Determination of generalized quadrangles with distinct elation points

In this paper, we classify the finite generalized quadrangles of order (s,t), s,t > 1, which have a line L of elation points, with the additional property that there is a line M not meeting L for which {L, M} is regular. This is a first fundamental step towards the classification of those generalized quadrangles having a line of elation points. Mathematics Subject Classification (2000): 51E12, 51E20, 20B25, 20E42     

Some aspects of the interactions of orthopositronium with perfect and defect surfaces of insulating materials

ETLA (Elastic Thermalisation Lifetime Analysis) is a new model function for the fitting of lifetime spectra of slowly thermalising orthopositronium in the free space between the grains of insulating oxide powders. From this model one can obtain three fundamental parameters; the mass of the cluster of atoms which scatters the o-Ps, the probability that the o-Ps is forced into two-quantum decay at each collision and the emission energyE(0) of the o-Ps from the powder surface. As a consequence of full thermalisation of the Ps it is shown that the o-Ps quenching constant _q () follows atT ^1/2 dependency for MgO, Al₂O₃ and SiO₂ and for temperatures between 77 and 500 K. In MgO powder at low temperatures the irradiation by the positrons induces surface paramagnetic defects which are identified as Mg⁺ sites. These surface defects do not affect the thermalisation, but they induce paramagnetic o-p conversion i.e., an increase in , and they are also responsible for an increase in the emission energyE(0) of the o-Ps.     

Synthesis and absolute configuration of (1S,8S)-as-hydrindacene-1,8-diol as determined by the circular dichroism exciton chirality method

2,3,6,7-Tetrahydro-as-indacene-1,8-dione 4 was prepared in 4 steps starting from 2-methyl-furan by modification of a literature procedure. Appliance of Noyori’s asymmetric transfer hydrogenation, resulted in (1S,8S)-1,2,3,6,7,8-hexahydro-as-indacene-1,8-diol 5 in high yield (81%) and excellent enantioselectivity (>99% ee) or (8S)-8-hydroxy-3,6,7,8-tetrahydro-2H-as-indacen-1-one 6 in moderate yield (58%) and equally high enantioselectivity (98.5% ee), depending on the conditions. The asymmetric reduction was expected to yield the (S)-alcohols using the (S,S)-Ts-DPEN ligand, which was confirmed by the appliance of the exciton chirality method on the corresponding bis(p-dimethylamino)benzoate 7.     

Evaluation of process parameters of ultrasonic treatment of bacterial suspensions in a pilot scale water disinfection system

In this study, several process parameters that may contribute to the efficiency of ultrasound disinfection are examined on a pilot scale water disinfection system that mimics realistic circumstances as encountered in an industrial environment. The main parameters of sonication are: (i) power; (ii) duration of treatment; (iii) volume of the treated sample. The specific energy (E_s) is an indicator of the intensity of the ultrasound treatment because it incorporates the transferred power, the duration of sonication and the treated volume. In this study, the importance of this parameter for the disinfection efficiency was assessed through changes in volume of treated water, water flow rate and electrical power of the ultrasonic reactor. In addition, the influences of the initial bacterial concentration on the disinfection efficiency were examined. The disinfection efficiency of the ultrasonic technique was scored on a homogenous and on a mixed bacterial culture suspended in water with two different types of ultrasonic reactors (Telsonic and Bandelin). This study demonstrates that specific energy, treatment time of water with ultrasound and number of passages through the ultrasonic reactor are crucial influential parameters of ultrasonic disinfection of contaminated water in a pilot scale water disinfection system. The promising results obtained in this study on a pilot scale water disinfection system indicate the possible application of ultrasound technology to reduce bacterial contamination in recirculating process water to an acceptable low level. However, the energy demand of the ultrasound equipment is rather high and therefore it may be advantageous to apply ultrasound in combination with another treatment.     

