Mechanisms of ZnII-activated magnetic resonance imaging agents

We report on the mechanism of a series of Zn (II)-activated magnetic resonance contrast agents that modulate the access of water to a paramagnetic Gd (III) ion to create an increase in relaxivity upon binding of Zn (II). In the absence and presence of Zn (II), the coordination at the Gd (III) center is modulated by appended Zn (II) binding groups. These groups were systematically varied to optimize the change in coordination upon Zn (II) binding. We observe that at least one appended aminoacetate must be present as a coordinating group to bind Gd (III) and effectively inhibit access of water. At least two binding groups are required to efficiently bind Zn (II), creating an unsaturated complex and allowing access of water. (13)C isotopic labeling of the acetate binding groups for NMR spectroscopy provides evidence of a change in the metal coordination of these groups upon the addition of Zn (II) supporting our proposed mechanism of activation as presented.     

Development of EPA method 535 for the determination of chloroacetanilide and other acetamide herbicide degradates in drinking water by solid-phase extraction and liquid chromatography/tandem mass spectrometry

U.S. Environmental Protection Agency (EPA) Method 535 has been developed in order to provide a method for the analysis of "Alachlor ESA and other acetanilide degradation products," which are listed on EPA's 1998 Drinking Water Contaminant Candidate List. Method 535 uses solid-phase extraction with a nonporous graphitized carbon sorbent to extract the ethane sulfonic acid (ESA) and oxanilic acid degradates of propachlor, flufenacet, dimethenamid, alachlor, acetochlor, and metolachlor from finished drinking water matrixes. Separation and quantitation of the target analytes are achieved with liquid chromatography/tandem mass spectrometry. Dimethachlor ESA and butachlor ESA were chosen during the method development as the surrogate and internal standard. Drinking water samples were dechlorinated with ammonium chloride without adversely affecting the analyte recoveries. Typical mean recoveries of 92-116% in deionized water and 89-116% in ground water were observed with relative standard deviations of <5%.     

Chiral analytical method development of liquiritigenin with application to a pharmacokinetic study

Pharmacometric characterization studies of liquiritigenin have historically overlooked its chiral nature. To achieve complete characterization, an analytical method enabling the detection and quantification of the individual enantiomers of racemic (±) liquiritigenin is necessary. Resolution of the enantiomers of liquiritigenin was achieved using a simple high‐performance liquid chromatographic method. A Chiralpak® ADRH column was employed to perform baseline separation with UV detection at 210 nm.The standard curves were linear ranging from 0.5 to 100 µg/mL for each enantiomer. Limit of quantification was 0.5 µg/mL. The assay was applied successfully to stereoselective serum disposition of liquiritigenin enantiomers in rats. Liquiritigenin enantiomers were detected in serum as both aglycones and glucuronidated conjugates. Both unconjugated enantiomers had a serum half‐life of ~15 min in rats. The volume of distribution (V_d) for S‐ and R‐liquiritigenin was 1.49 and 2.21 L/kg, respectively. Total clearance (Cl_total) was 5.12 L/h/kg for S‐liquiritigenin and 4.79 L/h/kg for R‐liquiritigenin, and area under the curve (AUC_0‐inf) was 3.95 µg h/mL for S‐liquiritigenin and 4.23 µg h/mL for R‐liquiritigenin. The large volume of distribution coupled with the short serum half‐life suggests extensive distribution of liquiritigenin into tissues. Copyright © 2012 John Wiley & Sons, Ltd.     

