Polyesterification of aromatic dicarboxylic acids and bisphenols with tosyl chloride/dimethylformamide/pyridine promoted by the improvement of the difficult solubility of the activated diacids with lithium chloride

The solution polyesterification of dicarboxylic acids in pyridine, the activated intermediates of which were difficult to dissolve in tosyl chloride/dimethylformamide/pyridine, was investigated in the presence of lithium chloride. The solubility of the activated dicarboxylic acids was largely improved by the presence of the salt, and the polycondensation with bisphenols was greatly facilitated. The salt was more effectively added to a pyridine solution of dicarboxylic acids than to the activated dicarboxylic acids in pyridine. The favorable additive effect on the improved solubility was attributed to a lowered degree of association of the activated dicarboxylic acids, which led to distributions of the resulting oligomers from bisphenols at an earlier stage closer to the theoretical ones and yielded better polycondensation results. The reaction, which proceeded through favorable distributions of the co‐oligomers, produced copolymers of higher inherent viscosities and slightly block sequence distributions determined by NMR. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 2725–2733, 2004     

Site-directed 13C solid-state NMR studies on membrane proteins: strategy and goals toward revealing conformation and dynamics as illustrated for bacteriorhodopsin labeled with [1-13C]amino acid residues

We have so far demonstrated that well-resolved and site-specifically assigned (13)C peaks as recorded by site-directed NMR study on (13)C-labeled membrane proteins can serve as a convenient probe to reveal their local conformation and dynamics. We attempted here to clarify the extent to which (13)C NMR spectra of (13)C-labeled fully hydrated bacteriorhodopsin (bR) as a typical membrane protein are visible or well resolved in the presence of inherent fluctuation motions with frequency of 10(2)-10(8) Hz, especially at the membrane surfaces. Accordingly, we estimated the relative proportion of (13)C NMR signals from the surface areas with and without peak suppression by the accelerated transverse relaxation effect by surface-bound Mn(2+) ions, which could be effective for residues within 8.7 angstroms of the membrane surface. It turned out that the experimental findings are consistent with the predicted amount of amino acid residues under consideration located within 8.7 angstroms of the surface for [1-(13)C]Val- and Ile-labeled bR and also [3-(13)C]Ala-bR. In contrast, (13)C NMR peaks from such surfaces area are almost completely or partially suppressed for [1-(13)C]Gly-, Ala-, Leu-, Phe- and Trp-labeled bR, as a result of plausible interference of the fluctuation frequency with frequency of magic angle spinning (10(4) Hz). We further assigned several (13)C NMR signals of [1-(13)C] Val-, Trp- and Ile-labeled bR on the basis of a variety of site-directed mutants with reference to those of the wild type. Further, we recorded the (13)C NMR of bR in lipid bilayers to search for the optimal conditions to be able to obtain signals with the highest peak intensities and spectral resolution. Backbone dynamics turn out to be essential for recording (13)C NMR spectra so as to escape from motional frequencies of the order of 10(4)-10(5) Hz, either in the direction of accelerated fluctuation or slowed motions in the direction of forming the 2D array.     

A stable silicon congener of highly strained bicyclo[3.2.0]hepta-1,3,6-triene

A silicon-containing fused bicyclic compound with a highly strained bridgehead double bond, 2,3,6,7-tetra-tert-butyl-4-(tert-butyldimethylsilyl)-5-(tert-butyldimethylsiloxy)-5-silabicyclo[3.2.0]hepta-1,3,6-triene (2), was synthesized quantitatively by the reaction of 1,2-bis-tert-butyl-4,4-bis(tert-butyldimethylsilyl)-4-silatriafulvene (3) with di-tert-butylcyclopropenone (4) at 80 degrees C. An X-ray crystallographic analysis for 2 not only confirmed a bicyclic structure having a silacyclopentadiene (silole) ring fused with a silacyclobutene ring but also the remarkable deformation around the double bonds; the sum of the bond angles around the unsaturated bridgehead carbon was 333 degrees . The strain energy of a model 5-silabicyclo[3.2.0]hepta-1,3,6-triene was calculated at the MP2/6-31+G(d,p)//B3LYP/6-31+G(d) level (30.2 kcal/mol) to be comparable to that for parent bicyclo[3.2.0]hepta-1,3,6-triene (30.7 kcal/mol). Despite the high steric strain, 2 was stable enough to be kept intact for several months in the air. The high stability is ascribed to the effective steric protection of the ring system by the bulky substituents.     

Radical ions : XXVI. Radical anions of perphenylcyclopolysilanes

Perphenylcyclopolysilanes [Si(C₆H₅)₂]_n (n = 4, 5) are reduced by potassium to radical anions. Their simple ESR spectra demonstrate, that the extra electron is confined to the inner Si_nC_2n skeleton of the uncleaved and presumably planarized cyclopolysilanes.     

