High‐mobility solution‐processed zinc oxide thin films on silicon nitride

A high effective electron mobility of 33 cm² V^–1 s^–1 was achieved in solution‐processed undoped zinc oxide (ZnO) thin films. The introduction of silicon nitride (Si₃N₄) as growth substrate resulted in a mobility improvement by a factor of 2.5 with respect to the commonly used silicon oxide (SiO₂). The solution‐processed ZnO thin films grown on Si₃N₄, prepared by low‐pressure chemical vapor deposition, revealed bigger grain sizes, lower strain and better crystalline quality in comparison to the films grown on thermal SiO₂. These results show that the nucleation and growth mechanisms of solution‐processed films are substrate dependent and affect the final film structure accordingly. The substantial difference in electron mobilities suggests that, in addition to the grain morphology and crystalline structure effects, defect chemistry is a contributing factor that also depends on the particular substrate. In this respect, interface trap densities measured in high‐κ HfO₂/ZnO MOSCAPs were about ten times lower in those fabricated on Si₃N₄ substrates. (© 2014 WILEY‐VCH Verlag GmbH &Co. KGaA, Weinheim)

     

Photocatalytic degradation of azo dyes using Zn-doped and undoped TiO2 nanoparticles

Undoped and Zn-doped TiO₂ nanoparticles were synthesized by the sol gel method. The dopant (Zn) was taken at 0.1, 0.2, 0.5, 0.7, and 1.0 mol%. The initial precursors were titanium tetraisopropoxide and zinc acetate. The samples were characterized by X-ray powder diffraction, Fourier transform infrared spectroscopy, transmission electron microscopy, and UV–vis diffuse reflectance. The photocatalytic activity of the prepared nanoparticles was studied by observing their role in degradation of two azo dyes, i.e., Eriochrome Black T and Methyl Red under UV–visible light. The results revealed that Zn-doped TiO₂ nanoparticles exhibited better degradation as compared to undoped TiO₂ nanoparticles. In this study, 0.7 mol% Zn-doped TiO₂ showed highest photocatalytic activity. Doping of Zn allowed better separation of electron–hole pairs which results in increased oxidation and reduction reactions.     

Flame stabilization in high pressure LOx/GH2 and GCH4 combustion

Planar laser induced fluorescence (PLIF) of OH is used to examine flame stabilization in high pressure cryogenic flames formed by injecting a central jet of low speed liquid oxygen surrounded by a high speed gaseous stream of hydrogen or methane. In the LO_x/GH₂ experiments injection conditions are transcritical as the chamber pressure is above critical but the temperature is below critical . In the LO_x/GCH₄ experiments the chamber pressure and LO_x injection temperature are below critical , . Hydrogen or methane are injected at room temperature LIF images delineate the flame edge in the injector nearfield. The two flames are stabilized in the vicinity of the liquid oxygen injector lip but the anchor point is found to lie closer to the lip in the LO_x/GH₂ case and its displacement from shot to shot is of a smaller amplitude than that corresponding to the LO_x/GCH₄ flame. Interpretation of these data is based on a previous analysis which indicates that stabilization is essentially controlled by a dimensionless group formed by comparing the lip thickness to the flame edge thickness Ψ = h_s/δ_f. It is found that Ψ slightly exceeds unity in the LO_x/GH₂ case essentially fulfilling the stability condition while Ψ < 1 in the LO_x/GCH₄ case. In this last situation the flame is thicker than the characteristic thickness h_s and it is therefore sensitive to the high speed methane stream. Anchoring is imperfect and the flame edge moves with the turbulent eddies shed from the lip. Global stabilization is achieved dynamically but the reactive layer is not well established and the large amplitude motion of the edge is a symptom of a possible lift-off. Theoretical estimates indicate that LO_x/GCH₄ flame stabilization requires a thicker lip size than the LO_x/GH₂ propellant couple.     

Stevia rebaudiana targeting α-amylase: An in-vitro and in-silico mechanistic study

Diabetes mellitus (DM) is the fastest growing metabolic disorder in the world. Recently, more attention is paid to the study of natural products due to side effects of synthetic drugs. Stevia rebaudiana (Bertoni) is considered an encouraging starting point for the antidiabetic lead development. In the present study, the in vitro α-amylase inhibitory activity of the extracts of S. rebaudiana is investigated. In order to understand the molecular mechanism and future pharmacophore development, in silico study of secondary metabolites isolated from S. rebaudiana was carried out. Results indicated that water extract shows highest α-amylase inhibitory activity as compared to other extracts. Moreover, compound 20 (rebaudioside A) which has been previously reported and isolated from water extract showed the impressive binding profile with α-amylase. Therefore, our study suggests that S. rebaudiana could be used in the development of therapeutic drugs for the treatment of diabetes.     

Pd(II)-Catalyzed Benzimidazole-Assisted Annulation of 3-(1H-Benzo[d]imidazol-2-yl)-2H-chromen-2-one: Access to Imidazo[1,2-a]chromeno[3,4-c]pyridine

Palladium-catalyzed [4+2] oxidative annulation of coumarin-benzimidazoles with olefins for the synthesis of polycyclic aromatic hydrocarbons have been achieved. This synthetic protocol gives access to a wide range of structurally distinct imidazo[1,2-a]chromeno[3,4-c]pyridines in moderate to good yield with wide functional group tolerance. Further, photophysical properties of annulated scaffolds have been examined, which discloses their interesting solvatochromic emission behaviors.     

