A new approach for fluorine determination by solid sampling graphite furnace molecular absorption spectrometry

This work deals with the determination of fluorine by solid sampling graphite furnace molecular absorption spectrometry. The molecular absorbance of aluminum monofluoride (AlF), which is produced in the vapor phase in the presence of Al³⁺, is measured at 227.5 nm, a non-resonant platinum line. A conventional graphite furnace program has been used with pyrolysis and vaporization temperatures of 800 and 2300 °C, respectively. Solutions of Ba²⁺ and Al³⁺ have been used to avoid fluorine losses during the pyrolysis stage and to produce AlF in the vaporization stage, respectively. Certified coal and alumina samples were analyzed using aqueous standards for calibration. The agreement between the found concentration and the certified value, or the value obtained by another method ranged from 92 to 105%, with a relative standard deviation less than 8.5%. The limit of detection and the characteristic mass was 0.17 μg g^− 1 and 205 pg, respectively.     

Determination of copper in medicinal plants used as dietary supplements by atomic absorption spectrometry with direct flame solid analysis

An alternative device for the direct solid analysis (DSA) for copper determination by flame atomic absorption spectrometry (FAAS) is proposed. Copper was directly determined in commercial medicinal plants used as dietary supplements. The determination of copper in solid samples by DSA–FAAS was made by using a conventional air–acetylene flame. Between 0.05 and 1.5 mg of each test, sample was weighed directly into a small polyethylene vial connected to the device used for solid introduction into the flame. Test samples were introduced into the flame as a dry aerosol using a T-quartz cell set between the burner and the optical path. The T-quartz cell has a slit in the superior part by which the solid aerosol passes to the flame. A transient signal, evaluated as integrated absorbance, is produced and it is totally integrated in 2 s. Background signals always presented absorbance values less than 0.1. It was found a characteristic mass of 0.8 ng Cu and absolute limit of detection of 1.2 ng (3 s), or 1.2 μg g⁻¹ if a sample mass of 1 mg was used. Optimized conditions for air flow rate, flame stoichiometry, and so on were established as well. No excessive grinding of the samples was needed and samples with particle of size less than 80 μm were used throughout. No statistical difference between the results from the proposed system and those obtained by sample digestion and determination by conventional FAAS was observed. With the proposed procedure, more than 50 test samples can be analyzed in 1 h and it can be easily adapted to conventional spectrometers for FAAS.     

Application of micellar electrokinetic chromatography to the quality control of a pharmaceutical preparation containing three bronchodilators

Theophylline(1,3-dimethylxanthine), dyphylline [7-(2,3-dihydroxypropyl)theophylline] and proxyphylline [7-(beta-hydroxypropyl)theophylline] are three bronchodilators administered jointly in a single pharmaceutical preparation used against asthma. A micellar electrokinetic chromatography (MEKC) method for their resolution using a background electrolyte consisting of 20 mM tetraborate at pH 8.5 and 100 mM sodium dodecyl sulfate is proposed. The method was used to determine the three active principles in a pharmaceutical preparation. The small amount of sample required and the expeditiousness of the procedure allow content uniformity to be determined in individual tablets. The values of the validation parameters for the method (viz. selectivity, linearity, accuracy, precision, limit of detection, limit of quantitation and robustness) are reported. A complete factor design (2(3)x2) including pH, the surfactant concentration and the ionic strength of the background electrolyte as factors was used to estimate robustness. Based on the results, the method is robust enough for quantitation purposes.     

Stereoselective synthesis of substituted exo-glycals from 1-exo-methylene pyranoses

Halo-exo-glycals of the gluco-, manno- and galacto- series, readily prepared by reaction of 1-exo-methylene pyranoses with iodonium dicollidinium triflate (IDCT), undergo Suzuki or B-alkyl Suzuki cross-coupling reactions with boronic acids or alkyl boranes to yield, in a stereoselective manner, functionalized exo-glycals.     

Convergent stereocontrolled synthesis of substituted exo-glycals by Stille cross-coupling of halo-exo-glycals and stannanes

(Z)-exo-Glycals can be conveniently prepared in a convergent manner by Stille cross-coupling of (Z)-halo(Br,I)-exo-glycals and aryl or alkenyl stannanes, the latter are readily obtained by addition of tributylstannyl radicals to terminal alkynes.     

Anthill Earth as a Gold Occurrence Indicator,and Gold Determination by Solid Sampling Flame Atomic Absorption Spectrometry

With the aim of avoiding cumbersome sample treatment, we present a device for the introduction of solid soil samples into AAS-flames for gold determination, as well as the proposition of earth from anthills as a gold occurrence indicator. A previous ground sample of anthill earth (0.50 mg) was weighed directly into a small recipient of polyethylene which was then connected to a sampling boronsilicate glass chamber. The sample was carried by an airflow (5 L min⁻¹) to a quartz cell positioned between the burner top and the optical beam. The generated atomic vapor produced a transient signal which was totally integrated in three seconds. The performance was compared with conventional flame atomic absorption spectrometry after proper sample digestion. No significant differences were observed between both procedures (mean deviation ±1.90%), and a LOQ of 0.03 μg Au was achieved using the proposed method. The anthill earth was found to be very suitable for indication of gold occurrence in soils and related materials.