Band bending at the Si(1 1 1)–SiO2 interface induced by low-energy ion bombardment

Experiments employing photoreflectance spectroscopy have uncovered band bending due to electrically active defects at the Si(1 1 1)–SiO₂ interface after sub-keV Ar⁺ ion bombardment. The band bending of about 0.5 eV resembles that for Si(1 0 0)–SiO₂, and both interfaces exhibit two kinetic regimes for the evolution of band bending upon annealing due to defects healing. The healing takes place about an order of magnitude more quickly at the (1 1 1) interface, however, probably because of less fully saturated bonding and higher compressive stress.     

Green chemical synthesis of fluorinated 1,3,5-triaryl-s-triazines in aqueous medium under microwaves as potential antifungal agents

Reasonable pure fluorinated s-triazines were synthesized in quantitative yield (96-99%) in 2-3 min in aqueous medium under microwaves, by reaction of fluorinated anilines and aqueous formaldehyde. All synthesized compounds have been screened in vitro for their antifungal activity against Rhizoctonia solani, Fusarium oxysporum, and Collectotrichum capsici.     

Stereospecific adduct ion formation in the chemical ionization mass spectra of E- and Z-1,2,3-triaryl-2-propen-1-ones

Stereospecific adduct ion formation has been observed in the chemical ionization mass spectra (positive and negative) of certain E- and Z-1,2,3-triaryl-2-propen-1-ones. The Z isomers are found to give higher relative abundances of adduct ions than the E isomers. This has been interpreted in terms of the differences in the proton affinities of the isomers originating from their different degrees of enone resonance. Halide ion (CI^? and Br^?) attachment spectra of these compounds also show stereochemical differences in the relative abundances of [M]^?˙ and [M+halide]^? ions, though the effect is not as pronounced as in the case of the positive ion spectra.     

Microwave assisted green chemical synthesis of novel spiro[indole-pyrido thiazines]: a system reluctant to be formed under thermal conditions

Spiro [3H-indole-3,2′-[4H] pyrido [3,2-e]-1,3-thiazine]-2,4′ (1H) diones, a class of previously unknown compound which does not form under conventional conditions, can be prepared by treatment of ‘in situ’ generated 3-indolylimine derivatives with 2-mercaptonicotinic acid under microwave irradiation in absence of any solvent or solid support in 85-92% yields in 3-8 min. The facile one pot reaction is generalized for a variety of ketones and amines to give pure pyrido [3,2-e] thiazine derivatives, which do not require further purification processes.     

Specific determination of cysteine and penicillamine through cyclization to 2-thioxothiazolidine-4-carboxylic acids

A very simple and highly specific method for the determination of cysteine and penicillamine is presented. Treatment with 1,1'-thiocarbonyldiimidazole in slightly basic solutions converts cysteine rapidly and quantitatively to a very stable derivative, 2-thioxothiazolidine-4-carboxylic acid, which is not formed by thiols or amines. The cyclic derivative has a characteristic UV spectrum with a maximum at 272 nm and it can be quantified by one of two ways. (1) When only inorganic ions and common additives are present, a spectrophotometer or a plate reader capable of handling multiple samples is sufficient to estimate cysteine in the concentration range of 2-150 muM. Penicillamine is determined similarly by cyclization to 5,5-dimethyl-2-thioxothiazolidine-4-carboxylic acid. The method is also applicable to derivatives of cysteine modified only at the carboxyl group. (2) To determine cysteine in complex mixtures, a liquid chromatograph connected to a UV detector is used. The elution is rapid with well-separated peaks for the thiazolidine derivatives. The detection limit is 2 pmole of cysteine or penicillamine per injection and the detector response is linear up to 1 nmole. The usefulness of the method is demonstrated by determining cysteine and penicillamine in capsules and by measuring cysteine in a dietary supplement.     

