Photon channelling in foams

Experiments by Gittings, Bandyopadhyay and Durian (Europhys. Lett. 65, 414 (2004)) demonstrate that light possesses a higher probability to propagate in the liquid phase of a foam due to total reflection. The authors term this observation photon channelling which we investigate in this article theoretically. We first derive a central relation in the work of Gitting et al. without any free parameters. It links the photon's path-length fraction f in the liquid phase to the liquid fraction ɛ. We then construct two-dimensional Voronoi foams, replace the cell edges by channels to represent the liquid films and simulate photon paths according to the laws of ray optics using transmission and reflection coefficients from Fresnel's formulas. In an exact honeycomb foam, the photons show superdiffusive behavior. It becomes diffusive as soon as disorder is introduced into the foams. The dependence of the diffusion constant on channel width and refractive index is explained by a one-dimensional random-walk model. It contains a photon channelling state that is crucial for the understanding of the numerical results. At the end, we shortly comment on the observation that photon channelling only occurs in a finite range of ɛ.     

High precision delta(17)O isotope measurements of oxygen from silicates and other oxides: method and applications

The use of infrared laser-assisted fluorination to release oxygen from milligram quantities of silicates or other oxide mineral grains is a well-established technique. However, relatively few studies have reported the optimisation of this procedure for oxygen-17 isotope measurements. We describe here details of an analytical system using infrared (10 μm) laser-assisted fluorination, in conjunction with a dual inlet mass spectrometer of high resolving power ( approximately 250) to provide (17)O and (18)O oxygen isotope measurements from 0.5-2 mg of silicates or other oxide mineral grains. Respective precisions (1) of typically 0.08 and 0.04 per thousand are obtained for the complete analytical procedure. Departures from the mass-dependent oxygen isotope fractionation line are quantified by Delta(17)O; our precision (1) of such measurements on individual samples is shown to be +/-0.024 per thousand. In turn, this permits the offset between parallel, mass-dependent fractionation lines to be characterised to substantially greater precision than has been possible hitherto. Application of this system to investigate the (17)O versus (18)O relationship for numerous terrestrial whole-rock and mineral samples, of diverse geological origins and age, indicates that the complete data set may be described by a single, mass-dependent fractionation line of slope 0.5244+/- 0.00038 (standard error). Copyright 1999 John Wiley & Sons, Ltd.     

Copper and iron interactions with angiotensin-converting enzyme inhibitors. A study by fast-atom bombardment tandem mass spectrometry

Fast atom bombardment, combined with high-energy collision-induced tandem mass spectrometry, has been used to investigate gas-phase metal-ion interactions with captopril, enalaprilat and lisinopril, all angiotensin-converting enzyme inhibitors.Suggestions for the location of metal-binding sites are presented. For captopril, metal binding occurs most likely at both the sulphur and the nitrogen atom. For enalaprilat and lisinopril, binding preferably occurs at the amine nitrogen. Copyright 1999 John Wiley & Sons, Ltd.     

Complex catalyst studies of ziegler—natta type : I. A study of the iron stearate reaction with alkyl-aluminium in solvents with the help of the mössbauer effect and ir spectroscopy

The usual reaction of alkylaluminium addition to the end carbonyl groups of the stearate ligand takes place with Al(₂N₅)₃ : Fe(C₁₇N₃₅COO)₃ ? 2, maintaining the dimer structure of the original iron stearate. The reaction is not significantly complicated by redox reactions.     

Time series modeling of Army Mission Command communication networks: an event-driven analysis

We examine the communication time series of a fully-networked Army coalition command and control organization. The network comprised two echelons of command, at the Division and Brigade levels, over a 2-week military scenario exercise involving a Mission Command staff communicating over email and phone. We used time series analysis to predict the communications record based on an external work variable of the number of important scenario events occurring across time. After taking into account structural features of the time series—decreasing communications over time, a network crash, and the transition between weeks—we examined the remaining variability in email and phone communication. We found that the exercise scenario events were not a significant predictor of the Divisional communications, which were best fit by an auto-regressive model of order 1, meaning that the best predictor of the volume of communications at a given time point was the volume of communications on the immediately preceding time point. The occurrence of scenario events, however, did predict the Brigade communication time series, which were well fit by a lag dependent variable model. These results demonstrate that Brigade communications responded to and could be predicted by battlefield events, whereas the Division communications were only predicted by their own past values. These results highlight the importance of modeling environmental work events to predict organizational communication time series and suggest that network communications are perhaps increasingly dependent upon battlefield events for lower echelons of command closer to the tactical edge.     

