Dynamic surface tension measurements of surfactant solutions using the maximum bubble pressure method – limits of applicability

One of the essential differences in the design of bubble pressure tensiometers consists in the geometry of the measuring capillaries. To reach extremely short adsorption times of milliseconds and below, the so-called deadtime of the capillaries must be of the order of some 10 ms. In particular, for concentrated surfactant solutions, such as micellar solutions, short deadtimes are needed to minimize the initial surfactant load of the generated bubbles. A theoretical model is derived and confirmed by experiments performed for a wide range of experimental conditions, mainly in respect to variations in deadtime and bubble volume.     

Effect of water hardness on surface tension and dilational visco-elasticity of sodium dodecyl sulphate solutions

The complementary drop and bubble profile analysis and maximum bubble pressure tensiometry are used to measure the dynamic surface tension of aqueous SDS solutions in the presence of hardness salts (CaCl(2) and MgCl(2) in the ratio of 2:1 at concentrations of 6 and 40FH). The presence of hardness salts results in an essential increase of the SDS adsorption activity, which indicates the formation of Ca(DS)(2) and Mg(DS)(2) in the SDS solutions. The surface tension isotherms of SDS in presence of Ca(DS)(2) and Mg(DS)(2) are described using the generalised Frumkin model. The presence of hardness salts accelerates the ageing of SDS solutions as compared with the addition of 0.01 M NaCl due to a faster hydrolysis and hence formation of dodecanol. These results are used to estimate the possible concentration of dodecanol in the studied SDS solutions. The buoyant bubble profile method with harmonic surface oscillations is used to measure the dilational rheology of SDS solutions in presence of hardness salts in the frequency range between 0.005 Hz and 0.2 Hz. The visco-elasticity modulus in the presence of hardness salts is higher as compared with its values in the presence of 0.01 M NaCl additions. The ageing of SDS solutions leads to an essential increase of the visco-elastic modulus.     

Dynamic surface tension and surface rheology of biological liquids

The paper presents results of dynamic and equilibrium surface tension measurements (using a maximum bubble pressure instrument) of serum and urine samples that were obtained from 80 healthy human of various sexes and ages. These data were compared with surface tension measurements of biological liquids obtained from patients suffering from malignant neoplasm of corpus uteri (n=5) and cervix uteri (n=31). In addition, surface dilatational rheology was determined on 32 samples using a drop shape method. The dilatational rheology data were compared with the dynamic surface tension data. Although some trends were found, no significant correlations exist between surface tension and rheology data and any of the disease states or stages. It is difficult to explain these findings in the framework of known mechanisms. However, our studies demonstrate that dynamic interface tensiometry of human biological liquids provide new insight into the biophysical behavior of these liquids, most likely reflecting compositional changes of them during ageing, the course of cancer and as a consequence of therapeutical interventions.     

Computational modelling of blood flow in side arterial branches after stenting of cerebral aneurysms

The major concern with the use of stents as flow diverters for the treatment of intracranial aneurysms is the potential occlusion of a perforating artery or other side branches which can cause ischemic strokes. This article presents image-based patient-specific models of stented cerebral aneurysms in which a small side artery has been jailed by the stent mesh. The results indicate that, because of the large resistances of the distal vascular beds which dominate the flow divisions among the different arterial branches, the flow reduction in jailed side branches is quite small even when a large percentage of the inlet area of these branches has been blocked. This suggests that unless the side branch is completely occluded, it will likely maintain its normal blood flow. Although this conclusion eases the concern of stenting cerebral aneurysms, a complete occlusion can still be caused depending on the conformability characteristics of the stents.     

Influence of disorder on superconductivity in non-magnetic rare-earth nickel borocarbides

The effect of substitutional disorder on the superconducting properties of YNi₂B₂C was studied by partially replacing yttrium and nickel by Lu and Pt, respectively. For the two series of (Y, Lu)Ni₂B₂C and Y(Ni, Pt)₂B₂C compounds, the upper critical field H _c2(T) and the specific heat c _p(T, H) in the superconducting mixed state have been investigated. Disorder is found to reduce several relevant quantities such as T _c, the upper critical field H _c2(0) at T=0 and a characteristic positive curvature of H _c2(T) observed for these compounds near T _c. The H _c2(T) data point to the clean limit for (Y, Lu) substitutions and to a transition to the quasi-dirty limit for (Ni, Pt) substitutions. The electronic specific heat contribution γ(H) exhibits significant deviations from the usual linear γ(H) law. These deviations reduce with growing substitutional disorder but remain even in the quasidirty limit which is reached in the Y(Ni_1−x , Pt _x )₂B₂C samples for x=0.1.     

Non-resonant microwave absorption studies of superconducting MgB2 and MgB2 + MgO

Non-resonant microwave absorption (NRMA) studies of superconducting MgB₂ and a sample containing ∼10% by weight of MgO in MgB₂ are reported. The NRMA results indicate near absence of intergranular weak links in the pure MgB₂ sample. A linear temperature dependence of the lower critical field H _c1 is observed indicating a non-s wave superconductivity. However, the phase reversal of the NRMA signal which could suggest d wave symmetry is also not observed. In the MgB₂ + MgO sample, much larger low field dependent absorption is observed indicating the presence of intergranular weak links. The hysteretic behavior of NRMA is compared and contrasted in the two samples. In the pure MgB₂ sample, a large hysteresis is observed between the forward and the reverse scans of the magnetic field indicating strong pinning of flux lines. This hysteresis saturates a few degrees below T _c while in the MgB₂ + MgO sample, a much slower increase of hysteresis with decreasing temperature is observed, a signature of weaker pinning.     

Interfacial tensiometry as a novel methodology for the determination of surfactant adsorption at a liquid surface

At low surfactant concentration the loss of molecules in the bulk phase due to adsorption can be significant if the surface-area-to-bulk-volume ratio is large. This loss of molecules, however, can be used to determine the adsorption of a surfactant if the experiments are performed under well-controlled conditions. Experiments are performed with the model surfactant tridecyldimethylphosphine oxide (C13DMPO) using drop profile analysis and ring tensiometry. Taking into account the different area/volume ratios and the measured equilibrium surface tensions as a measure of the final surfactant bulk concentration, the adsorption of C13DMPO is determined.