Comparison of yellow poplar pretreatment between NREL digester and sunds hydrolyzer

Single-stage cocurrent dilute acid pretreatments were carried out on yellow poplar (Liriodendron tulipifera) sawdust using an as-installed and short residence time modified pilot-scale Sunds hydrolyzer and a 4-L bench-scale NREL digester (steam explosion reactor). Pretreatment conditions for the Sunds hydrolyzer, installed in the NREL process development unit (PDU), which operates at 1 t/d (bone-dry t) feed rate, spanned the temperature range of 160 – 210°C, 0.1 – 1.0% (w/w) sulfuric acid, and 4-10-min residence times. The batch pretreatments of yellow poplar sawdust in the bench-scale digester were carried out at 210 and 230°C, 0.26% (w/w) sulfuric acid, and 1-, 3-, and 4-min residence times. The dilute acid prehydrolysis solubilized more than 90% of the hemicellulose, and increased the enzymatic digestibility of the cellulose that remained in the solids. Compositional analysis of the pretreated solids and liquors and mass balance data show that the two pretreatment devices had similar pretreatment performance.     

Dilute sulfuric acid pretreatment of corn stover at high solids concentrations

Applied Biochemistry and Biotechnology - The enzymatic digestibility of a pretreated substrate is enhanced by increasing the severity of the pretreatment conditions, apparently because a greater...     

Critical behavior of betaine arsenate

The critical exponents , and of undeuterated and partially deuterated ferroelectric betaine arsenate are estimated. Small but remarkable deviations from the tricritical values are observed. The obtained values are tested via scaling of the isothermals.At some distance aboveT _c a cross-over of the effective critical exponent to a value typically for short-range forces is observed. A suitably defined cross-over temperature range decreases with increasing deuteration and seems to vanish near the antiferroelectric phase boundary.     

Preliminary estimate of the cost of ethanol production for ssf technology

The Solar Energy Research Institute (SERI) recently completed a detailed engineering and economic analysis of the simultaneous saccharification and fermentation (SSF) based wood-to-ethanol process. The reference-case design was based on a plant capacity of 1920 dry t/d and a wood cost of $42/dry t. For this case, the preliminary estimate of the production cost of the ethanol product is about $1.22/gal. The combined effects of optimizing SSF enzyme loading, increasing plant capacity to 10,000 dry t/d, and reducing wood cost to $34/dry t are to reduce the preliminary estimate of the production cost to about $0.95/gal. Other technological improvements may further reduce the production cost. Certain technical assumptions, inherent in the analysis, are being investigated further.

     

Synthese und Reaktionen von Bicyclo[6.4.0]dodecan-3-carbonsäure-Derivaten

Synthesis and Reactions of the Bicyclo[6.4.0]dodecane-3-carboxylic Acid Derivatives The synthesis and some consecutive reactions of the compounds 5-8 , derivatives of bicyclo[6.4.0]dodecane-3-carboxylic acid ( 1 ), are described. The esters 7 and 8 can be obtained by Baeyer-Villiger oxidation of 2-hydroxy-8-methyltricyclo[7.3.1.0^2,7]tridecan-13-one ( 4 ) and subsequent hydrolysis of the lactone 5 . The structure and configuration of these compounds has been evaluated by spectroscopic techniques (mainly 2D-NMR methods). The formation of 7 via 1,2-H shift and subsequent isomerization to 8 has been studied. The esters 11 and 13 are formed stereospecifically from 7 and 8 .     

