Structure elucidation of β-carotene isomers by HPLC-NMR coupling using a C30 bonded phase

The separation of cis/trans isomers of β-carotene has been performed with a C₃₀ stationary phase employing ¹H NMR spectroscopy as an on-line detection technique. 1D as well as 2D NMR spectra have been recorded in the stopped-flow mode for the predominant chromatographic peaks. Structural assignment of the five identified isomers was performed via comparison of simulated 1D ¹H NMR spectra on the basis of the structures of β-carotene cis/trans isomers with the experimental data, and also by the analysis of the proton-proton connectivities in the 2D NMR spectra of three isomers with the highest concentration. The chromatographic retention behaviour of the isomers agreed well with previously reported data. The advantage of the applied hyphenated coupling technique compared to conventional off-line techniques lies in the fact that chromatographic separation and NMR detection are performed in a closed system, so that reisomerization of the separated compounds is inhibited. Received: 29 May 1996 / Revised: 1 July 1996 / Accepted: 4 July 1996     

Characterisation of anodic oxide films on zirconium formed in sulphuric acid: XPS and corrosion resistance investigations

Present work describes investigations of a two-step process consisting of galvanostatic anodising in a 1 M H₂SO₄ solution at 100 mA cm⁻² up to the limiting voltages of 20, 60, 80, 100 and 120 V, directly after which potentiostatic regime was employed and the current was allowed to drop. The total treatment time (5 min) was held constant for all samples. The treatment was carried out to improve the corrosion resistance of zirconium in physiological conditions, which was determined by electrochemical evaluation in Ringer’s solution. XPS studies revealed that after anodising sulphur was incorporated into the oxide film in the form of sulphated zirconia. The maximum content of sulphate in the oxide layer was observed after anodising at 80 V. Anodising at higher voltages resulted in formation of coatings with decreasing amount of sulphur. It was found that there is a strong correlation between the sulphur content in the oxide layers and the measured corrosion current density. On the other hand, the pitting corrosion resistance seemed to be unaffected by the presence of S and it was improving with the increasing limiting voltage of the treatment.

     

The Dirichlet ring and unconditional bases in L 2[0, 2π]

It is observed that the Dirichlet ring admits a representation in an infinite-dimensional matrix algebra. The resulting matrices are subsequently used in the construction of nonorthogonal Riesz bases in a separable Hilbert space. This framework enables custom design of a plethora of bases with interesting features. Remarkably, the representation of signals in any one of these bases is numerically implementable via fast algorithms.     

Preparation and Properties of Novel Cationically Active Oligo-p-Methoxystyryl-Silica Composites

Abstract

The preparation of cationically active oligo-p-methoxystyrene-silica composites by cationic interfacial polymerization is described. In addition to the effective preparation of the interfacial initiator, p-methoxybenzylium-hydrogen sulfate-silica, and p-methoxybenzylium-trifluoroacetate-silica, a procedure to yield new kinds of composites is reported. The outstanding properties of the “living” oligo-p-methoxy-styryl-hydrogen sulfate-silica is demonstrated by means of zeta potential measurements, solid-state ¹³C-NMR spectroscopy, UV/Vis spectroscopy, and electron scanning microscopy.     

Photochemical Sandmeyer-type Halogenation of Arenediazonium Salts

Trihalide salts were found to efficiently promote photochemical dediazotizing halogenations of diazonium salts. In contrast to classical Sandmeyer reactions, no metal catalysts are required to achieve high yields and outstanding selectivities for halogenation over competing hydridodediazotization. Convenient protocols are disclosed for synthetically meaningful brominations, iodinations, and chlorinations of diversely functionalized derivatives.     

Application of Natural Clinoptilolite for Ammonium Removal from Sludge Water

Sludge water (SW) arising from the dewatering of anaerobic digested sludge causes high back loads of ammonium, leading to high stress (inhibition of the activity of microorganisms by an oversupply of nitrogen compounds (substrate inhibition)) for wastewater treatment plants (WWTP). On the other hand, ammonium is a valuable resource to substitute ammonia from the energy intensive Haber-Bosch process for fertilizer production. Within this work, it was investigated to what extent and under which conditions Carpathian clinoptilolite powder (CCP 20) can be used to remove ammonium from SW and to recover it. Two different SW, originating from municipal WWTPs were investigated (SW1: c₀ = 967 mg/L NH₄-N, municipal wastewater; SW2: c₀ = 718–927 mg/L NH₄-N, large industrial wastewater share). The highest loading was achieved at 307 K with 16.1 mg/g (SW1) and 15.3 mg/g (SW2) at 295 K. Kinetic studies with different specific dosages (0.05 g_CLI/mg_NH4-N), temperatures (283–307 K) and pre-loaded CCP 20 (0–11.4 mg/g) were conducted. At a higher temperature a higher load was achieved. Already after 30 min contact time, regardless of the sludge water, a high load up to 7.15 mg/g at 307 K was reached, achieving equilibrium after 120 min. Pre-loaded sorbent could be further loaded with ammonium when it was recontacted with the SW.     

Bioactive Phenolic Compounds from Primula veris L.: Influence of the Extraction Conditions and Purification

Our experiments may help to answer the question of whether cowslip (Primula veris L.) is a rich source of bioactive substances that can be obtained by efficient extraction with potential use as a food additive. A hypothesis assumed that the type of solvent used for plant extraction and the individual morphological parts of Primula veris L. used for the preparation of herbal extracts will have key impacts on the efficiency of the extraction of bioactive compounds, and thus, the health-promoting quality of plant concentrates produced. Most analysis of such polyphenolic compound contents in extracts from Primula veris L. has been performed by using chromatography methods such as ultra-performance reverse-phase liquid chromatography (UPLC−PDA−MS/MS). Experiments demonstrated that the most effective extraction agent for fresh study material was water at 100 °C, whereas for dried material it was 70% ethanol. The richest sources of polyphenolic compounds were found in cowslip primrose flowers and leaves. The aqueous and ethanol extracts from Primula veris L. were characterized by a quantitatively rich profile of polyphenolic substances, and a high antioxidative potential. Selective extraction with the use of mild conditions and neutral solvents is the first step to obtaining preparations from cowslip primrose with a high content of bioactive substances.