Oxidation of cyclohexane catalyzed by metal-ion-exchanged zeolites

The ion-exchange rates and capacities of the zeolite NaY for the Cu(II), Co(II), and Pb(II) metal ions were investigated. Ion-exchange equilibria were achieved in approximately 72 h for all the metal ions. The maximum ion exchange of metal ions into the zeolite was found to be 120 mg Pb(II), 110 mg Cu(II), and 100 mg Co(II) per gram of zeolite NaY. It is observed that the exchange capacity of a zeolite varies with the exchanged metal ion and the amount of metal ions exchanged into zeolite decreases in the sequence Pb(II) > Cu(II) > Co(II). Application of the metal-ion-exchanged zeolites in oxidation of cyclohexane in liquid phase with visible light was examined and it is observed that the order of reactivity of the zeolites for the conversion of cyclohexane to cyclohexanone and cyclohexanol is CuY > CoY > PbY. It is found that conversion increases by increase of the empty active sites of a zeolite and the formation of cyclohexanol is favored initially, but the cyclohexanol is subsequently converted to cyclohexanone.     

Two new isoflavanoids from the rhizomes of Iris soforana

Two new isoflavones 1 and 2 along with eleven known compounds 3-13, have been isolated for the first time from the rhizomes of Iris soforana. The structures of these compounds were determined on the basis of spectroscopic methods and found to be 5,3'-dihydroxy-4'-methoxy-6,7-methylenedioxyisoflavone (1) (Soforanarin A), and 5,7,5'-trimethoxy-6,3',4'-trihydroxyisoflavone (2) (Soforanarin B).     

Preparation of calix[4]arene-based sporopollenin and examination of its dichromate sorption ability

The present study describes the preparation of a new calix[4]arene-based sporopollenin material and its application for the removal of Na₂Cr₂O₇ from aqueous solution. The novel calix[4]arene-based sporopollenin material was prepared via the immobilization of dihydrazine amide derivative of p-tert-butylcalix[4]arene (3) onto the modified sporopollenin. The newly prepared calix[4]arene-based sporopollenin is characterized by using different analytical techniques such as FT-IR spectroscopy, scanning electron microscope and Elemental analysis. The batch wise sorption study was carried out to optimize various experimental parameters such as the effect of sorbent dosage, pH, temperature and Cr(VI) anion concentration. It has been found that the sorption of Cr(VI) anion on calix[4]arene-based sporopollenin was highly pH dependent and maximum sorption was achieved at pH 1.5. The sorption behavior was also evaluated by Langmuir, Freundlich and Dubinin Radushkevich isotherms. The value of correlation coefficient (R ²) showed a good agreement with Freundlich isotherm model. Result of study demonstrated that calix[4]arene-based sporopollenin proved to be highly effective for the removal of Cr(VI).     

Isoflavonoid glycosides from the rhizomes of Iris germanica

Four isoflavone glycosides were isolated from the rhizomes of Iris germanica. Compounds 1 and 2 are new, while compounds 3 and 4 are known isoflavone glycosides. These compounds were identified as iriskashmirianin 4'-O-beta-D-glucoside (1), nigricin 4'-O-beta-D-glucoside (2), irilone 4'-O-beta-D-glucoside (3) and iridin (4). Their structures were determined with the help of spectroscopic methods.     

Weakly non-linear waves in a tapered elastic tube filled with an inviscid fluid

In the present work, treating the artery as a tapered, thin walled, long and circularly conical prestressed elastic tube and using the longwave approximation, we have studied the propagation of weakly non-linear waves in such a fluid-filled elastic tube by employing the reductive perturbation method. By considering the blood as an incompressible inviscid fluid, the evolution equation is obtained as the Korteweg-de Vries equation with a variable coefficient. It is shown that this type of equation admits a solitary wave-type solution with variable wave speed. It is observed that, the wave speed decreases with distance for positive tapering while it increases for negative tapering. It is further observed that, the progressive wave profile for expanding tubes (a>0) becomes more steepened whereas for narrowing tubes (a<0) it becomes more flattened.     