Chiral analytical method development and application to pre‐clinical pharmacokinetics of pinocembrin

An analytical method enabling the detection and quantification of the individual enantiomers of racemic (±) pinocembrin is required to fully characterize its pharmacokinetic disposition. Direct resolution of the enantiomers of pinocembrin was achieved using a novel and simple reversed‐phase high‐performance liquid chromatography method with electrospray ionization and detection by mass spectrometry in rat serum. A Chiralcel® AD‐RH column was employed to perform baseline separation with electrospray positive‐mode ionization with selected ion monitoring detection. The standard curves were linear from 0.5 to 100 µg/mL for each enantiomer. The limit of quantification was 0.5 µg/mL. The assay was applied successfully to stereoselective serum disposition of pinocembrin enantiomers in rats. Pinocembrin enantiomers were detected in serum. Both enantiomers had a serum half‐life of ~15 min in rats. Similar values of volume of distribution between the enantiomers were also observed: 1.76 L/kg for S‐pinocembrin and 1.79 L/kg for R‐pinocembrin. Total clearance was 5.527 L//h/kg for S‐pinocembrin and 5.535 L/h/kg for R‐pinocembrin, and the area under the curve was 1.821 µg h/mL for S‐pinocembrin and 1.876 µg h/mL for R‐pinocembrin. The large volume of distribution coupled with the short serum half‐life suggests extensive distribution of pinocembrin into the tissues. Copyright © 2012 John Wiley & Sons, Ltd.     

On the <Emphasis Type="Italic">KO</Emphasis> Characteristic Cycle of a Spin<Superscript><Emphasis Type="Italic">c</Emphasis></Superscript> Manifold

We compute the KO-characteristic numbers of a characteristic submanifold of a Spin^c manifold in terms of its K-characteristic numbers. The proof is based on the geometry of the Thom class in K-theory and is simpler than the existing proofs of several previously known special cases.     

An investigation of the chemical stability of arsenosugars in basic environments using IC-ICP-MS and IC-ESI-MS/MS

This paper evaluates the chemical stability of four arsenosugars using tetramethylammonium hydroxide (TMAOH) as an extraction solvent. This solvent was chosen because of the near quantitative removal of these arsenicals from difficult to extract seafood (oysters and shellfish). Four arsenosugars (3-[5'-deoxy-5'-(dimethylarsinoyl)-beta-ribofuranosyloxy]-2-hydroxypropylene glycol--As(328), 3-5'-deoxy-5'-(dimethylarsinoyl)-beta-ribofuranosyloxy]-2-hydroxypropanesulfonic acid--As(392), 3-[5'-deoxy-5'-(dimethylarsinoyl)-beta-ribofuranosyloxy]-2-hydroxypropyl hydrogen sulfate--As(408), and 3-[5'-deoxy-5'-(dimethylarsinoyl)-beta-ribofuranosyloxy]-2-hydroxypropyl-2,3-hydroxypropyl phosphate--As(482)) were evaluated. The stability of these four arsenosugars were studied independently in a solution of 2.5% TMAOH at 60 degrees C over a period of up to 8 h. Two arsenosugars, As(328) and As(392), were found to be relatively stable in this solution for up to 8 h. However, As(408) and As(482) formed detectable quantities of dimethylarsinic acid (DMAA) and As(328) within 0.5 and 2 h, respectively. It was found that 97% of As(408) degrades after 8 h of treatment producing 3.4 times as much DMAA as As(328). This is contrary to As(482), which produces 13 times as much As(328) as DMAA and only 37% of the As(482) was converted by the 8 h treatment at 60 degrees C. These degradation products led to the investigation of weaker TMAOH extraction solvents. Three different concentrations (2.5%, 0.83% and 0.25%) were used to determine the effect of TMAOH concentration on the degradation rate of As(408). By reducing the TMAOH concentration to 0.83%, the conversion of the arsenosugar to As(328) and DMAA is nearly eliminated (less than 5% loss). Arsenosugars, As(408) and As(482), were also studied in 253 mM NaOH to verify the degradation products. The NaOH experiments were conducted to investigate a possible hydroxide based reaction mechanism. Similar degradation plots were found for each arsenosugar when compared to the 2.5% TMAOH data. A mechanism has been proposed for the formation of As(328) from As(408) and As(482) in base via an SN2 reaction (hydroxide attack) at the side chain carbon adjacent to the inorganic ester. The formation of DMAA is observed in all arsenosugars after prolonged exposure. This probably occurs via an SN2 attack at the arsenic atom.     

