Improved detectability with a polymer-based trapping device in rapid HPLC analysis for ultra-low levels of bisphenol A (BPA) in environmental samples.

A new high-performance liquid chromatography (HPLC) method has been developed to detect ultra-low concentrations of bisphenol-A (BPA) (below 1 ng/L (ppt)) using column switching electrochemical detection (ECD). The results were superior to those obtained from manual pretreatment procedure with membrane stationary phase. BPA is inherently ubiquitous in the environment, including tools and solvents used for its analysis; to obtain meaningful results, therefore, the concentration of the overall BPA contamination must be below the detection limit for BPA using the analytical system. Therefore, purified water for preparing the standard BPA solution must be filtered with a hydrophobic membrane to suppress BPA background levels of contamination. In addition, we investigated methods for effectively preserving environmental water containing BPA. The addition of a small amount of ethylenediaminetetraacetic acid (EDTA) provided good recovery even after overnight storage. By employing these precautionary measures and procedures to reduce BPA contamination from the analytical procedure, we could accurately determine l(-10) ppt of BPA in environmental water samples using a column switching HPLC system.     

Density functional calculations of dangling bonds for CN and SiN films

Hyperfine interaction constants (HFICs) of dangling bonds for CN and SiN films were calculated by density-functional theory. The averaged ¹⁴N isotropic HFICs for C dangling bonds are almost equal to those for Si dangling bonds. The anisotropic ¹⁴N HFICs calculated for C dangling bonds are larger than those for Si dangling bonds by a factor 2. The calculated results were compared with experimental results obtained by electron spin resonance and electron nuclear double resonance. It was indicated that the carbon dangling bonds are located such that they avoid N atoms in CN films.     

Basic study of the gelation of dimethacrylate‐type crosslinking agents

An investigation was made of the gelation of dimethacrylate‐type crosslinking agents in view of an application for separation media. The study mainly centered on a crosslinking agent, glycerol dimethacrylate (GDMA), which is relatively hydrophilic because of a hydroxyl group in the middle of its structure. The gelation of GDMA was compared with that of other hydrophobic crosslinking agents such as ethylene glycol dimethacrylate and 1,6‐hexanediol dimethacrylate. The diluents used in the study were toluene, toluene with methanol, and cyclohexanol. The gelation was observed in real time with a charge coupled device camera and dynamic light scattering (DLS). Also, the separated dry gels were extensively characterized with scanning electron microscopy, BET (N₂ absorption and desorption isotherm), and Fourier transform infrared. DLS analysis showed a stronger molecular interaction of GDMA gelation in toluene, whereas this interaction was much weaker in an alcoholic solvent such as toluene with methanol or cyclohexanol. This indicated that GDMA gelation might proceed through hydrogen bonding as well as a crosslinking reaction of vinyl groups. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 949–958, 2006     

Fischer indolization and its related compounds—VII : Development of abnormal fischer indolization of ortho-methoxyphenylhydrazone to provide a synthetic method for useful indole derivatives possessing an active methine group at C6 and novel 3,6′-biindole derivatives

Fischer indolization of ethyl pyruvate 2-methoxyphenylhydrazone (1) with p-toluene-sulfonic acid in benzene in the presence of an enolizable dicarbonyl or an indolic compound gave either an indole product having an active methine group at C₆ or a novel type of 3,6′-biindole compound. Structures of the products were established by NMR spectra and chemical evidence.     

Emission spectrographic determination of trace elements in atmospheric particulate matter

Air containing particulate material was passed continuously for one month through a low-volume air sampler equipped with a cyclone to exclude particulates greater than 10 μm in diameter. The samples and filters were ashed in a low-temperature plasma and, after addition of In₂O₃ support, palladium internal standard and graphite buffer, the ashes were analyzed by a.c. are emission spectrometry. Standard samples were prepared from a commercial standard containing 49 elements. The procedure allows the determination of 14 trace metals (Ag, Al, Cr, Cu, Fe, Ga, Mn, Mo, Ni, Pb, Sn, Ti, V, Zn) with relative standard deviations of 1.4–15.1%. The procedure has been applied successfully to monthly determinations of the average atmospheric concentrations of these elements in Kobe City for the past three years.     

