Effect of crack tip sharpness on the strength of vulcanized rubbers

The effect of crack tip sharpness on crack propagation in vulcanized rubbers has been studied. For very sharp cracks, tearing is found to occur on a small scale at very low energies not far above the threshold required for the onset of mechanical crack growth. The “small-scale” tearing energies show relatively little variation for rubbers that differ widely in tear strength as normally measured. Thus the latter property appears to be strongly influenced by variations in the ability of rubbers to promote tip blunting. The small-scale tear behavior is of relevance to other fracture phenomena, including cutting by sharp objects and tensile failure. Natural variations in tip sharpness occur during cyclic or time-dependent mechanical crack growth and influence the form of the crack growth characteristics.     

Sample preparation for high throughput accurate mass analysis by matrix-assisted laser desorption/ionization time-of-flight mass spectrometry

An automated sample preparation for high throughput accurate mass determinations by matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOFMS) has been developed. Sample preparation was performed with an automated workstation and automated mass analyses were performed with a commercial MALDI-TOF mass spectrometer. The method was tested with a 41-sample library. MALDI-TOFMS was found to give the needed sensitivity, accurate mass measurement, and soft ionization necessary for structure confirmation, even of mixtures. A mass accuracy of 5 ppm or less was obtained in over 80% of known compound measurements. A mass accuracy better than 10 ppm was obtained for all measurements of known compounds. Analyses of parallel synthesis products resulted in 77% of the measurements with a mass accuracy of 5 ppm or better.     

The effect of the ammonium paratungstate source on the tungsten crystallite size

In an investigation into the effects of CaCl₂ on the sulfation of limestones in a laboratory furnace simulating fluidized-bed coal combustion conditions, small additions of CaCl₂ (<1 mole%) to the limestone prior to calcination were found to increase the extent of sulfation by changing the limestone pore structure. These changes were effected by trace amounts of liquid in the system in a synthetic SO₂/O₂ flue gas at 850°C. At much higher concentrations of CaCl₂, large amounts of a liquid phase are produced, containing a substantial quantity of dissolved CaO and leading to greatly enhanced sulfation when exposed to SO₂/O₂. The use of CaCl₂ additive in fluidized-bed combustion would reduce the quantity of limestones required to meet air pollution standards for SO₂ and also reduce the quantity of solid waste generated.     

Formation of microvias in epoxy-glass composites by laser ablation

Single CO₂ laser pulses, of 10.6μm wavelength, are used to form blind microvias (holes in electronic boards for through-plating conducting paths) in copper-clad epoxy-glass laminates. The microvia dimensions depend on pulse energy and duration, the thicknesses of the epoxy-glass laminate and copper cladding, and the distribution of glass within the epoxy-glass laminate. The useful range of laser parameters, especially pulse energy, is primarily determined by the ability to metallize subsequently the blind microvias. Several conclusions can be drawn from the data. The pulse enegy should be within ±20% of the optimum value in order to form vias with a cylindrical geometry. For 300 μm thick laminates, the thickness of the copper on the bottom should be 18 μm or more. A larger range of pulse energies could be used if the glass fibre density was more uniform and if subsequent copper metallization of the blind vias could be improved.     

The application of chromatography to the analysis of pharmaceutical creams

Summary The application of GLC, HPLC and TLC to the analysis of pharmaceutical creams is discussed with special attention to sample clean-up. The results of the determination of hydrocortisone acetate, salicylic acid, benzoic acid, diethyl stilbestrol, chloramphenicol, diphenhydramine HCl, tretinoin and some cream base components by reversed phase HPLC are given.Presented at the 14th International Symposium on Chromatography London, September, 1982     

Structural Diversity of Copper(I)–N‐Heterocyclic Carbene Complexes; Ligand Tuning Facilitates Isolation of the First Structurally Characterised Copper(I)–NHC Containing a Copper(I)–Alkene Interaction

The preparation of a series of imidazolium salts bearing N‐allyl substituents, and a range of substituents on the second nitrogen atom that have varying electronic and steric properties, is reported. The ligands have been coordinated to a copper(I) centre and the resulting copper(I)–NHC (NHC=N‐heterocyclic carbene) complexes have been thoroughly examined, both in solution and in the solid‐state. The solid‐state structures are highly diverse and exhibit a range of unusual geometries and cuprophilic interactions. The first structurally characterised copper(I)–NHC complex containing a copper(I)–alkene interaction is reported. An N‐pyridyl substituent, which forms a dative bond with the copper(I) centre, stabilises an interaction between the metal centre and the allyl substituent of a neighbouring ligand, to form a 1D coordination polymer. The stabilisation is attributed to the pyridyl substituent increasing the electron density at the copper(I) centre, and thus enhancing the metal(d)‐to‐alkene(π*) back‐bonding. In addition, components other than charge transfer appear to have a role in copper(I)–alkene stabilisation because further increases in the Lewis basicity of the ligand disfavours copper(I)–alkene binding.     

Letter: Invariants of the Kerr Vacuum

The Kerr vacuum has two independent invariants derivable from the Riemann tensor without differentiation. Both of these invariants must be examined in order to avoid an erroneous conclusion that the ring singularity of this spacetime is directional.     

A problem concerning infinite graphs

We show that there are graphs G and H which satisfy: (I) for every integer n, H contains n disjoint graphs each isomorphic to G, and (II) H does not contain infinitely many disjoint graphs each isomorphic to G. This answers one of the questions raised by Halin in the Graph Theory Newsletter.