DTA and X-ray diffraction investigations of laser-irradiated CeO2 powders

The TG and DTA curves and diffractograms of powdered CeO₂ samples irradiated with a CO₂ laser beam with powers of 0.41–1.39 kW/cm² are presented. The laser treatment induced structural changes and probably generation of a metastable phase. X-ray diffraction coupled with thermal analysis was used to establish the structural modifications in the irradiated samples after heating.     

Effect of time on the interfacial and foaming properties of beta-lactoglobulin/acacia gum electrostatic complexes and coacervates at pH 4.2

The electrostatic complexation between beta-lactoglobulin and acacia gum was investigated at pH 4.2 and 25 degrees C. The binding isotherm revealed a spontaneous exothermic reaction, leading to a DeltaHobs = -2108 kJ mol(-1) and a saturation protein to polysaccharide weight mixing ratio of 2:1. Soluble electrostatic complexes formed in these conditions were characterized by a hydrodynamic diameter of 119 +/- 0.6 nm and a polydispersity index of 0.097. The effect of time on the interfacial and foaming properties of these soluble complexes was investigated at a concentration of 0.1 wt % at two different times after mixing (4 min, referred as t approximately 0 h and t = 24 h). At t approximately 0 h, the mixture is mainly made of aggregating soluble electrostatic complexes, whereas after 24 h these complexes have already insolubilize to form liquid coacervates. The surface elasticity, viscosity and phase angle obtained at low frequency (0.01 Hz) using oscillating bubble tensiometry revealed higher fluidity and less rigidity in the film formed at t approximately 0 h. This observation was confirmed by diminishing bubble experiments coupled with microscopy of the thin film. It was thicker, more homogeneous and contained more water at t approximately 0 h as compared to t = 24 h (thinner film, less water). This led to very different gas permeability's of Kt approximately 0 h = 0.021 cm s(-1) and Kt=24 h) = 0.449 cm s(-1), respectively. Aqueous foams produced with the beta-lactoglobulin/acacia gum electrostatic complexes or coacervates exhibited very different stability. The former (t approximately 0 h) had a stable volume, combining low drainage rate and mainly air bubble disproportionation as the destabilization mechanism. By contrast, using coacervates aged for 24 h, the foam was significantly less stable, combining fast liquid drainage and air bubble destabilization though fast gas diffusion followed by film rupture and bubble coalescence. The strong effect of time on the air/water interfacial properties of the beta-lactoglobulin/acacia gum electrostatic complexes can be understood by their reorganization at the interface to form a coacervate phase that is more fluid/viscous at t approximately 0 h vs rigid/elastic at t = 24 h.     

Thermal studies of pre-formulates of metronidazole obtained by spray drying technique

Compatibility studies between active drugs and excipients are substantial in the pharmaceutical technology. The objective of the present work was to develop pre-formulated mixtures of metronidazole (MT) obtained by spray drying (SPDR) and their thermoanalytical characterization. Dynamic and isothermal TG, conventional DSC and DSC coupled to a photovisual system were used. DSC experiments with both techniques confirmed the homogeneity of the conventional and pre-formulated mixtures. The TG data made possible the comparison the thermal stability of the different mixtures. Similar thermal stabilities were found of the conventional and pre-formulated mixtures, with slower particles sizes of MT.     

Organophosphorus chemistry,XII. Reaction of furil with alkyl phosphites and ylide-phosphoranes

Summary The reaction of furil (1) with trialkyl phosphites2 yielded caged phosphorane derivatives of types3a-c. Dry hydrogen chloride gas converted3a-c into the respectivea-hydroxyvinyl-phosphates8a-c which are equally produced by reacting furil with the appropriate dialkyl phosphite7. The reaction of furil with ylide-phosphoranes10 proceeded according to the Wittig reaction mechanism to give the respective ethylenes11a-c. The new compounds have been characterized by their spectroscopic data (IR, PMR,³¹P-NMR, MS) and elementary analyses.Dedicated to Prof. M. Sidky on the occasion of his 60th birthday     

PMR-Spektren einiger Alkoxy-9-chlor-6-nitroacridine

The spectra of some 9-chloro-6-nitroacridines with methoxy substituents in position 1,4; 2,4; 3,4; 2,3; and ethoxy substituents in positions 1, 2, 3, were recorded. The influence of electron releasing alkoxy groups and electron withdrawing nitro groups on chemical shifts of protons in the 9-chloroacridinic cycle was discussed and PMR parameters were determined, comparatively with those of acridine and 9-chloroacridine. Good agreement between calculated and experimental values is observed. The spectrum of 9-chloro-1,2,3-triethoxyacridine shows for the four protons of the ringC. (H-5, H-6, H-7, H-8) anAMNX coupling pattern whose parameters were determined.     