A potentiometric microbial sensor based on immobilized escherichia coli for glutamic acid

The sensor consists of immobilized E. coli (which contains glutamate decarboxylase) and a carbon dioxide gas-sensor. Continuous introduction of sample solution into a flow system incorporating the sensor gives a potential which increases until a steady state is reached after 5 min. Measurements can also be made with only a 1- or 3-min introduction period with little loss of sensitivity. Calibration plots of mV measurements vs. logarithmic glutamic acid concentration are linear in the range 100–800 mg l^-1. The sensor is highly selective, stable and reproducible. It has been applied to the determination of glutamic acid in fermentation broths.     

Proof of the generalized expressions for the number of perfect matchings of polycube graphs

The number of perfect rnatchings for the linear 2 × 2 ×n cubic lattice was analytically derived by diagonalizing the skew—symmetric 4n × 4n determinant, whose non—zero off—diagonal elements are either ±1 or ±i (pure imaginary number). The basic formulation invoking the matrix manipulation follows that of Kasteleyn, but the result obtained in this paper is the first example of the analytical solution for a special case of the three-dimensional Ising model.received by the Publisher 20 September 1989     

Highly efficient and selective epoxidation of alkenes by photochemical oxygenation sensitized by a ruthenium(II) porphyrin with water as both electron and oxygen donor

Visible light irradiation of a reaction mixture of carbonyl-coordinated tetra(2,4,6-trimethyl)phenylporphyrinatoruthenium(II) (Ru(II)TMP(CO)) as a photosensitizer, hexachloroplatinate(IV) as an electron acceptor, and an alkene in alkaline aqueous acetonitrile induces selective epoxidation of the alkene with high quantum yield (Phi = 0.6, selectivity = 94.4% for cyclohexene and Phi = 0.4, selectivity = 99.7% for norbornene) under degassed conditions. The oxygen atom of the epoxide was confirmed to come from a water molecule by an experiment with H(2)(18)O. cis-Stilbene was converted into its epoxide, cis-stilbeneoxide, without forming trans-stilbeneoxide. trans-Stilbene, however, did not exhibit any reactivity. Under neutral conditions, an efficient buildup of the cation radical of Ru(II)TMP(CO) was observed at the early stage of the photoreaction, while an addition of hydroxide ion caused a rapid reaction with the cation radical to promote the reaction with reversion to the starting Ru(II)TMP(CO). A possible involvement of a higher oxidized state of Ru such as Ru(IV), Ru(V), Ru(VI) through a dismutation of the Ru(III) species was excluded by an experiment with Ru(VI)TMP(O)(2). Decarbonylation of the Ru complex was also proven to be invalid. A reaction mechanism involving an electron transfer from the excited triplet state of Ru(II)TMP(CO) to hexachloroplatinate(IV) and subsequent formation of OH(-)-coordinated Ru(III) species, leading to an oxo-ruthenium complex as the key intermediate of the photochemical epoxidation, was postulated.     

Oxythallation of norbornene derivatives with thallium(III) acetate in methanol

Treatment of norbornene, norbornadiene, benzonorbornadiene, and chloro- and methoxy-benzonorbornadiene with thallium(III) acetate in methanol affords only the corresponding cis-exo-acetoxythallation adducts in a sharp contrast to oxymercuration of such strained olefins where methoxymercuration prevails. In the cases of substituted benzonorbornadienes the products are obtained as the regioisomeric mixtures, the isomer ratio being determined by ¹³C NMR. In the cases of 5-norbornene-2,3-dicarboxylic anhydride, 5-norbornene-2-methyl-2,3-dicarboxylic anhydride, and 5-norbornen-2-endo-carboxylic acid, lactonization occurs to give a trans-oxythallation adduct having a lactone ring, no introduction of either methoxy or acetoxy groups being observed. ¹H and/or ¹³C NMR data for several new oxythallation adducts are provided. The alkaline sodium borohydride reduction of adducts in methanol affords mainly the parent olefin together with 10–16% yields of the corresponding exo-alcohol.