Femtosecond intermolecular electron transfer in condensed systems

We have investigated the ultrafast intermolecular electron transfer (ET) from an electron-donating solvent (aniline (AN) or N, N-dimethylaniline (DMA)) to an excited dye molecule (oxazines (Nile blue and oxazine 1) or coumarins). A non-exponential time dependence was observed in AN and can be explained by solvent reorientation and nuclear motion of the reactants. However, in DMA, a single exponential process was observed for Nile blue (160 fs) and oxazine 1 (280 fs), which can be explained by assuming that the rate of ET is limited mainly by ultrafast nuclear motion. A clear substituent effect on intermolecular ET was observed for the 7-aminocoumarins. When the alkyl chain on the 7-amino group is extended and a hexagonal ring with the benzene moiety is formed, the rate of ET is reduced by three orders of magnitude. This effect can be explained by a change in the free energy difference of the reaction and by the vibrational motion of the amino group.     

Evaluation of the adsorption affinity of proteins to calcium hydroxyapatites by desorption and pre-adsorption methods

The adsorption affinity of bovine serum albumin (BSA) and lysozyme (LSZ) to calcium hydroxyapatite (CaHAP) was evaluated by desorption and two step adsorption methods. These experiments were carried out at 15°C in a 1×10⁻⁴ mol dm⁻³ KCl solution of pH 6.0. BSA molecules were scarcely desorbed, exhibiting an irreversible adsorption of BSA, though LSZ slightly desorbed. This result supports our previous findings that LSZ adsorbs weakly onto phosphate ions exposed on ac or bc faces of CaHAP while BSA adsorbs strongly onto positively charged sites on ac or bc faces of CaHAP. The amount of adsorbed LSZ was markedly increased by the pre-adsorption of BSA, where LSZ was adsorbed onto BSA-covered CaHAP. On the other hand, the amount of adsorbed BSA was not changed by the pre-adsorption of LSZ. In both pre-adsorption systems it was confirmed by an HPLC method that no protein molecule pre-adsorbed was desorbed after the post-adsorption procedure. Therefore, it was interpreted that the enhancement of adsorption of positively charged LSZ is induced by an electrostatic attractive force through pre-adsorption of negatively charged BSA molecules with a high coverage. However, since the coverage of LSZ onto CaHAP is considerably low, no stimulation of BSA adsorption occurred on the LSZ-covered surface. The formation of double protein adsorbed layers consisting of pre- and post-adsorbed proteins was proposed.     

Preparation and characterization of carbonated barium-calcium hydroxyapatite solid solutions

Particles of carbonated barium-calcium hydroxyapatite solid solutions (BaCaHap) with different Ba/(Ba+Ca) (X(Ba)) atomic ratios were prepared by a wet method at 100 degrees C and characterized by various means. The crystal phases and structures of the products strongly depended on the composition of the starting solution, that is, the Ba/(Ba+Ca) atomic ratio ([X(Ba)]) and H3PO4 concentration ([H3PO4]) in the solution. BaCaHap with X(Ba)0.43 could be prepared at [X(Ba)]0.7 by changing [H3PO4], but could never be obtained at [X(Ba)]=0.8-0.95 regardless of [H3PO4]. The carbonated calcium hydroxyapatite particles prepared at [X(Ba)]=0 were fine and short rod-shaped particles (ca. 14x84 nm). With increasing [X(Ba)] from 0 to 0.8, the particles obtained became large spherical agglomerates. The carbonated barium hydroxyapatite particles formed at [X(Ba)]=1 were long rod-shaped agglomerates (ca. 0.2x2 microm) of fine primary particles. The amount of CO2 adsorbed irreversibly on a series of BaCaHaps showed a minimum at (Ba+Ca)/(P+C) atomic ratio of around 1.56, which agreed well with the minimum cation/P ratio obtained for the other hydroxyapatites, as already reported.     

Control on the porosity of disk-like hematite particles prepared from a forced hydrolysis reaction using polyvinyl alcohol

The effects of polyvinyl alcohol (PVA) molecules on the porosity of disk-like hematite particles produced from the forced hydrolysis reaction using two kinds of PVA molecules with a well-defined molecular weight and a high degree of saponification (PVA-105 and PVA-124) were investigated. It is evident from TEM and field-emission scanning electron microscope (FE-SEM) measurements that a fraction of particles lost their spherical habit and acquired a disk-like shape by the addition of small amounts of both PVA molecules, though no difference in the particle size between the two PVA systems was observed. FE-SEM images of the particles revealed that the disk-like hematite particles are made up of small cluster particles with a diameter of approx. 5–10 nm. The disk-like particles produced a rather lower concentration for PVA-124 with a higher molecular weight than that for PVA-105 with a lower molecular weight. This fact was due to the large number of hydroxy groups in PVA-124 molecules than in PVA-105; hydroxy groups act as adsorption sites onto polynuclear (PN) primary particles and cause pronounced effects on the formation and structure of particles during the aggregation of PN particles. It was clarified from N₂ adsorption measurements at 77 K that the porosity of the hematite particles can be controlled from microporous to mesoporous by changing the concentrations of PVA-105 and PVA-124, as was classified into three groups, i.e., groups 1, 2, and 3. The control particles produced without PVA molecules, classified into group 1, showed type IV adsorption isotherms, and only the voids produced between spherical particles were detected as mesopores. On the other hand, the particles produced with small amounts of PVA produced micropores as classified in group 2. In this group, the particles produced uniform micropores after being outgassed at 100–200 °C. The hematite particles produced with high concentrations of PVAs were classified into group 3. In this group, the particles after being outgassed at lower temperature produced micropores with diameters between 0.6 and 2.0 nm, though the micropores in the particles changed to mesopores after outgassing at 300 °C. This mesopore formation was attributed to the elimination of the PVA-adsorbed layer by evacuation at 300 °C, i.e., the large voids residing in the disk-like hematite particles make the particles mesoporous. This mesopore formation was further confirmed by adsorption experiments of C₆H₆(benzene) and CCl₄ molecules at 298 K.     

