Photoassisted reaction of chemical warfare agent VX droplets under UV light irradiation

A photoassisted reaction of O-ethyl S-[2-(diisopropylamino) ethyl] methylphosphonothioate (VX) droplets in air was carried out. The experimental results indicated that VX droplets could be easily and chemically transformed into other compounds under irradiation of a germicidal lamp over sufficient time. Quantum chemical calculation results demonstrated that UV light less than 278 nm wavelength could possibly initiate photoreaction of VX and that both P-S and P=O bonds in the VX molecule were lengthened. The identification of reaction products by gas and liquid chromatography mass spectroscopy and NMR revealed that the VX molecule in air under UV light irradiation could undergo isomerization of S-esters to O-esters, cleavage of P-S, S-C, and C-N bonds, and ozonation of tertiary amines.     

复杂换热网络MINLP中的非线性特性分析

针对复杂换热网络MINLP问题,本文应用多维函数渐变法探索和分析了连续变量和整型变量引起的网络性能非线性和非凸特性。研究表明,当系统规模增大时,不但连续变量的叠加效应将增加系统的非线性,整型变量将使得非线性特性更为严重。     

免疫亲和柱净化-液相色谱-串联质谱法同时测定猪肉中6种玉米赤霉醇类化合物残留量

建立了猪肉中6种玉米赤霉醇类化合物残留量的免疫亲和柱净化-液相色谱-串联质谱(IAC-LC-MS/MS)分析方法。酶解后的样品用乙醚提取,提取液浓缩后用三氯甲烷溶解,NaOH溶液反萃取,经免疫亲和柱富集和净化后,采用LC-MS/MS进行测定,外标法定量。在Shimadzu Shim-pack VP-ODS C18反相柱上分离,梯度洗脱,流动相为乙腈和2 mmol/L乙酸铵溶液;质谱采集为电喷雾负离子多反应监测模式。6种目标物的线性范围为0.5～200μg/L,相关系数(R)大于0.999,定量限(LOQ)在0.05～0.63μg/kg之间;添加浓度在1.0～5.0μg/kg范围内,方法回收率为71.3%～93.7%,相对标准偏差在3.7%～9.7%之间。该方法灵敏度高、重现性好,适用于猪肉样品中痕量玉米赤霉醇类药物残留的测定。     

吹扫捕集二次冷阱气相色谱-质谱联用测定地下水中的氟利昂

建立了吹扫捕集二次冷阱气相色谱-质谱(GC-MS)联用分析地下水中氟利昂(一氯三氟甲烷(CFC-11),二氯二氟甲烷(CFC-12),1,1,2-三氯三氟乙烷(CFC-113))的方法。地下水中的氟利昂经吹扫捕集热解析,二次冷阱富集后再热解析后进入GC-MS分析。结果表明,本方法测定CFC-11,CFC-12和CFC-113的线性范围分别是9.0×10"14～3.0×10"12 mol/L,4.0×10"14～3.0×10"12 mol/L和4.0×10"17～4.0×10"14 mol/L,相关系数大于0.99,检出限分别为4.4×10"14mol/L,1.6×10"14mol/L和5.36×10"18mol/L,样品加标回收率为95.4%～102.0%。本方法适用于地下水中氟利昂的检测,根据分析结果可计算出地下水的表观年龄。     

基于柑橘皮渣纳米多孔碳分散固相萃取-气相色谱法 测定果蔬中14种有机磷农药残留

以废弃柑橘皮渣为碳源,通过ZnCl2活化后高温煅烧制备了纳米多孔碳材料(NPC),将其作为吸附剂,建立了分散固相萃取净化、气相色谱法测定果蔬中有机磷农药残留的方法.扫描电子显微镜(SEM)、X射线衍射(XRD)、傅立叶红外光谱(FT-IR)、拉曼光谱及氮气吸附分析(BET)等表征显示,NPC是无定形的多孔碳材料,孔径大小为0~15 nm,比表面积和孔体积分别为1243 m2/g和1.28 cm3/g.以果蔬中14种有机磷类农药为分析对象,考察了吸附剂的用量和净化时间,并将NPC与商业化材料N-丙基乙二胺(PSA)、十八烷基硅胶键合相(C18)和石墨化碳黑(GCB)进行了对比.结果表明,NPC最佳使用量为0.01 g,净化时间只需2 min.NPC成本远低于C18、PSA和GCB,因具有丰富的孔道结构,NPC净化效果显著优于3种商业化材料.在最优条件下,14种有机磷农药在0.02~1.0 mg/L范围内的线性关系良好(R2>0.99),检出限(S/N=3)为0.63~5.30μg/kg.3个添加水平下的平均回收率为71.3%~114.7%,相对标准偏差(RSD)为0.9%~12.9%.本方法操作简便、快速、成本低,在果蔬样品前处理中具有广阔的应用前景.     