Metabolic profile of glyburide in human liver microsomes using LC‐DAD‐Q‐TRAP‐MS/MS

The sulfonylurea urea drug glyburide (glibenclamide) is widely used for the treatment of diabetes milletus and gestational diabetes. In previous studies monohydroxylated metabolites were identified and characterized for glyburide in different species, but the metabolite owing to the loss of cyclohexyl ring was identified only in mouse. Glyburide upon incubation with hepatic microsomes resulted in 10 metabolites for human. The current study identifies new metabolites of glyburide along with the hydroxylated metabolites that were reported earlier. The newly identified drug metabolites are dihydroxylated metabolites, a metabolite owing to the loss of cyclohexyl ring and one owing to hydroxylation with dehydrogenation. Among the 10 identified metabolites, there were six monohydroxylated metabolites, one dihydroxylated metabolite, two metabolites owing to hydroxylation and dehydrogenation, and one metabolite owing to the loss of cyclohexyl ring. New metabolites of glyburide were identified and characterized using liquid chromatography–diode array detector–quadruple‐ion trap–mass spectrometry/mass spectrometry (LC‐DAD‐Q‐TRAP‐MS/MS). An enhanced mass scan–enhanced product ion scan with information‐dependent acquisition mode in a Q‐TRAP‐MS/MS system was used to characterize the metabolites. Liquid chromatography with diode array detection was used as a complimentary technique to confirm and identify the metabolites. Metabolites formed in higher amounts were detected in both diode array detection and mass spectrometry detection. Copyright © 2012 John Wiley & Sons, Ltd.     

Transition-Metal-Free Reverse Reactivity of (2-Alkynyl)-Arylaldimines: Assembly of Functionalized Amino-Indinones

Transition-metal-free regioselective synthesis of functionalized amino-indenones by the reaction of ortho-alkynylaldehydes with a broad range of primary amines by intramolecular cyclization has been described. The designed reaction proceeds through KOH-mediated Prins-type cyclization and DMSO-promoted oxidation of the cyclopent-2-en-1-one system. The proposed mechanism and role of solvent were well supported by control experiments. For the first time, we have disclosed the reverse reactivity of (2-alkynyl)-arylaldimines in a super basic system.     

Cost Optimization Technique for Quantum Circuits

In this paper, an attempt is made to present a method of quantum cost minimization or optimization technique for quantum reversible circuits using proposed merger rules in Exclusive Sum of Product (ESOP) method. These modified ESOP methods are used to minimize the quantum circuits. We found that the quantum cost is drastically decreased than the previous ESOP method. It will be easy to find the quantum cost and quantum gate optimized quantum circuits implementation. It will also reduce quantum error while the quantum circuit is executed in real quantum processor.

     

Imparting Multifunctionality by Utilizing Biporosity in a Zirconium‐Based Metal–Organic Framework

In this work, we have synthesized nanocomposites made up of a metal–organic framework (MOF) and conducting polymers by polymerization of specialty monomers such as pyrrole (Py) and 3,4‐ethylenedioxythiophene (EDOT) in the voids of a stable and biporous Zr‐based MOF ( UiO‐66 ). FTIR and Raman data confirmed the presence of polypyrrole ( PPy ) and poly3,4‐ethylenedioxythiophene ( PEDOT ) in UiO‐66‐PPy and UiO‐66‐PEDOT nanocomposites, respectively, and PXRD data revealed successful retention of the structure of the MOF. HRTEM images showed successful incorporation of polymer fibers inside the voids of the framework. Owing to the intrinsic biporosity of UiO‐66 , polymer chains were observed to selectively occupy only one of the voids. This resulted in a remarkable enhancement (million‐fold) of the electrical conductivity while the nanocomposites retain 60–70 % of the porosity of the original MOF. These semiconducting yet significantly porous MOF nanocomposite systems exhibited ultralow thermal conductivity. Enhanced electrical conductivity with lowered thermal conductivity could qualify such MOF nanocomposites for thermoelectric applications.