A study of some parameters relevant to the response of harwell PMMA dosimeters to gamma and electron irradiation

The effects on the radiation response of Harwell polymethylmethacrylate (PMMA) dosimeters of dose-rate, radiation type, temperature during irradiation and post-irradiation storage, and post-irradiation stability, are of importance to the operators of commercial irradiation facilities.

This paper describes recent studies of the effects of some of these parameters on the radiation response of Harwell Red 4034, Amber 3042, and Gammachrome YR Perspex dosimeters, and provides data on batch to batch variation and shelf-life.     

High throughput screening platform for new inhibitors of protein biosynthesis

The search for new antibiotics is an important task, which is of interest for both basic research and health care practices. It is essential to elucidate the mechanism of antimicrobial action during the screening for antimicrobial activity and at the same time be able to test thousands of compounds. A robotic screening system for potential antibiotics developed at the Department of Chemistry at Moscow State University has been described that enables the immediate identification of those that inhibit protein biosynthesis.     

Size‐matched alkyne‐conjugated cyanine fluorophores to identify differences in protein glycosylation

Currently, there are few methods to detect differences in posttranslational modifications (PTMs) in a specific manner from complex mixtures. Thus, we developed an approach that combines the sensitivity and specificity of click chemistry with the resolution capabilities of 2D‐DIGE. In “Click‐DIGE”, posttranslationally modified proteins are metabolically labeled with azido‐substrate analogs, then size‐ and charge‐matched alkyne‐Cy3 or alkyne‐Cy5 dyes are covalently attached to the azide of the PTM by click chemistry. The fluorescently‐tagged protein samples are then multiplexed for 2DE analysis. Whereas standard DIGE labels all proteins, Click‐DIGE focuses the analysis of protein differences to a targeted subset of posttranslationally modified proteins within a complex sample (i.e. specific labeling and analysis of azido glycoproteins within a cell lysate). Our data indicate that (i) Click‐DIGE specifically labels azido proteins, (ii) the resulting Cy‐protein conjugates are spectrally distinct, and (iii) the conjugates are size‐ and charge‐matched at the level of 2DE. We demonstrate the utility of this approach by detecting multiple differentially expressed glycoproteins between a mutant cell line defective in UDP‐galactose transport and the parental cell line. We anticipate that the diversity of azido substrates already available will enable Click‐DIGE to be compatible with analysis of a wide range of PTMs.     

Focused proteomics: monoclonal antibody-based isolation of the oxidative phosphorylation machinery and detection of phosphoproteins using a fluorescent phosphoprotein gel stain

We have raised monoclonal antibodies capable of immunocapturing all five complexes involved in oxidative phosphorylation for evaluating their post-translational modifications. Complex I (NADH dehydrogenase), complex II (succinate dehydrogenase), complex III (cytochrome c reductase), complex IV (cytochrome c oxidase), and complex V (F1F0 ATP synthase) from bovine heart mitochondria were obtained in good yield from small amounts of tissue in more than 90% purity in one step. The composition and purity of the complexes was evaluated by Western blotting using monoclonal antibodies against individual subunits of the five complexes. In this first study, the phosphorylation state of the proteins without inducing phosphorylation or dephosphorylation was identified by using the novel Pro-Q Diamond phosphoprotein gel stain. The major phosphorylated components were the same as described before in sucrose gradient enriched complexes. In addition a few additional potential phosphoproteins were observed. Since the described monoclonal antibodies show cross reactivity to human proteins, this procedure will be a fast and efficient way of studying post-translational modifications in control and patient samples using only small amounts of tissue.