A high‐performance liquid chromatographic analysis and preliminary pharmacokinetic characterization of 3′‐hydroxypterostilbene in rats

A high‐performance liquid chromatographic method was developed for the analysis of 3'‐hydroxypterostilbene. This method involves the use of a Luna^® C₁₈ column with ultraviolet detection at 325 nm. The mobile phase consisted of acetonitrile, water and formic acid (50:50:0.01, v/v/v) with a flow rate of 0.8 mL/min. The calibration curves were linear over the range 0.5–100.0 µg/mL. The mean extraction efficiency was between 97.40 and 111.16%. The precision of the assay was 0.196–14.39% (RSD%), and within 15% at the limit of quantitation (0.5 µg/mL). The bias of the assay was <16% and within 15% at the limit of quantitation. This assay was successfully applied to pre‐clinical pharmacokinetic samples from rat urine and serum. Copyright © 2009 John Wiley & Sons, Ltd.     

A Mass-Selective Variable-Temperature Drift Tube Ion Mobility-Mass Spectrometer for Temperature Dependent Ion Mobility Studies

A hybrid ion mobility-mass spectrometer (IM-MS) incorporating a variable-temperature (80–400 K) drift tube is presented. The instrument utilizes an electron ionization (EI) source for fundamental small molecule studies. Ions are transferred to the IM-MS analyzer stages through a quadrupole, which can operate in either broad transmission or mass-selective mode. Ion beam modulation for the ion mobility experiment is accomplished by an electronic shutter gate. The variable-temperature ion mobility spectrometer consists of a 30.2 cm uniform field drift tube enclosed within a thermal envelope. Subambient temperatures down to 80 K are achievable through cryogenic cooling with liquid nitrogen, while elevated temperatures can be accessed through resistive heating of the envelope. Mobility separated ions are mass analyzed by an orthogonal time-of-flight (TOF) mass spectrometer. This report describes the technological considerations for operating the instrument at variable temperature, and preliminary results are presented for IM-MS analysis of several small mass ions. Specifically, mobility separations of benzene fragment ions generated by EI are used to illustrate significantly improved (greater than 50%) ion mobility resolution at low temperatures resulting from decreased diffusional broadening. Preliminary results on the separation of long-lived electronic states of Ti⁺ formed by EI of TiCl₄ and hydration reactions of Ti⁺ with residual water are presented.     

Facile charge-displacement at silicon gives spaced-out reaction

Adsorbates on metals, but not previously on semiconductors, have been observed to display long-range repulsive interactions. On metals, due to efficient dissipation, the repulsions are weak, typically on the order of 5 meV at 10 ?. On the 7×7 reconstruction of the Si(111) surface, charge transport through the surface has been demonstrated by others using charge injection by STM tips. Here we show that for both physisorbed brominated molecules, and for chemisorbed Br-atoms, induced charge-transfer in the Si(111)-7×7 surface can lead to a strong repulsive interaction between adsorbates, calculated as 200 meV at 13.4 ?. This large repulsive interaction must be channeled through the surface since it causes widely spaced "one-per-corner-hole" patterns of physisorption (three cases--directly observed here) and subsequent chemisorption (four cases observed). The patterns were observed by ultrahigh vacuum scanning tunneling microscopy for four different brominated hydrocarbon adsorbates; 1,2-dibromoethane, 1-bromopropane, 1-bromopentane, and bromobenzene, deposited individually on the surface. In every case, adsorbates were overwhelmingly more likely to be found singly than multiply adjacent to a corner-hole, constituting a distinctive pattern having a probability p = 7 × 10(-5) compared to a random distribution.     

Investigation of self-immolative linkers in the design of hydrogen peroxide activated metalloprotein inhibitors

A series of self-immolative boronic ester protected methyl salicylates and metal-binding groups with various linking strategies have been investigated for their use in the design of matrix metalloproteinase proinhibitors.