基于XPS对硫铁矿去除SeO2-3的机理研究

硒是动植物及人体生长必需的十五种微量元素之一，具有清除体内自由基、抗氧化、增强免疫力等功能，但其安全剂量的范围却很窄。利用扫描电子显微镜（SEM）和X射线衍射仪（XRD）对湿法球磨制备的硫铁矿形貌进行了表征。SEM观测发现加乙醇助磨后的硫铁矿为粒径大小较均匀的球形颗粒团聚体，粒径范围在17～200 nm之间，平均粒径138 nm。XRD衍射图谱中的特征峰与FeS₂衍射图谱中各峰位置基本一致，因此判定硫铁矿中主要化学组分为FeS₂，且图谱中基本没有杂峰，表明制备过程中并未混入杂质，样品纯度较高。实验结果表明，该法制备的硫铁矿具有颗粒粒径小、比表面积大、反应活性高等优点。研究中利用X射线光电子能谱仪（XPS）对硫铁矿去除水体中SeO2-₃的机理进行了研究。研究结果表明, （1）在较为广泛的实验pH范围（pH 2.2～11.5），硫铁矿均能有效去除水体中SeO2-₃，去除效率（除pH值7.8以外）均达到90%以上；（2）硫铁矿与SeO2-₃发生反应后，其主要组成元素的XPS特征峰结合能有所减小，表明硫铁矿表面发生了一定化学变化；（3）酸碱环境下硫铁矿去除SeO2-₃的机理不完全相同，酸性环境下，硫铁矿对SeO2-₃的去除是单纯的氧化还原过程，即硫铁矿中被酸活化的S2-₂将SeO2-₃还原为单质Se(0)，并且酸性越强，SeO2-₃去除效果越好；碱性环境下，SeO2-₃的去除过程中氧化还原与络合反应并存，硫铁矿表面有络合态Fe(OH)SeO₃和单质Se(0)两种存在形态，且碱性越强，络合态Fe(OH)SeO₃含量越高。以上研究结果为硫铁矿去除固定水体和土壤中以SeO2-₃为代表的可变价金属阴离子提供重要理论依据和应用基础。     

Single Crystal to Single Crystal (SC‐to‐SC) Transformation from a Nonporous to Porous Metal–Organic Framework and Its Application Potential in Gas Adsorption and Suzuki Coupling Reaction through Postmodification

A new amino‐functionalized strontium–carboxylate‐based metal–organic framework (MOF) has been synthesized that undergoes single crystal to single crystal (SC‐to‐SC) transformation upon desolvation. Both structures have been characterized by single‐crystal X‐ray analysis. The desolvated structure shows an interesting 3D porous structure with pendent ?NH₂ groups inside the pore wall, whereas the solvated compound possesses a nonporous structure with DMF molecules on the metal centers. The amino group was postmodified through Schiff base condensation by pyridine‐2‐carboxaldehyde and palladium was anchored on that site. The modified framework has been utilized for the Suzuki cross‐coupling reaction. The compound shows high activity towards the C?C cross‐coupling reaction with good yields and turnover frequencies. Gas adsorption studies showed that the desolvated compound had permanent porosity and was microporous in nature with a BET surface area of 2052 m² g^?1. The material also possesses good CO₂ (8 wt %) and H₂ (1.87 wt %) adsorption capabilities.     

基于LED的多色温多星等单星模拟器

针对星模拟器与星敏感器观星的色温不匹配对星敏感器光信号定标精度产生的影响,设计了一种基于LED的多色温多星等单星模拟器,采用该系统模拟特定色温的星光用于星敏感器光信号定标,大幅降低了色温非匹配带来的定标误差。从理论上分析了色温非匹配影响星敏感器光信号的定标精度的机理;根据设计指标确定了星模拟器的设计方案,主要解决了光源的选型、多色温多星等单星模拟器驱动和控制系统、色温星等匹配算法、多色温多星等单星模拟器软件设计四项关键技术问题;对多色温多星等单星模拟器进行了标定和性能测试:0等星4000K和3等星7000 K星光的光谱匹配误差分别为4.87%和7.83%,星等等级分别为0.03和2.93;光源稳定后,多色温多星等单星模拟器的平行光管出口Φ100 mm口径内的照度非均匀度为6.5%,均满足设计指标。     

