Expanding the applicability of magnetic ionic liquids for multiclass determination in biological matrices based on dispersive liquid–liquid microextraction and HPLC with diode array detector analysis

Monitoring biological samples at trace levels of chemicals from anthropogenic actions such as pesticides, pharmaceuticals, and hormones has become a very important subject. This work describes a method for the determination of eight compounds of different chemical classes in human urine samples. Dispersive liquid–liquid microextraction based on magnetic ionic liquids was used as the sample preparation procedure. The main parameters of the method, such as sample dilution, type, and volume of disperser solvent, amount of magnetic ionic liquids, extraction time, and pH were optimized by univariate and multivariate procedures. Validation was performed using a urine sample of a male volunteer in order to obtain a calibration curve and the main analytical parameters of merit such as limits of detection and quantification. Values varied from 3.0 to 7.5 µg/L and from 10 to 25 µg/L, respectively. Satisfactory precisions of 21% for intraday (n = 3) and 16% for interday (n = 9) were achieved. Accuracy was evaluated by relative recovery assays using different urine samples and ranged from 75 to 130%. Robustness was assured by the Lenth method. The validated procedure was applied to five urine samples from different volunteers and the hormone estrone was found in one sample.     

Membrane-based microextraction techniques in analytical chemistry: A review

The use of membrane-based sample preparation techniques in analytical chemistry has gained growing attention from the scientific community since the development of miniaturized sample preparation procedures in the 1990s. The use of membranes makes the microextraction procedures more stable, allowing the determination of analytes in complex and “dirty” samples. This review describes some characteristics of classical membrane-based microextraction techniques (membrane-protected solid-phase microextraction, hollow-fiber liquid-phase microextraction and hollow-fiber renewal liquid membrane) as well as some alternative configurations (thin film and electromembrane extraction) used successfully for the determination of different analytes in a large variety of matrices, some critical points regarding each technique are highlighted.     

Anisotropic magnetic porous assemblies of oxide nanoparticles interconnected via silica bridges for catalytic application

We report the microfluidic chip-based assembly of colloidal silanol-functionalized silica nanoparticles using monodisperse water-in-oil droplets as templates. The nanoparticles are linked via silica bridges, thereby forming superstructures that range from doublets to porous spherical or rod-like micro-objects. Adding magnetite nanoparticles to the colloid generates micro-objects that can be magnetically manipulated. We functionalized such magnetic porous assemblies with horseradish peroxidase and demonstrate the catalytic binding of fluorescent dye-labeled tyramide over the complete effective surface of the superstructure. Such nanoparticle assemblies permit easy manipulation and recovery after a heterogeneous catalytic process while providing a large surface similar to that of the individual nanoparticles.     

Controlled synthesis of fluorescent silica nanoparticles inside microfluidic droplets

We study the droplet-based synthesis of fluorescent silica nanoparticles (50-350 nm size) in a microfluidic chip. Fluorescein-isothiocyanate (FITC) dye is first chemically linked to aminopropyl triethoxysilane (APTES) in ethanol and this reaction product is subsequently mixed with tetraethyl orthosilicate (TEOS) to yield a fluorescent silicon alkoxide precursor solution. The latter reacts with an aqueous ethanol-ammonia hydrolysing mixture inside droplets, forming fluorescent silica nanoparticles. The droplets are obtained by pinching-off side-by-side flowing streams of alkoxide solution/hydrolysing mixture on a microfluidic chip using a Fluorinert oil continuous phase flow. Synthesis in droplets leads to a faster reaction and allows drastically improved nanoparticle size uniformity (down to 3% relative standard deviation for 350 nm size particles) when compared to conventional bulk synthesis methods, thanks to the precise control of reagent concentrations and reaction times offered by the microfluidic format. Incorporating FITC inside silica nanoparticles using our method leads to reduced dye leakage and increases the dye's stability, as evidenced by a reduced photochemical bleaching compared to a pure FITC solution.     

