-aluminum alloy powder containing 2 wt.% Al (Fe-2Al) using Mössbauer spectroscopy and X-ray diffraction. The samples were prepared by high-temperature, high-pressure diffusion of nitrogen. They were prepared in a hot-isostatic-pressure (HIP) furnace at 1000 °C at nitrogen pressures up to 200 MPa. The alloy powders contained up to 8 at.% nitrogen as determined by vacuum fusion analysis. XRD analysis indicates that for the pure iron powders, the lattice spacing remained independent of nitrogen concentration, but that for the Fe-2Al powders, it decreased with increasing nitrogen concentration. Mössbauer analysis showed that for the pure iron powders, most of the nitrogen was associated with the formation of the iron nitride Fe₄N. For the alloy powders containing less than 5 at.% nitrogen, all of the nitrogen was contained interstitially. The presence of nitrogen completely eliminated the conduction-electron spin-density oscillations observed in many ferromagnetic alloys.     

Polybenzimidazoles containing anthracene photodimer

Polybenzimidazoles that contained anthracene photodimer were prepared. The molecular weights of the polymers prepared by the photopolymerization of bis-anthrylbenzimidazoles were limited by the precipitation of the resulting polymers from the reaction organic solvents. Higher molecular weight polymers were obtained by the photopolymerization of bis-anthryl-Schiff's bases, followed by the oxidation of the resulting polymers. These polymers were soluble in acidic solvents such as formic and sulfuric acids but were insoluble in organic solvents.