Partial Least-Squares Study of the Effects of Organic Modifier and Physicochemical Properties on the Retention of Some Thiazoles

JPC – Journal of Planar Chromatography – Modern TLC - Reversed-phase (RP) HPTLC with aqueous ammonia-organic modifier (acetonitrile, dioxane, acetone) mobile phases has been used to...     

Preparation of cellulose and cellulose derivative azo compounds

Wood pulp and cotton linter are the most common sources of cellulose forindustrial use. Methyl cellulose (MC) and cellulose sulfate (CS) were preparedusing bleached wood pulp and cotton linter. Coloured azo compounds were alsoprepared from coupling cellulose, wood pulp, MC and CS with aromatic diazoniumsalt. The presence of electron-releasing or withdrawing substituents affectedthe electrophilic substitution reaction. The produced azo compounds werecharacterized by FT-IR methodology, as well as mass spectrometry, in which thefunctional groups and the ion fragments of the products were analyzed.     

Structural basis for discriminative regulation of gene expression by adenine- and guanine-sensing mRNAs

Metabolite-sensing mRNAs, or "riboswitches," specifically interact with small ligands and direct expression of the genes involved in their metabolism. Riboswitches contain sensing "aptamer" modules, capable of ligand-induced structural changes, and downstream regions, harboring expression-controlling elements. We report the crystal structures of the add A-riboswitch and xpt G-riboswitch aptamer modules that distinguish between bound adenine and guanine with exquisite specificity and modulate expression of two different sets of genes. The riboswitches form tuning fork-like architectures, in which the prongs are held in parallel through hairpin loop interactions, and the internal bubble zippers up to form the purine binding pocket. The bound purines are held by hydrogen bonding interactions involving conserved nucleotides along their entire periphery. Recognition specificity is associated with Watson-Crick pairing of the encapsulated adenine and guanine ligands with uridine and cytosine, respectively.     

Production of antitumoral retamycin during fed-batch fermentations of Streptomyces olindensis

Fed-batch runs were performed in order to correlate the production of retamycin, an anthracycline antibiotic produced by Streptomyces olindensis in submerged cultures, with the specific growth rate. Maximum retamycin production was achieved with an exponential feed rate, controlling the specific growth rate at a low value (0.03 h-1, about 10% of the maximum specific growth rate). Control of the specific growth rate at higher values (0.10 and 0.17 h-1) caused a decrease in antibiotic production. Morphology, assessed by image analysis, was shown to be highly relevant in this process. Cell growth mainly in the form of clumps (90% clumps and 10% free filaments) led to better results than growth as clumps (75%) and free filaments (25%).     

Preliminary characterization of anhydrous ethanol used in Brazil as automotive fuel

This work reports preliminary studies on the characterisation of anhydrous ethanol (AEA) used as an automotive fuel mixed with gasoline in Porto Alegre (South Brazil). Pre-concentration of the impurities contained in 1000 ml of AEA was carried on through solid-phase extraction using XAD4 resin. The main compounds in the extract were identified by means of spectral data from the library of the equipment. The concentrate was then fractionated using a preparative liquid chromatographic column filled with activated silica gel and the elution procedure was carried out with, n-hexane, n-hexane-benzene (1:1, v/v) and dichloromethane. Prior to analysis by GC-MS, each fraction was reduced to 1 ml with a gentle stream of nitrogen. Saturated linear hydrocarbons and aromatic hydrocarbons eluted in the first fraction and oxygenated compounds such as aldehydes. ketones and alcohols, eluted in the second one. were the main compounds detected in the sample.