Structural organization of cetyltrimethylammonium sulfate in aqueous solution: The effect of Na2SO4

We used dynamic light scattering (DLS), steady-state fluorescence, time resolved fluorescence quenching (TRFQ), tensiometry, conductimetry, and isothermal titration calorimetry (ITC) to investigate the self-assembly of the cationic surfactant cetyltrimethylammonium sulfate (CTAS) in aqueous solution, which has SO(2-)4 as divalent counterion. We obtained the critical micelle concentration (cmc), aggregation number (N(agg)), area per monomer (a0), hydrodynamic radius (R(H)), and degree of counterion dissociation (alpha) of CTAS micelles in the absence and presence of up to 1 M Na2SO4 and at temperatures of 25 and 40 degrees C. Between 0.01 and 0.3 M salt the hydrodynamic radius of CTAS micelle R(H) approximately 16 A is roughly independent on Na2SO4 concentration; below and above this concentration range R(H) increases steeply with the salt concentration, indicating micelle structure transition, from spherical to rod-like structures. R(H) increases only slightly as temperature increases from 25 to 40 degrees C, and the cmc decreases initially very steeply with Na2SO4 concentration up to about 10 mM, and thereafter it is constant. The area per surfactant at the water/air interface, a0, initially increases steeply with Na2SO4 concentration, and then decreases above ca. 10 mM. Conductimetry gives alpha = 0.18 for the degree of counterion dissociation, and N(agg) obtained by fluorescence methods increases with surfactant concentration but it is roughly independent of up to 80 mM salt. The ITC data yield cmc of 0.22 mM in water, and the calculated enthalpy change of micelle formation, Delta H(mic) = 3.8 kJ mol(-1), Gibbs free energy of micellization of surfactant molecules, Delta G(mic) = -38.0 kJ mol(-1) and entropy TDelta S(mic) = 41.7 kJ mol(-1) indicate that the formation of CTAS micelles is entropy-driven.     

Cork as a new (green) coating for solid-phase microextraction: Determination of polycyclic aromatic hydrocarbons in water samples by gas chromatography–mass spectrometry

A new fiber for solid-phase microextraction (SPME) was prepared employing cork as a coating. The morphology and composition of the cork fiber was evaluated by scanning electron microscopy (SEM) and Fourier transform infrared spectroscopy (FTIR), respectively. The proposed fiber was used for the determination of polycyclic aromatic hydrocarbons (PAHs) in river water samples by gas chromatography–selected ion monitoring–mass spectrometry (GC–SIM–MS). A central composite design was used for optimization of the variables involved in the extraction of PAHs from water samples. The optimal extraction conditions were extraction time and temperature of 60 min and 80 °C, respectively. The detection and quantification limits were 0.03 and 0.1 μg L⁻¹, respectively. The recovery values were between 70.2 and 103.2% and the RSD was ≤15.7 (n = 3). The linear range was 0.1–10 μg L⁻¹ with r ≥ 0.96 and the fiber-to-fiber reproducibility showed RSD ≤ 18.6% (n = 5). The efficiency of the cork fiber was compared with commercially available fibers and good results were achieved, demonstrating the applicability and great potential of cork as a coating for SPME.     

Synthesis and inclusion ability of a bis-β-cyclodextrin pseudo-cryptand towards Busulfan anticancer agent

The synthesis of a C₂-symmetric receptor including two β-cyclodextrins connected by urea linkers to a chiral diaza-crown ether organising platform is reported. This molecular system, long thought to be a potent selective carrier for chiral/achiral organic/inorganic guests at the supramolecular level, was found to be an efficient complexing tool towards the Busulfan anticancer agent.     

Properties of fractional operators with fixed memory length

In this present paper, we discuss some properties of fractional operators with fixed memory length (Riemann–Liouville fractional integral, Riemann–Liouville and Caputo fractional derivatives). Some observations and examples are discussed during the article, in order to make the results well defined and clear. Furthermore, we consider the fundamental theorem of calculus for fractional operators with fixed memory length.     

Composition and applications of Aloe vera leaf gel

Many of the health benefits associated with Aloe vera have been attributed to the polysaccharides contained in the gel of the leaves. These biological activities include promotion of wound healing, antifungal activity, hypoglycemic or antidiabetic effects antiinflammatory, anticancer, immunomodulatory and gastroprotective properties. While the known biological activities of A. vera will be briefly discussed, it is the aim of this review to further highlight recently discovered effects and applications of the leaf gel. These effects include the potential of whole leaf or inner fillet gel liquid preparations of A. vera to enhance the intestinal absorption and bioavailability of co-administered compounds as well as enhancement of skin permeation. In addition, important pharmaceutical applications such as the use of the dried A. vera gel powder as an excipient in sustained release pharmaceutical dosage forms will be outlined.