Polypyrrole Shell@3D‐Ni Metal Core Structured Electrodes for High‐Performance Supercapacitors

Three‐dimensional (3D) nanometal films serving as current collectors have attracted much interest recently owing to their promising application in high‐performance supercapacitors. In the process of the electrochemical reaction, the 3D structure can provide a short diffusion path for fast ion transport, and the highly conductive nanometal may serve as a backbone for facile electron transfer. In this work, a novel polypyrrole (PPy) shell@3D‐Ni‐core composite is developed to enhance the electrochemical performance of conventional PPy. With the introduction of a Ni metal core, the as‐prepared material exhibits a high specific capacitance (726 F g^?1 at a charge/discharge rate of 1 A g^?1), good rate capability (a decay of 33 % in C_sp with charge/discharge rates increasing from 1 to 20 A g^?1), and high cycle stability (only a small decrease of 4.2 % in C_sp after 1000 cycles at a scan rate of 100 mV s^?1). Furthermore, an aqueous symmetric supercapacitor device is fabricated by using the as‐prepared composite as electrodes; the device demonstrates a high energy density (≈21.2 Wh kg^?1) and superior long‐term cycle ability (only 4.4 % and 18.6 % loss in C_sp after 2000 and 5000 cycles, respectively).     

On Minimal Asymptotic Bases

Mathematical Notes - Let $$\mathbb N$$ denote the set of all nonnegative integers, and let $$A\subseteq\mathbb N$$ . Let $$h,n\in\mathbb N$$ , $$h\ge 2$$ and $$r_h(A,n)=\#\{(a_1,\dots,a_h)\in...     

An experimental study on the fire characteristics of new and aged building wires using a cone calorimeter

Journal of Thermal Analysis and Calorimetry - The fire behavior of one flame-retardant PVC cable used as building wire is investigated in this work. Bench scale tests were performed using a cone...     

A molecular fluorophore in citric acid/ethylenediamine carbon dots identified and quantified by multinuclear solid-state nuclear magnetic resonance

The composition of fluorescent polymer nanoparticles, commonly referred to as carbon dots, synthesized by microwave-assisted reaction of citric acid and ethylenediamine was investigated by ¹³C, ¹³C{¹H}, ¹H─¹³C, ¹³C{¹⁴N}, and ¹⁵N solid-state nuclear magnetic resonance (NMR) experiments. ¹³C NMR with spectral editing provided no evidence for significant condensed aromatic or diamondoid carbon phases. ¹⁵N NMR showed that the nanoparticle matrix has been polymerized by amide and some imide formation. Five small, resolved ¹³C NMR peaks, including an unusual ═CH signal at 84 ppm (¹H chemical shift of 5.8 ppm) and ═CN₂ at 155 ppm, and two distinctive ¹⁵N NMR resonances near 80 and 160 ppm proved the presence of 5-oxo-1,2,3,5-tetrahydroimidazo[1,2-a]pyridine-7-carboxylic acid (IPCA) or its derivatives. This molecular fluorophore with conjugated double bonds, formed by a double cyclization reaction of citric acid and ethylenediamine as first shown by Y. Song, B. Yang, and coworkers in 2015, accounts for the fluorescence of the carbon dots. Cross-peaks in a ¹H─¹³C HETCOR spectrum with brief ¹H spin diffusion proved that IPCA is finely dispersed in the polyamide matrix. From quantitative ¹³C and ¹⁵N NMR spectra, a high concentration (18 ± 2 wt%) of IPCA in the carbon dots was determined. A pronounced gradient in ¹³C chemical-shift perturbations and peak widths, with the broadest lines near the COO group of IPCA, indicated at least partial transformation of the carboxylic acid of IPCA by amide or ester formation.