Silicon-Based Integrated Optic Pressure Sensor Using Intermodal Interference between TM-Like and TE-Like Modes

In this paper, a silicon-based integrated optic pressure sensor using an intermodal interference between the fundamental TM-like and TE-like modes is described. The sensor consists of a micromachined rectangular diaphragm and a straight polystyrene optical waveguide passing over the diaphragm. Its sensitivity is theoretically known to be strongly dependent on the position of the waveguide over the diaphragm. To experimentally investigate such dependence, we fabricated a sensor with a 1.2 mm ×10 mm ×20 μm diaphragm, over which waveguides were placed at 50 μm intervals. The measured phase sensitivity was 98 mrad/kPa for the waveguide nearest to the diaphragm edge. The measurement was also carried out for the other waveguides. As theoretically expected, the largest sensitivity was obtained for the waveguide nearest to the edge.     

Constructing finitely presented monoids which have no finite complete presentation

Squier (1987) showed that if a monoid is defined by a finite complete rewriting system, then it satisfies the homological finiteness condition FP₃, and using this fact he gave monoids (groups) which have solvable word problems but cannot be presented by finite complete systems. In the present paper we show that a monoid cannot have a finite complete presentation if it contains certain special elements. This observation enables us to construct monoids without finite complete presentation in a direct and elementary way. We give a finitely presented monoid which has (1) a word problem solvable in linear time and (2) linear growth but (3) no finite complete presentation. We also give a finitely presented monoid which has (1) a word problem solvable in linear time, (2) finite derivation type in the sense of Squier and (3) the property FP_∞, but (4) no finite complete presentation.     

Linear and Nonlinear Optical Properties Of Racemic (±)2-(α-Methylbenzylamino)-5-Nitropyridine Single Crystals

Linear and nonlinear optical properties of racemic (±)2-(α-methylbenzylamino)-5-nitropyridine ((±)MBANP) single crystals have been comprehensively investigated and compared with those of the enantiomorph (–)2-(α-methylbenzylamino)-5-nitropyridine ((–)MBANP) crystals. (±)MBANP crystal exhibits very high chemical and physical stability, but relatively small nonlinear optical coefficients (d₃₁ = 6.8 pm/V, d₃₂ = 4.7 pm/V, d₃₃ = 0.84 pm/V). A comparison between the nonlinear optical coefficients of (±)MBANP and (–)MBANP demonstrates the validity of the oriented-gas model in molecular crystals that neglects all the contributions from intermolecular interaction.     

Wavelength dependence in photochemical vapor deposition of aluminum film using dimethylaluminum hydride

In photochemical vapor deposition of aluminum film on silicon using dimethylaluminum hydride, (CH₃)₂AlH, a surface reaction dominated below a (CH₃)₂AlH pressure of 0.3 m Torr at 200°C, which was induced only with the 160 nm band emitted from a deuterium lamp. A gas-phase reaction occurred above 0.3 mTorr at 200°C, which could be induced by both 160 nm and 240 nm emission bands from the lamp. To distinguish between surface ad gas-phase reactions, a thickness profile was used. At 240°C the surface reaction could be induced even by the 240 nm band, while the deposits formed under illumination of the two bands were thinner than those obtained with only the 240 nm band, indicating occurrence of vacuum ultraviolet (VUV)-enhanced desorption. The mechanism responsible for the observed wavelength dependence in unclear. The electrical resistivity of the films deposited at 200°C was 4.5 μΩ cm, which did not change with wavelength.     

Influence of Zn Diffusion on Bandwidth and Extinction in MQW Electroabsorption Modulators Buried with Semi-Insulating InP

A comprehensive analysis of multi-quantum-well electroabsorption modulators buried with semi-insulating (SI)-InP is presented. We quantitatively demonstrate that suppression of Zn diffusion into the burying and optical core layers plays a key role in high-speed and high-extinction operation.     

Synthesis and chiroptical properties of optically active poly(ethynylcarbazole) derivatives: Substituent effect on the helix formation

Novel chiral acetylene monomers containing carbazole, 2‐ethynyl‐9‐[(S)‐2‐methylbutoxycarbonyl]carbazole ( 1 ), 3‐ethynyl‐9‐[(S)‐2‐methylbutoxycarbonyl]carbazole ( 2 ), 2‐ethynyl‐9‐[(S)‐2‐methylbutyl]carbazole ( 3 ), and 2‐ethynyl‐9‐[(S)‐4‐methylhexyl]carbazole ( 4 ) were synthesized and polymerized with [(nbd)RhCl]₂? Et₃N. The corresponding polyacetylenes with number‐average molecular weights ranging from 68,700 to 310,000 were obtained in good yields. Poly( 1 ) exhibited a large specific rotation and an intense Cotton effect in toluene, indicating that it formed a helix with predominantly one‐handed screw sense, while the other three polymers showed no evidence for taking a helical structure. Poly( 1 ) largely decreased the CD intensity upon heating from ?10 to 60 °C. Poly( 1 ) showed a Cotton effect in film state in a manner similar to solution state. No chiral amplification was observed in the copolymerization of 1 with achiral 2‐ethynyl‐9‐tert‐butoxycarbonylcarbazole ( 5 ). © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 4450–4458, 2007     

Surfaces which contain helical geodesics

LetM be a complete smooth surface of constant mean curvature in the Euclidean 3-space. If there exists two helical geodesics onM through each point ofM, thenM is either a plane, a sphere, or a circular cylinder.