Tumor cell detection method using complement-mediated cytolytic reaction and imaging sensor system

A novel tumor-detection system consisting of complementmediated cytolytic reaction and an image processing system was developed for the simple and rapid determination of tumor cells. The present system consists of a CCD image sensor, image memory board, personal computer, and microscope. When monoclonal antibody 3C4, which is specific to the guinea pig hepatoma L-10, was added to cell suspension, only L-10 cytolysis occurred. Cytolysis caused a decrease in brightness of the cells observed by phase-contrast microscopy. The phase contrast image of the cells before cytolysis was converted to a digitalized signal and stored in computer memory. After cytolysis, a brightness threshold above that of lysed cells was subtracted from the digitalized signal and compared to the signal stored before reaction. L-10 cells in mixed cell suspension were determined specifically by the system. Measurement time was only 2 sec and overall time, including reaction time, was approximately 30 min. Since this method does not require a cell washing process, automation of the whole system is possible.     

Enhanced indoor radon concentration by using radon-rich well water in a Japanese wooden house in Fukuoka, Japan

Summary Radon measurements were carried out in a Japanese wooden house built on granitic geology, where radon-rich well water is used. Atmospheric radon concentrations were measured over one year with passive integrated radon monitors. The monitors were distributed at several locations in the house and were replaced every two months. In order to confirm the diurnal variation and heterogeneous distribution of radon, short-term measurements were carried out accordingly. Radon, its decay products and terrestrial gamma-radiations were measured in this survey. From the long-term measurement, the radon concentration in the house ranged from 14 to 184 Bq^. m^-3with an arithmetic mean of 45 Bq^. m^-3. A radon concentration of 184 Bq^. m^-3was observed in the bathroom in spring (March-May) though the radon level was normal in the living room and bedroom. In order to characterize the house, similar measurements were conducted in several surrounding houses. There was a significant difference in radon concentration between the investigated houses. There was a spatial distribution of the radon concentration and the highest value was found in the bathroom. Radon and its decay products concentrations varied with time, which increased from midnight to morning whereas they decreased during daytime. Although the radon concentration in tap water was 1 Bq^. l^-1, a high level of 353 Bq^. l^-1was found in the well water.While well water was being used, the indoor radon concentration near the bathroom increased rapidly with a maximum value of 964 Bq^. m^-3. It is clear that the use of well water enhanced the radon level around the bathroom.     

Donor–acceptor–acceptor-type near-infrared fluorophores that contain dithienophosphole oxide and boryl groups: effect of the boryl group on the nonradiative decay

The use of donor–π–acceptor (D–π–A) skeletons is an effective strategy for the design of fluorophores with red-shifted emission. In particular, the use of amino and boryl moieties as the electron-donating and -accepting groups, respectively, can produce dyes that exhibit high fluorescence and solvatochromism. Herein, we introduce a dithienophosphole P-oxide scaffold as an acceptor–spacer to produce a boryl- and amino-substituted donor–acceptor–acceptor (D–A–A) π-system. The thus obtained fluorophores exhibit emission in the near-infrared (NIR) region, while maintaining high fluorescence quantum yields even in polar solvents (e.g. λ_em = 704 nm and Φ_F = 0.69 in CH₃CN). A comparison of these compounds with their formyl- or cyano-substituted counterparts demonstrated the importance of the boryl group for generating intense emission. The differences among these electron-accepting substituents were examined in detail using theoretical calculations, which revealed the crucial role of the boryl group in lowering the nonradiative decay rate constant by decreasing the non-adiabatic coupling in the internal conversion process. The D–A–A framework was further fine-tuned to improve the photostability. One of these D–A–A dyes was successfully used in bioimaging to visualize the blood vessels of Japanese medaka larvae and mouse brain.

Combination of electron-accepting diarylboryl terminal groups and dithienophosphole oxide spacers with electron-donating triarylamine moieties produces donor–acceptor–acceptor type π-systems, which exhibit emissions in the near-infrared region.     

Development of a method for estimating an accurate equivalence point in nickel titration of cyanide ions

In a nickel titration of cyanide ions using murexide as indicator, an accurate equivalence point was determined by a non-linear least-squares curve-fitting for a titration curve. This method was developed to establish a standard solution for cyanide ions. In a curve-fitting procedure, a theoretical titration curve was calculated, assuming that nickel ion formed only a 1:4 Ni²⁺:CN⁻ complex with cyanide ions and formed only a 1:1 complex with murexide. Results of the curve-fitting were reasonable at any pH and any indicator concentration studied. The combined standard uncertainty for a concentration of a 1000 mg kg⁻¹ cyanide solution by this method was 0.079%.     

Syntheses and reactions of functional polymers. XLII. Preparation and use of polymers having N-hydroxy-succinimide unit in the chain

Styrene-maleic anhydride alternating copolymer was converted to N-hydroxymaleimide-styrene copolymer by reaction with hydroxylamine in pyridine at room temperature. The conversion was more than 90%. From this copolymer, N-acetoxy- or N-benzoyloxymaleimide-styrene copolymers were derived by action of acetic anhydride or benzoyl chloride in dimethylformamide at room temperature. Acylation of several primary amines was carried out effectively by use of these N-acyloxyimide-styrene copolymers. The reaction of the acetylated copolymer with diethylamine at room temperature afforded N-hydroxyimide copolymer.     