Selective decomposition of proteins by photocatalytic Ti(IV)-doped calcium hydroxyapatite particles from mixed-protein systems

The decomposition of protein molecules from a mixed-protein solution on the surface of calcium hydroxyapatite (CaHap) and Ti(IV)-doped CaHap (TiHap) particles with a Ti/(Ca + Ti) atomic ratio (X _Ti) of 0.10 and 0.20 under UV irradiation of 365 nm in wavelength was investigated. Acidic bovine serum albumin (BSA) and basic lysozyme (LSZ) were employed as a model of pathogenic proteins. The photocatalytic activities of TiHap particles were estimated from the decomposition of BSA and LSZ from the BSA (2.5 mg/cm³)–LSZ(1.0 mg/cm³) mixture under 1 mW/cm² UV irradiation dispersed in a 10-mL quartz tube. No change in BSA concentration by UV irradiation was observed for all the unheated original CaHap and TiHap particles without and with low photocatalytic activities, respectively. Similar results were observed for the systems that employed heat-treated particles endowed a high photocatalytic activity by heat treatment at 650 °C for 1 h. On the other hand, a selective photocatalytic decomposition was observed for the LSZ, i.e., only LSZ molecules were decomposed completely from the BSA (2.5 mg/cm³)–LSZ(1.0 mg/cm³) mixture by using heat-treated TiHap particles with X _Ti?=?0.10 and 0.20. This selective decomposition by TiHap particles was interpreted by higher adsorption affinity of positively charged LSZ to highly negatively charged TiHap together with low molecular weight and rigid structure of LSZ molecules.     

Preparation and microstructural studies on hydrothermally prepared hematite

A 0.1 M FeCl3 aqueous solution was hydrothermally treated in a 1.5-dm3 stainless steel autoclave at varied temperatures (Th: 110-200 degrees C). Highly ordered cubic particles with uniform micropores 0.8 nm in diameter are produced at Th = 115 degrees C, although the cubic particles become less uniform with wide pore size distribution by raising the Th.     

Effects of Pluronics surfactants on morphology and porosity of hematite particles produced from forced hydrolysis reaction

The shape and porosity of hematite particles, produced from a forced hydrolysis reaction of acidic FeCl₃ solution, were controlled by using Pluronics as nonionic surfactants (0–4 wt.%). Pluronics possess a nominal formula of (PEO) _x –(PPO) _y –(PEO) _x . The effect of Pluronics with low hydrophilicity (PEO contents were less than 50 mol%) was small and provided spherical particles the same as that of the system without Pluronics (control system). However, Pluronics with higher hydrophilicity (PEO contents were over 50 mol%) gave ellipsoidal hematite particles. This effect on the particle morphology was enhanced by an increase in their molecular weight. On the other hand, the Pluronics possessing an opposite nominal formula [(PPO) _x –(PEO) _y –(PPO) _x ] exhibited no effect on the particle shape; it only depressed phase transformation from ?-FeOOH to hematite. Not only the morphology but also the pore size of hematite particles was controlled from nonporous to mesoporous by using Pluronics. The N₂ adsorption experiment and t-plot curve analysis revealed that the hematite particles changed from mesoporous to microporous by an increase in the concentration of Pluronics. On the other hand, in the presence of very low amounts of Pluronics molecules (0.1 wt.%), nonporous hematite particles were produced via strong aggregation of PN particles by their hydrogen bonding between hydroxyl and PEO or PPO groups. The dynamic light scattering measurement for the system with Pluronics clarified the existence of polynuclear (PN) particles with a hydrodynamic particle diameter (D _a) of ca. 40 nm after these were aged for 6 h. The size of PN particles remained constant at ca. 40 nm during aging time of 12 h～3 days, but the scattering intensity was decreased. This decrease in the scattering intensity reveals that the number of PN particles is reduced by aggregation. The transmission electron microscope, inductively coupled plasma atomic emission spectroscopy, and total organic carbon analysis measurements employed on the systems produced for ellipsoidal particles elucidated that the formation of ellipsoidal hematite particles is attributed to the adsorption of Pluronics on the surfaces of PN and growing hematite particles.     

Sodium or lithium ion-binding-induced structural changes in the K-ring of V-ATPase from Enterococcus hirae revealed by ATR-FTIR spectroscopy

V-ATPase from Enterococcus hirae forms a large supramolecular protein complex (total molecular weight ～700,000) and physiologically transports Na(+) and Li(+) across a hydrophobic lipid bilayer. Stabilization of these cations in the binding site has been discussed on the basis of X-ray crystal structures of a membrane-embedded domain, the K-ring (Na(+)- and Li(+)-bound forms). Here, sodium or lithium ion-binding-induced difference IR spectra of the intact V-ATPase have for the first time been measured at physiological temperature under a sufficient amount of hydration. The results suggest that sodium or lithium ion binding induces the deprotonation of Glu139, a hydrogen-bonding change in the tyrosine residue, and a small conformational change in the K-ring. These structural changes, especially the deprotonation of Glu139, are considered to be important for reducing energetic barriers to the transport of cations through the membrane.