The role of palladium catalyst and base in stereoselective transformations of (E)-2-chlorovinylsulfides

Stereoselective transformations of 2-chlorovinylsulfides in the presence of soluble (t-BuOK) or insoluble (solid KOH or Cs₂CO₃/18-crown-6) base and palladium catalyst (dppb)Pd(OAc)₂ have been studied. Depending on the substrate or catalytic system, the reaction leads to the formation of (E)-1,2-bis[aryl(or arylmethyl)thio]ethenes and/or (E)-1,4-bis[aryl(or arylmethyl)thio]-1-buten-3-ynes in yields of up to 93%.     

Quantitative validation of different protein precipitation methods in proteome analysis of blood platelets

For the preparation of proteins for proteome analysis, precipitation is frequently used to concentrate proteins and to remove interfering compounds. Various methods for protein precipitation are applied, which rely on different chemical principles. This study compares the changes in the protein composition of human blood platelet extracts after precipitation with ethanol (EtOH) or trichloroacetic acid (TCA). Both methods yielded the same amount of proteins from the platelet preparations. However, the EtOH-precipitated samples had to be dialyzed because of the considerable salt content. To characterize single platelet proteins, samples were analyzed by two-dimensional fluorescence differential gel electrophoresis. More than 90% of all the spots were equally present in the EtOH- and TCA-precipitated samples. However, both precipitation methods showed a smaller correlation with nonprecipitated samples (EtOH 74.9%, TCA 79.2%). Several proteins were either reduced or relatively enriched in the precipitated samples. The proteins varied randomly in molecular weight and isoelectric point. This study shows that protein precipitation leads to specific changes in the protein composition of proteomics samples. This depends more on the specific structure of the protein than on the precipitating agent used in the experiment.     

Interfacing Click Chemistry with Automated Oligonucleotide Synthesis for the Preparation of Fluorescent DNA Probes Containing Internal Xanthene and Cyanine Dyes

Double‐labeled oligonucleotide probes containing fluorophores interacting by energy‐transfer mechanisms are essential for modern bioanalysis, molecular diagnostics, and in vivo imaging techniques. Although bright xanthene and cyanine dyes are gaining increased prominence within these fields, little attention has thus far been paid to probes containing these dyes internally attached, a fact which is mainly due to the quite challenging synthesis of such oligonucleotide probes. Herein, by using 2′‐O‐propargyl uridine phosphoramidite and a series of xanthenes and cyanine azide derivatives, we have for the first time performed solid‐phase copper(I)‐catalyzed azide–alkyne cycloaddition (CuAAC) click labeling during the automated phosphoramidite oligonucleotide synthesis followed by postsynthetic click reactions in solution. We demonstrate that our novel strategy is rapid and efficient for the preparation of novel oligonucleotide probes containing internally positioned xanthene and cyanine dye pairs and thus represents a significant step forward for the preparation of advanced fluorescent oligonucleotide probes. Furthermore, we demonstrate that the novel xanthene and cyanine labeled probes display unusual and very promising photophysical properties resulting from energy‐transfer interactions between the fluorophores controlled by nucleic acid assembly. Potential benefits of using these novel fluorescent probes within, for example, molecular diagnostics and fluorescence microscopy include: Considerable Stokes shifts (40–110 nm), quenched fluorescence of single‐stranded probes accompanied by up to 7.7‐fold light‐up effect of emission upon target DNA/RNA binding, remarkable sensitivity to single‐nucleotide mismatches, generally high fluorescence brightness values (FB up to 26), and hence low limit of target detection values (LOD down to <5 nM ).     

Insights into polyether biosynthesis from analysis of the nigericin biosynthetic gene cluster in Streptomyces sp. DSM4137

Nigericin was among the first polyether ionophores to be discovered, but its biosynthesis remains obscure. The biosynthetic gene cluster for nigericin has been serendipitously cloned from Streptomyces sp. DSM4137, and deletion of this gene cluster abolished the production of both nigericin and the closely related metabolite abierixin. Detailed comparison of the nigericin biosynthetic genes with their counterparts in the biosynthetic clusters for other polyketides has prompted a significant revision of the proposed common pathway for polyether biosynthesis. In particular, we present evidence that in nigericin, nanchangmycin, and monensin, an unusual ketosynthase-like protein, KSX, transfers the initially formed linear polyketide chain to a discrete acyl carrier protein, ACPX, for oxidative cyclization. Consistent with this, deletion of either monACPX or monKSX from the monensin gene cluster effectively abolished monensin A biosynthesis.