Vinyl Polymerization. 436. Effect of Magnetic Field on Uncatalyzed Polymerization

The radical polymerization of vinyl monomers initiated with several kinds of hydrophilic macromolecule was carried out in a magnetic field. The magnetic field promoted the polymerization; the conversion of monomers and the molecular weight of the polymers obtained increased with increasing field strength in the range of 0–0.1 T. The dependence of the composition and tacticity of the mother polymer on the magnitude of the magnetic field was studied. Using graft or block copolymers, which consisted of hard and soft segments, the effect of a magnetic field was further investigated. The degree of hardness and tightness of the hydrophobic areas (reaction areas) formed by the mother polymer in the aqueous solution was found to affect the magnetic field effect on the uncatalyzed polymerization. The overall activation energy obtained in the magnetic field was almost equal to that obtained without a magnetic field.     

Investigation of radon and thoron concentrations in a landmark skyscraper in Tokyo

The temporal variation of the radon concentration, and the radon and thoron concentrations every 3 months for a year were measured using two types of devices in a landmark skyscraper, the Tokyo Metropolitan Government Daiichi Building. In the measurement of temporal variation of the radon concentration using a pulse type ionization chamber, the average radon concentration was 21 ± 13 Bq m^?3 (2–68 Bq m^?3). The measured indoor radon concentration had a strong relationship with the operation of the mechanical ventilation system and the activities of the office workers. The radon concentration also increased together with temperature. Other environmental parameters, such as air pressure and relative humidity, were not related to the radon concentration. In the long-term measurements using a passive radon and thoron discriminative monitor, no seasonal variation was observed. The annual average concentrations of radon and thoron were 16 ± 8 and 16 ± 7 Bq m^?3, respectively. There was also no relationship between the two concentrations. The annual average effective dose for office workers in this skyscraper was estimated to be 0.08 mSv y^?1 for 2000 working hours per year. When considering the indoor radon exposure received from their residential dwellings using the annual mean radon concentration indoors in Japan (15.5 Bq m^?3), the annual average effective dose was estimated to be 0.37 mSv y^?1. This value was 31 % of the worldwide average annual effective dose.     

Enhanced collective optical response of vast numbers of silver nanoparticles assembled on a microbead

We investigated the optical response of a huge number of silver nanoparticles (AgNPs) densely assembled on an organic microsphere, i.e., AgNP-fixed bead, under the collective phenomena of localized surface plasmons. For this purpose, various optical properties of such a AgNP-fixed bead were analyzed in aqueous solution by dark-field optical microscopy and laser Raman microscopy. In particular, in comparison with the optical spectrum of single AgNPs, significant spectral broadening and redshift were observed due to plasmonic superradiance with decreasing interparticle distance to the subnanoscale when using small binder molecules in the AgNP-fixed bead. Furthermore, we observed surface-enhanced Raman scattering and clarified the sensitivity of the signal intensity to the size of the binder molecules between the AgNPs, which can be explained based on optical response theory using a discrete integral with spherical cells. These results and discussion provide a guiding principle for broadband plasmonic light absorbers and for highly sensitive detection of small molecules and nanoscale biomaterials based on vast numbers of nanogaps produced by a bottom-up self-assembly process.     

Proper composition for superconductivity in Pb(Ba, Sr)2(Y, Ca)Cu3O7

Superconductivity and composition analysis of PbBaSr(Y, Ca)Cu₃O_y with fixed ratio of Sr/Ba = 1 were studied. Synthesis condition and superconductivity of Pb(Ba, Sr)₂(Y, Ca)Cu₃O_y with various ratio of Sr/Ba and Ca/Y were also studied. It was found that T_c increased with increasing Ca concentration, and that Sr-rich specimens allowed to contain more Ca. PbBa_0.8Sr_1.2Y_0.6Ca_0.4Cu₃O₇ showed superconductivity with zero-resistance temperature of 42 K, which was higher than PbBaSrY_0.7Ca_0.3Cu₃O₇ with maximum Ca content for Sr/Ba = 1. Decrease in averaged ionic radii of Ba and Sr in Sr-rich compositions would be favorable for the contraction of Cu-O bonds by hole-doping via Ca substitution for Y.     

Radiation dose of workers originating from radon in the show Cave of Tapolca,Hungary

In the last few decades attention has been given to improve workplace conditions, primarily to reduce the different health risks. In the air that accumulates in underground workplaces radon may constitute one of the health risks. The radon concentration in the show cave in Tapolca is especially high in summer months, with the annual average in the year 2005 being 7227 Bq/m³, in 2006 8591 Bq/m³. The radon concentration was found to be independent on the location of the measurement. Its value was rather similar for working hours and for the total period. The hours spent in the cave by the workers depend on the number of visitors. The radiation dose, estimated on the basis of personal dosimeters, is significant for those working there especially, employed during the whole year. Taking into consideration the actual working hours and the equilibrium factor, F = 0.4, given in the literature, it approaches and even exceeds the dose limit of 20 mSv/year. With a well organized work schedule, as well as the employment of outside workers during the summer period, the dose limit of 20 mSv/year can probably be maintained. However, on the basis of recent measurements, the actual equilibrium factor was determined to be F = 0.5, which in turn means a further 25% increase in the dose effect.