Influence of calcium on the self-assembly of partially hydrolyzed alpha-lactalbumin

Self-assembly of alpha-lactalbumin after partial hydrolysis by a protease from Bacillus licheniformis can result in nanotubular structures, which show many similarities to microtubules. Calcium plays a crucial role in this process. The objective of this investigation was to study the role of calcium in more detail. The kinetics of the hydrolysis step and the self-assembly step were monitored by respectively liquid chromatography-mass spectrometry and dynamic light scattering. The microstructure of the gels finally formed was investigated by transmission electron microscopy. This investigation demonstrates that calcium accelerated the kinetics of the self-assembly, but it had no effect on the hydrolysis kinetics. As a result of the accelerated self-assembly kinetics at a high calcium concentration, the time of gelation decreased as well. A minimum concentration of calcium needed to obtain the tubular alpha-lactalbumin structures was determined. Below R = 1.5 (mole calcium/mole alpha-lactalbumin), turbid gels with randomlike structure were obtained. Between R = 1.5 and R = 6, translucent gels with a fine stranded network of tubules were formed, while higher calcium concentrations had a negative effect on the tubule formation, resulting in amorphous structures. The optimum calcium concentration for alpha-lactalbumin nanotube formation seemed to be around R = 3.     

Secondary deuterium kinetic isotope effects in irreversible additions of allyl reagents to benzaldehyde

The competitive kinetics of additions of allyl to benzaldehyde-h and -d from allyltributyl tin, from diisopropyltartrylallyl boronate, and from allyl bromide and zinc dust in aqueous tetrahydrofuran have inverse secondary deuterium kinetic isotope effects, SDKIEs. These inverse SDKIEs are in contrast to the normal SDKIEs that were obtained with allyl lithium and allyl Grignard, suggesting rate-determining single-electron transfer in these cases. By various MO calculations the transition state for addition of allyl boronate occurs with substantial B-O bond formation and little C-C bond formation. The magnitudes of the SDKIEs with the other two allylating reagents, when compared with reasonable equilibrium isotope effects for the addition, suggest transition states with substantial C-C bond formation.     

Mass spectrometric analysis of ceramic components for solid oxide fuel cells

For the determination of trace impurities in ceramic components of solid oxide fuel cells (SOFCs), some mass spectrometric methods have been applied such as spark source mass spectrometry (SSMS), laser ionization mass spectrometry (LIMS), laser ablation inductively coupled plasma mass spectrometry (LA-ICP-MS) and inductively coupled plasma mass spectrometry (ICP-MS). Due to a lack of suitable standard reference materials for quantifying of analytical results on La _x Sr _y MnO₃ cathode material a matrix-matched synthetic standard-high purity initial compounds doped with trace elements-was prepared in order to determine the relative sensitivity coefficients in SSMS and LA-ICP-MS. Radiofrequency glow discharge mass spectrometry (rf-GDMS) was developed for trace analysis and depth profiling of thick non-conducting layers. Surface analytical techniques, such as secondary ion mass spectrometry (SIMS) and sputtered neutral mass spectrometry (SNMS), were used to determine the element distribution on surfaces (homogeneity) and the surface contaminants of SOFC ceramic layers.Dedicated to Professor Dr. rer. nat. Hubertus Nickel on the occasion of his 65th birthday     

Terephthalamide derivatives as mimetics of helical peptides: disruption of the Bcl-x(L)/Bak interaction

A series of Bcl-x(L)/Bak antagonists, based on a terephthalamide scaffold, was designed to mimic the alpha-helical region of the Bak peptide. These molecules showed favorable in vitro activities in disrupting the Bcl-x(L)/Bak BH3 domain complex (terephthalamides 9 and 26, K(i) = 0.78 +/- 0.07 and 1.85 +/- 0.32 microM, respectively). Extensive structure-affinity studies demonstrated a correlation between the ability of terephthalamide derivatives to disrupt Bcl-x(L)/Bak complex formation and the size of variable side chains on these molecules. Treatment of human HEK293 cells with the terephthalamide derivative 26 resulted in disruption of the Bcl-x(L)/Bax interaction in whole cells with an IC(50) of 35.0 microM. Computational docking simulations and NMR experiments suggested that the binding cleft for the BH3 domain of the Bak peptide on the surface of Bcl-x(L) is the target area for these synthetic inhibitors.