Properties of levels in22Ne

Levels up to 9.3 MeV excitation in²²Ne were studied with the¹⁹ F(α, pγ) ²²Ne reaction atE _α = 12 MeV. Level energies, branching ratios, mean lifetimes, spins and mixing ratios were obtained for a number of levels. Relevant results are compared with many-particle shell-model calculations.     

Dual energy time reversed elastic wave propagation and nonlinear signal processing for localisation and depth-profiling of near-surface defects: a simulation study

Nonlinear Elastic Wave Spectroscopy (NEWS) relies on the activation of defects by wave energy that propagates through the medium. In general, the response of activated defects will not scale linearly with the excitation amplitude, and the resulting nonlinear signatures can be identified and used for quality inspection. The efficiency of NEWS based inspection methods is therefore intrinsically linked to the locally deposited activation energy at the defect zone and the ability to generate nonlinear signatures that exceed the noise level of acquisition. Time Reversal techniques allow focusing of high levels of energy in small areas, and are consequently very useful for the local activation of defected zones. In this report, numerical simulations are reported showing the potential of a combination consisting of dual energy reciprocal Time Reversal and nonlinearity filtering using the Scaling Subtraction Method. The method is applied to the detection of planar near-surface defects parallel to the surface in a 2D domain. The results are evaluated for sweep excitation at different frequency ranges; for point-like receiver as well as extended transducers, and for in-plane as well as out-of-plane focusing. The observable nonlinear response at the surface is linked to an effective nonlinearity within the medium based on the defect geometry and the distribution of the local stresses.     

Compact fibre-laser-pumped Ho:YLF oscillator–amplifier system

We developed a compact Ho:YLF oscillator–amplifier system in a novel setup to utilise the unpolarised pump power from a fibre laser efficiently, and produced 21.3 mJ at 1 kHz, with an M ² better than 1.1. The amplified energies agreed well with the predicted values from a two dimensional rotational symmetric amplifier model that we developed. The model considers upconversion losses and ground-state depletion, as well as the spatial distribution of the pump beam.     

Annealing study of He-irradiated Ni samples

Positron annihilation lifetime measurements were performed in helium-irradiated Ni foils for annealing temperatures between 300 K and 1400 K. The samples were also examined by T.E.M. It is shown that immediately after the irradiations two kinds of vacancy clusters are present, some of them containing He-ions and the others being empty. The empty vacancy clusters anneal out before 800 K, while the vacancy clusters containing He grow in size as a function of annealing temperature.     

Three-level phase modulator based on orthoconic antiferroelectric liquid crystals

Surface-stabilized orthoconic antiferroelectric liquid crystals (OAFLCs) have a director tilt of theta = 45 degrees and are, with no field applied, negatively uniaxial with the optic axis perpendicular to the cell substrates. We demonstrate that OAFLCs can be utilized to achieve lossless phase modulation with three almost equidistant phase levels. This turns out to be true also for polymer-stabilized OAFLCs, where the polymer network increases the switching speed of the device without affecting the phase modulation appreciably.     

Analysis of several subcycling schemes in partitioned simulations of a strongly coupled fluid-structure interaction

Fluid-structure interaction (FSI) simulations are used extensively to calculate the vibration of structures subjected to an internal or external flow. In the case of partitioned FSI simulations, separate flow and structure solvers are used, which requires some kind of coupling between both. The time step in both solvers is typically taken the same, but this unnecessarily leads to long calculation times when the time step is small due to stability reasons in one of the two solvers. Subcycling, the procedure where the time step of one solver is chosen smaller than the time step used in the other solver, may reduce the computational cost of the FSI simulation. The subcycling procedure can be either explicit or implicit, the latter implying the use of coupling iterations in each time step. Contrary to explicit subcycling, no stability analyses of implicit subcycling schemes are found in the literature. In this paper, the temporal stability of the implicit subcycling procedure is investigated. The one-dimensional flow in an elastic cylindrical tube is studied analytically. The results of this analysis are subsequently compared to a partitioned two-dimensional axisymmetric FSI calculation with implicit coupling between the flow and structure solvers.