亲水性聚硅氧烷改性天然乳胶的性能

以亲水性聚硅氧烷KGF-903共混改性天然乳胶,通过拉力试验、老化试验、接触角测量和扫描电子显微镜等研究了聚硅氧烷的添加量对天然乳胶力学性能、抗老化性能、亲水性能和表面形貌的影响。结果表明,KGF-903含量在1.5%时拉伸强度有最佳的改性效果;KGF-903添加量约为3%时断裂伸长率达到最大,老化前后的断裂伸长率比改性前分别提高57%和50%。随着KGF-903含量的增加,改性天然乳胶片的水接触角逐渐减小;扫描电子显微镜观察的结果表明,添加聚硅氧烷能改变乳胶的分散状态。利用小试的最佳配方(即KGF-903的添加量为1.5%)生产了2批次医用导尿管,其表面光洁度、导尿管球囊的成品率、管身硬度、连接器与导尿管排泄锥形接口所承受的拉力和充气漏斗与引流漏斗连接处所承受的拉力等均有显著的提高,有效改善了产品的质量。     

Oscillatory transverse electric field enhances protein resolution and capacity of size-exclusion chromatography

Protein separations by a novel size-exclusion electrochromatography (SEEC) are presented. The present SEEC, denoted as pSEEC, was established with an oscillatory low-voltage electric field perpendicular to the mobile-phase streamline. Retention experiments with different proteins indicated that the influence of electric field strength on the partition coefficient is different for different proteins as well as for the same protein under different mobile-phase conditions. These results of protein retention led to the experimental design of protein separations with binary mixtures of BSA and immunoglobulin G (IgG), myoglobin (Myo) and lysozyme (Lys), as well as ovalbumin (Oval) and Myo. The separation results for the binary protein systems sufficiently exhibited the applicability of the pSEEC for various separations in terms of their molecular weights (MWs) as well as pIs. For example, it was possible to separate the gel-excluded proteins (BSA/IgG) as well as gel-permeable and similar-molecular-weight proteins (Myo/Lys) by the pSEEC. Moreover, in the cases of Oval/ Myo, which could be partially separated by size-exclusion chromatography, the use of the pSEEC greatly improved the resolution and the separation became possible at high sample loading. The results indicate that the pSEEC technology is promising for preparative protein separations.     

考虑最佳入口温度的多股流换热器网络循环优化

针对于多股流换热器网络的应用优势,本文在衍生网络优化方法基础上,提出了考虑最佳入口温度的多股流换热器循环优化方法,即利用多股流换热器网络小面积换热器合并而不产生固定投资费用这一特点,将优化结果中存在公用工程的流体返回到另一种流体的入口并与其入口流体进行循环优化。结果表明,这种优化方法能够进一步发挥多股流换热器网络的优点,得到年综合费用更小、运行费用更低的网络结构。     

Transportation of sulfur mustard (HD) in alkyd coating

The kinetics of absorption, desorption, and degradation of sulfur mustard (HD) in alkyd coating was experimentally studied, and a one-dimension mass transfer model for the transportation of HD molecule in alkyd coating was established on the experimental data. The obtained results indicated that the persistence of HD molecule could be greatly increased due to the absorption of HD droplets by alkyd coating, and there still occurred the desorption of HD as vapor from coating for more than 3 days even after decontamination of HD droplets onto coating. It was also experimentally shown that the majority of HD both absorbed and desorbed was accomplished at an early stage, less than 10 h, and HD molecule was able to be degraded within the alkyd coating probably through the reactions of hydrolysis and elimination. The diffusion coefficient and degradation rate constant of HD in alkyd coating were determined to be practically around 10(-9) cm2/s and 2.4 x 10(-5) min(-1), respectively.     

Templated synthesis of highly ordered mesoporous cobalt ferrite and its microwave absorption properties

Based on the nanocasting strategy, highly ordered mesoporous CoFe2O4 is synthesized via the ‘two-solvent’ impregnation method using a mesoporous SBA-15 template. An ordered two-dimensional(P6mm) structure is preserved for the CoFe2O4/SBA-15 composite after the nanocasting. After the SBA-15 template is dissolved by NaOH solution, a mesoporous structure composed of aligned nanoparticles can be obtained, and the P6 mm structure of the parent SBA-15is preserved. With a high specific surface area(above 90 m2/g) and ferromagnetic behavior, the obtained material shows potential in light weight microwave absorption application. The minimum reflection loss(RL) can reach-18 dB at about16 GHz with a thickness of 2 mm and the corresponding absorption bandwidth is 4.5 GHz.