Rhodium-Catalyzed C8-Alkenylation of Isoquinolones with Maleimides

An efficient Rh(III)-catalyzed C−H alkenylation of N-protected isoquinolone with maleimides is reported. The carbonyl group of isoquinolone acts as an inherent directing group. Various N-substituents in the maleimide, including alkyl, aryl, and even H and −OH, were well tolerated under the developed reaction condition. This protocol showed broad substrate scope, good selectivity, and excellent yields. Hammett plot is also drawn to check the effect of substituents on the reaction progress.     

Spectrophotometric Determination of Rhenium(IV) with Thiocyanate,TX-100 and N,N′-Diphenylbenzamidine

A spectrophotometric method to determine rhenium(IV) at trace level is based on the extraction of Re(IV)-SCN^? complex in sulphuric acid media with N,N′-diphenylbenzamidine(DPBA) in presence of a non-ionic surfactant triton X-100 (TX-100) in chloroform. The complex shows maximum absorbance at 435 nm with amolar absorptivity value of 4.24 × 10⁴ L mol^?1 cm^?1 at an acidity range 3.5-6.5 M H₂SO₄. The method followed Beer's Law for the system Re(IV)-SCN^?(TX-100)-DPBA upto 4.0 μg Re(IV) mL^?1. The detection limit of the method is 5 ppb. None of the tested foreign ions, except molybdenum(VI), interfere with the determination of rhenium. The interference due to molybdenum could effectively be removed by prior precipitation with oxine. The effect of various analytical parameters on the extraction of the metal are discussed.     

Imprinted silica nanoparticles coated with N‐propylsilylmorpholine‐4‐carboxamide for the determination of m‐cresol in synthetic and real samples

m‐Cresol‐imprinted silica nanoparticles coated with N‐propylsilylmorpholine‐4‐carboxamide have been developed that contain specific pockets for the selective uptake of m‐cresol. Silica nanoparticles were synthesized by a sol–gel process followed by functionalization of their surface with N‐propylsilylmorpholine‐4‐carboxamide. The formation of m‐cresol‐imprinted silica nanoparticles was confirmed by UV‐Vis spectrophotometry, infrared spectroscopy, thermogravimetric analysis, scanning electron microscopy and transmission electron microscopy. Electron microscopic studies revealed the formation of monodispersed imprinted silica nanoparticles with spherical shape and an average size of 83 nm. The developed nanoparticles were filled in a syringe and used for the extraction of m‐cresol from aqueous samples followed by quantification using high‐performance liquid chromatography with diode array detection. Various adsorption experiments showed that developed m‐cresol‐imprinted silica nanoparticles exhibited a high adsorption capacity and selectivity and offered a fast kinetics for rebinding m‐cresol. The chromatographic quantification was achieved using mobile phase consisting of acetonitrile/water (70:30 v/v) at an isocratic flow rate of 1.0 mL/min using a reversed‐phase C₁₈ column and detection at λ_max = 275 nm. The limits of detection and quantification were 1.86 and 22.32 ng/mL, respectively, for the developed method. The percent recoveries ranged from 96.66–103.33% in the spiked samples. This combination of this nanotechnique with molecular imprinting was proved as a reliable, sensitive and selective method for determining the target from synthetic and real samples.     

Use of ultra-filtration in organic-rich groundwater for the physical separation of thorium

During this work, size fractionation technique “ultra filtration” is used in physical speciation of thorium in organic rich groundwater. Laboratory simulated experiments were carried out to study the physical speciation of thorium in aquatic environment having elevated level of dissolved humus material classified as dissolved organic carbon (DOC). Samples were collected from organic rich environment having DOC in the range of 50–60 µg mL^?1. Th(IV) ions are extremely particle reactive having K _d value of the order of 10^5–6, hence to avoid adsorption on suspended particulate matter, spiking of the solution with Th(NO₃)₄ was carried out in ground water samples after filtering through 450 nm pore size using suction filtration. Particles in dissolved state (colloids) ranging between <450 and >220 nm were separated using suction filtration assembly having a membrane with a pore diameter of 220 nm. Thereafter, solution was sequentially passed through the ultra-filtration membranes having pore diameters of 14 nm [300 k NMWL (nominal molecular weight limit)], 3.1 nm (50 k NMWL), 2.2 nm (30 k NMWL), 1.6 nm (10 k NMWL) and 1.1 nm (0.5 k NMWL) by using “Stirred Ultra-filtration Cells”, operating in concentration mode. Thorium has only one stable oxidation state i.e. IV, under all redox conditions in natural waters and therefore, its speciation is dominated by its interaction with various fractions of DOC. Experimental results show 50–60 % of the spiked Th is in association with fraction enriched with particles of 10 k NMWL (1.6 nm) followed by fraction enriched with particle of 0.5 k NMWL and <220 nm.