Coordination mechanism,characterization, and photoluminescence properties of spinel ZnAl<Subscript>2</Subscript>O<Subscript>4</Subscript> nanoparticles prepared by a modified polyacrylamide gel route

Single-phase ZnAl₂O₄ nanoparticles with the spinel structure were successfully synthesized using a modified polyacrylamide gel method according to the atomic ratio of Zn to Al = 1: 1.8. The as-prepared samples were characterized by means of X-ray powder diffraction (XRD), thermogravimetric analysis (TG), differential scanning calorimetry analysis (DSC), field-emission scanning electron microscopy (SEM), Fourier transform infrared spectroscopy (FTIR), and photoluminescence (PL) spectra. XRD patterns show that the pure phase of ZnAl₂O₄ is obtained after heating the xerogel at 900°C for 5 h in air. The SEM images reveal that the ZnAl₂O₄ nanoparticles have a narrow particle size distribution and the average particle size is around 45 nm. Photoluminescence (PL) spectra demonstrate the single phase ZnAl₂O₄ nanoparticles have an emission peak located at 469 nm when excited by 350 nm light. The phase structure, coordination mechanism, and luminescence properties have been discussed on the basis of the experimental results.     

In situ synchrotron X‐ray diffraction analysis of deformation behaviour in Ti–Ni‐based thin films

Deformation mechanisms of as‐deposited and post‐annealed Ti_50.2Ni_49.6, Ti_50.3Ni_46.2Cu_3.5 and Ti_48.5Ni_40.8Cu_7.5 thin films were investigated using the in situ synchrotron X‐ray diffraction technique. Results showed that initial crystalline phases determined the deformation mechanisms of all the films during tensile loading. For the films dominated by monoclinic martensites (B19′), tensile stress induced the detwinning of 〈011〉 type‐II twins and resulted in the preferred orientations of (002)_B19′ parallel to the loading direction (∥ LD) and (020)_B19′ perpendicular to the LD (⊥ LD). For the films dominated by austenite (B2), the austenite directly transformed into martensitic variants (B19′) with preferred orientations of (002)_B19′ ∥ LD and (020)_B19′ ⊥ LD. For the Ti_50.3Ni_46.2Cu_3.5 and Ti_48.1Ni_40.8Cu_7.5 films, martensitic transformation temperatures decreased apparently after post‐annealing because of the large thermal stress generated in the films due to the large differences in thermal expansion coefficients between the film and substrate.     

A novel method for the synthesize of nanostructured MgFe2O4 photocatalysts

Journal of Sol-Gel Science and Technology - Nanostructured MgFe2O4 magnetic photocatalysts are facilely synthesized by 60Co γ-ray irradiation assisted polyacrylamide gel route. The influence...     

Synthesis hexagonal ZrW2O8 and its thermal properties

ZrW₂O₈ as the typical negative thermal expansion (NTE) material has attracted much attention for the potential applications in various fields such as tailored coefficient of thermal expansion (CTE) composites. The hexagonal ZrW₂O₈ (h-ZrW₂O₈), with the combination of ZrO₂ and WO₃ in a composite, was synthesized at a pressure of 2 GPa and the temperature between 600°C and 700°C. We found h-ZrW₂O₈ decomposes to ZrO₂+WO₃ oxides that start from 500°C and end at 800°C, and determined the CTE of h-ZrW₂O₈ is?16.3×10^?6°C^?1 in the temperature range from 150°C to 450°C. The results show that ZrW₂O₈ with a hexagonal structure is metastable and exhibits high NTE property like its cubic structure.     

Effect of supersaturation on deuteration distribution in K(H1‐xDx)2PO4 crystals

The homogeneity of deuterium distribution in potassium dideuterium phosphate single crystals was studied by Raman and infrared spectroscopy analyses. Results indicated that the pyramidal section exhibited more homogeneous deuterium distribution than the prismatic section. Supersaturation slightly affected the deuterium homogeneity in the pyramidal section of crystals grown rapidly from 80% deuterated solution. Deuterium homogeneity in the prismatic section decreased with increasing supersaturation level of the growth solution.