Crosslinking network of bio‐based bis‐functional epoxides derived from trans‐limonene oxide

The thiol‐ene reaction between trans‐limonene oxide (trans‐LO) and ethane‐1,2‐dithiol in the presence of triethylborane affords a bio‐based bis‐functional epoxide (bis‐trans‐LO). The crosslinking reaction of bis‐trans‐LO with branched polyethyleneimine (BPEI; M_n = 600; BPEI₆₀₀) at a feed ratio of bis‐trans‐LO/BPEI₆₀₀ = 57/43 (wt/wt) yields the corresponding network polymer with T_d10 (10% thermal decomposition temperature) of 304.7 °C in 98% yield. In contrast, negligible amounts of network polymer are obtained by the reaction of bis‐LO (bis‐functional epoxide derived from cis and trans‐LO) and BPEI₆₀₀ regardless of the feed ratio. The mechanical strengths as measured by direct tensile tests of the network polymers derived from bis‐trans‐LO and BPEI_600,1800 (M_n = 600 and 1800) were approximately 16 and 11 times higher than that of bis‐LO and BPEI₁₈₀₀, respectively. The tensile shear strengths of the metal‐to‐metal adhesive bonds induced by bis‐trans‐LO and BPEI_600,1800 were 9.5 and 14.1 MPa, respectively. DMA revealed that the storage modulus of the network polymer derived from bis‐trans‐LO and BPEI₁₈₀₀ in the rubber region was higher than that of the material prepared from bis‐LO and BPEI₁₈₀₀, indicating higher crosslink density of the bis‐trans‐LO/BPEI₁₈₀₀ system. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2019 , 57, 2466–2473     

双奇核188Au的准粒子带结构研究

利用在束γ谱学实验技术, 通过¹⁷³Yb(¹⁹F,4nγ)反应 布居了¹⁸⁸Au的高自旋态, 并对其准粒子带结构进行了研究. 基于实验测量结果, 对原有的双奇核¹⁸⁸Au能级纲图做了较大的修改. 通过系统性比较, 对15⁺以上的能级结构进行了讨论.     

Electrical properties and memory effect in the field effect transistor based on organic ferroelectric insulator and pentacene

We have fabricated a field effect transistor (FET) based on an organic ferroelectric insulator and molecular conductor, and investigated the electrical properties and memory effects on the PEN-FET. We have observed a drastic change in the drain current at around the coercive electric fieldE _c of the organic ferroelectric insulator in not only a FET (PEN-FET) based on a pentacene (PEN) film but also a FET (IPEN-FET) based on an iodine doped PEN film. The magnitude of the change of the drain current for the IPEN-FET is 200 times larger than that for the PEN-FET. It is expected from these results that the PEN-FET (especially the IPEN-FET) is an improvement in such devices, since it operates at a low gate electric field accompanied by the appearance of the spontaneous polarization in the organic ferroelectric insulator. In addition, we have found that the drain current for the PEN-FET does not return to the initial drain current ofE _G =0 V/cm for more than one week, even if the gate electric field is changed to 0 V/cm from 500 V/cm(>E _c ). From these results, it is suggested that the PEN-FET becomes a memory device.     

Fluorescence labeling of oligosaccharides useful in the determination of molecular interactions.

A simple method to label oligosaccharides with a multifunctional fluorescent group was developed. Oligosaccharides were quantitatively labeled at their reducing termini with pyrene butanoic acid hydrazide. The pyrene-labeled oligosaccharides were successfully applied to fluorescence polarization measurements and ELISA at picomole quantity, which was not previously reached by other procedures. This labeling method should prove to be useful in a variety of aspects in glycobiology.     

Unsaturated bond existing in tetrafluoroethylene-propylene-vinylidene fluoride terpolymer

Infrared and nuclear magnetic resonance (NMR) spectroscopies have been applied for quantitative comparison on unsaturated bonds in tetrafluoroethylene (TFE)-propylene (P)-vinylidene fluoride (VdF) terpolymers. These spectroscopies have led to consistent results while they are based on completely different principles. It is shown that the absolute concentration can be evaluated from NMR measurements. The behavior of unsaturation has been discussed in terms of after-treatment such as wet and dry treatments. The result obtained here can give the important information to improve the performance of fluoroelastomer based on TFE-P-VdF terpolymers.     

Cluster and periodic DFT calculations of adsorption and activation of CO2 on the Cu(hkl) surfaces

The adsorption behavior and thermal activation of carbon dioxide on the Cu(1 1 1), Cu(1 0 0), and Cu(1 1 0) surfaces have been investigated by means of density functional theory calculations and cluster models and periodic slabs. According to the cluster models, the optimized results indicate that the basis set of C and O atoms has a distinct effect on the adsorption energy, but an indistinct one on the equilibrium geometry. For the CO₂/Cu(hkl) adsorption systems studied here, the final structure of adsorbed CO₂ is near linear and the preferred modes for the adsorption of CO₂ onto the Cu(1 1 1), Cu(1 0 0), and Cu(1 1 0) surfaces are the side-on adsorption at the cross bridge site with an adsorption energy of 13.06 kJ/mol, the side-on adsorption at the short bridge site (13.54 kJ/mol), and the end-on adsorption on the on-top site with C–O bonds located along the short bridge site (26.01 kJ/mol), respectively. However, the calculated adsorption energies from periodic slabs are lower as compared to the experimental data as well as the cluster model data, indicating that the periodic slab approach of generalized gradient approximation in the density function theory may be not suitable to obtain quantitative information on the interaction of CO₂ with Cu(hkl) surfaces.     

Mass spectrometric analysis of low molecular mass polyesters by laser desorption/ionization on porous silicon

A low molecular mass polyester was analyzed by desorption/ionization on porous silicon (DIOS) mass spectrometry. The results were compared with those of matrix-assisted laser desorption ionization (MALDI) mass spectrometry using matrixes of alpha-cyano-4-hydroxycinnamic acid (CHCA) and 10,15,20-tetrakis(pentafluorophenyl)porphyrin (F20TPP). The CHCA matrix was not suitable for characterization of low molecular mass components of the polyester because the matrix-related ions interfered with the component ions. On the other hand, the F20TPP matrix showed no interference because no matrix-related ions appeared below m/z 822. However, the solvent selection for determining optimal conditions of sample preparation was limited, because F20TPP does not dissolve readily in any of the available organic solvents. In the DIOS spectra, the polymer ions were observed at high sensitivity without a contaminating ion. No matrix is needed for DIOS spectra of low molecular mass polyesters, facilitating sample preparation and selectivity of a precursor ion in post-source decay measurements.