Vibrational spectroscopic studies and ab initio calculations of 5-methyl-2-(p-methylaminophenyl)benzoxazole

FT-IR spectra of 5-methyl-2-(p-methylaminophenyl)benzoxazole was recorded and analysed. The vibrational frequencies of the compound have been computed using the Hartree-Fock/6-31G* basis and compared with the experimental values.     

Existence of Positive Solutions for Nonlinear Second-Order Impulsive Boundary Value Problems on Time Scales

This paper is concerned with the existence of positive solutions of second-order impulsive boundary value problem with integral boundary conditions on time scales. Existence results of at least three positive solutions are established via a new fixed point theorem in a cone. Also, an example is given to illustrate the effectiveness of our result.     

IR, Raman and SERS spectra of 2-phenoxymethylbenzothiazole

The FT-IR and FT-Raman spectra of 2-phenoxymethylbenzothiazole were recorded and analyzed. The surface enhanced Raman scattering (SERS) spectrum was recorded in a silver colloid. The vibrational wavenumbers of the compound have been computed using the Hartree–Fock/6-31G* basis and compared with the experimental values. The appearance of the Ag–O stretching mode at 237 cm⁻¹ in the SERS spectrum along with theoretically calculated atomic charge density, leads us to suggest that the molecule is adsorbed through the oxygen atom with the molecular plane tilted on the colloidal silver surface. The direction of charge transfer contribution to SERS has been discussed from the frontier orbital theory.     

New benchmark for water photooxidation by nanostructured alpha-Fe2O3 films

Thin films of silicon-doped Fe2O3 were deposited by APCVD (atmospheric pressure chemical vapor deposition) from Fe(CO)5 and TEOS (tetraethoxysilane) on SnO2-coated glass at 415 degrees C. HRSEM reveals a highly developed dendritic nanostructure of 500 nm thickness having a feature size of only 10-20 nm at the surface. Real surface area determination by dye adsorption yields a roughness factor of 21. XRD shows the films to be pure hematite with strong preferential orientation of the [110] axis vertical to the substrate, induced by silicon doping. Under illumination in 1 M NaOH, water is oxidized at the Fe2O3 electrode with higher efficiency (IPCE = 42% at 370 nm and 2.2 mA/cm2 in AM 1.5 G sunlight of 1000 W/m2 at 1.23 VRHE) than at the best reported single crystalline Fe2O3 electrodes. This unprecedented efficiency is in part attributed to the dendritic nanostructure which minimizes the distance photogenerated holes have to diffuse to reach the Fe2O3/electrolyte interface while still allowing efficient light absorption. Part of the gain in efficiency is obtained by depositing a thin insulating SiO2 interfacial layer between the SnO2 substrate and the Fe2O3 film and a catalytic cobalt monolayer on the Fe2O3 surface. A mechanistic model for water photooxidation is presented, involving stepwise accumulation of four holes by two vicinal iron or cobalt surface sites.     

Translucent thin film Fe2O3 photoanodes for efficient water splitting by sunlight: nanostructure-directing effect of Si-doping

Thin, silicon-doped nanocrystalline alpha-Fe2O3 films have been deposited on F-doped SnO2 substrates by ultrasonic spray pyrolysis and chemical vapor deposition at atmospheric pressure. The photocatalytic activity of these films with regard to photoelectrochemical water oxidation was measured at pH 13.6 under simulated AM 1.5 global sunlight. The photoanodes prepared by USP and APCVD gave 1.17 and 1.45 mA/cm2, respectively, at 1.23 V vs RHE. The morphology of the alpha-Fe2O3 was strongly influenced by the silicon doping, decreasing the feature size of the mesoscopic film. The silicon-doped alpha-Fe2O3 nano-leaflets show a preferred orientation with the (001) basal plane normal to the substrate. The best performing photoanode would yield a solar-to-chemical conversion efficiency of 2.1% in a tandem device using two dye-sensitized solar cells in series.