A novel approach to the acoustic characterisation of porous road surfaces

Porous road surfaces offer an effective means of reducing the generation and propagation of noise from road traffic. However, the porosity of these surfaces can deteriorate over time, leading to a reduction in their noise reducing properties. Efficient methods are therefore required for monitoring this performance. Existing techniques for performing in-situ measurements of acoustic absorption are unsuitable for use within the traffic stream. Static measurements using time domain Maximum Length Sequence (MLS) based techniques have been demonstrated to offer advantages over traditional techniques, presenting the opportunity for measurements under dynamic conditions. This paper describes the design of a system for carrying out dynamic MLS-based measurements. Results are presented which demonstrate that stable dynamic measurements can be carried out at speeds of up to 30 km/h.     

Oscillations of linear integro-differential equations

Sufficient conditions which guarantee that certain linear integro-differential equation cannot have a positive solution are established.     

Electronic structure of Ti metal and TiO2 powder studied by hard and soft (Cu Kα1 and Al Kα1) X-ray photoelectron and Auger spectroscopy

High-energy X-ray photoelectron spectroscopy (XPS) is of particular importance for minimizing the effects of surface contamination by increasing photoelectron escape depths. In this study high-resolution high-energy Cu Kα₁ and soft Al Kα₁ XPS and Auger electron spectroscopy were used to compare the electronic structure of Ti in TiO₂ powder and Ti metal. The Ti 1s in TiO₂ XPS line is narrower and more symmetric than in Ti metal. A comparison of the relative intensities of the L₂₃M₂₃M₄₅ and L₂₃M₂₃M₂₃ Auger transitions in Ti metal and TiO₂ is consistent with the expected transfer of Ti 3d electrons away from the Ti site in the oxide. The satellites accompanying the Ti 1s XPS line excited by Cu Kα₁ X-rays occur at the same energies as the satellites accompanying the Ti 2s and 2p XPS lines excited by Al Kα₁ X-rays indicating that they do not depend on the core-level, the experimental resolution or inelastic scattering processes.     

The two-dimensional quantum Euclidean algebra

The algebra dual to Woronowicz's deformation of the two-dimensional Euclidean group is constructed. The same algebra is obtained from SU _q (2) via contraction on both the group and algebra levels.     

Immobilization of catalase on membranes of poly(ethylene)-g-co-acrylic acid and poly(tetrafluoroethylene)-g-co-acrylic acid and their application in hydrogen peroxide electrochemical sensors

The immobilization of catalase on grafted membranes of poly(ethylene)-g-co-acrylic acid and poly(tetrafluoroethylene)-g-co-acrylic acid and their application in hydrogen peroxide electrochemical sensors is described. The introduction of carboxylic acid groups onto a hydrophobic support provides a good environment for subsequent enzyme immobilization. This single membrane, hydrogen peroxide sensor showed significant improvement with respect to the double membrane versions. The response is very rapid, the linear range being from 10 μM up to 6 mM, with a detection limit of 4.7 μM, and a lifetime of more than 4 months.     

Magnetoresistance of Fe3O4/Au/Fe3O4 and Fe3O4/Au/Fe spin-valve structures

A detailed study of the in-plane magnetotransport properties of spin valves with one and two Fe₃O₄ electrodes is presented. Fe₃O₄/Au/Fe₃O₄ spin valves exhibit a clear anisotropic magnetoresistance in small magnetic fields but no giant magnetoresistance (GMR). The absence of GMR in these structures is due to simultaneous magnetization reversal in the two Fe₃O₄ layers. By contrast, a negative GMR effect is measured on Fe₃O₄/Au/Fe spin valves. The negative GMR is attributed to an electron spin scattering asymmetry at the Fe₃O₄/Au interface or an induced spin scattering asymmetry in the Au interfacial layers.     

On some Nikolski - and Oswald-type inequalities

Inequalities of Nikolski (Trudy Mat. Inst. Steklova 38 (1951), 2.3, p. 255) in L_2π^p, p 1, and of Oswald (Izv. Vyssh. Uchebn. Zaved. Mat. 7 (1976), (3.4), p. 71; Theorem 1, p. 69), 0 < p < 1, are extended to the case of Orlicz spaces L_2π.     

Methods in carbon K-edge NEXAFS: Experiment and analysis

Near-edge X-ray absorption spectroscopy (NEXAFS) is widely used to probe the chemistry and structure of surface layers. Moreover, using ultra-high brilliance polarised synchrotron light sources, it is possible to determine the molecular alignment of ultra-thin surface films. However, the quantitative analysis of NEXAFS data is complicated by many experimental factors and, historically, the essential methods of calibration, normalisation and artefact removal are presented in the literature in a somewhat fragmented manner, thus hindering their integrated implementation as well as their further development. This paper outlines a unified, systematic approach to the collection and quantitative analysis of NEXAFS data with a particular focus upon carbon K-edge spectra. As a consequence, we show that current methods neglect several important aspects of the data analysis process, which we address with a combination of novel and adapted techniques. We discuss multiple approaches in solving the issues commonly encountered in the analysis of NEXAFS data, revealing the inherent assumptions of each approach and providing guidelines for assessing their appropriateness in a broad range of experimental situations.     

Yttrium aluminate crystals for slabs

The methods of growing YAG:Nd crystals with a flat interface and YAP:Nd crystals with a sharp conical interface are described. The form of the interface was controlled by the He and H₂O content in the reducing atmosphere composed mainly of Ar and H₂ as well as by axial temperature gradient above the melt level. The crystals of 120–180 mm in length were machined to the high-quality slabs.