Logarithmic temperature dependence of the conductivity of the two-dimensional metal

We report on the first observation and studies of a weak delocalizing logarithmic temperature dependence of the conductivity, which causes the conductivity of the 2D metal to increase as T decreases down to 16 mK. The prefactor of the logarithmic dependence is found to decrease gradually with density, to vanish at a critical density n _c , 2∼2×10¹² cm⁻², and then to have the opposite sign at n>n _c ,2. The second critical density sets the upper limit on the existence region of the 2D metal, whereas the conductivity at the critical point, G _c ,2∼120e ²/h, sets an upper (low-temperature) limit on its conductivity. Pis’ma Zh. éksp. Teor. Fiz. 68, No. 6, 497–501 (25 September 1998) Published in English in the original Russian journal. Edited by Steve Torstveit.     

Carbon precipitation and diffusion in SiGeC alloys under silicon self-interstitial injection

In this work we investigate the diffusion and precipitation of supersaturated substitutional carbon in 200-nm-thick SiGeC layers buried under a silicon cap layer of 40 nm. The samples were annealed in either inert (N₂) or oxidizing (O₂) ambient at 850 °C for times ranging from 2 to 10 h. The silicon self-interstitial (I) flux coming from the surface under oxidation enhances the C diffusion with respect to the N₂-annealed samples. In the early stages of the oxidation process, the loss of C from the SiGeC layer by diffusion across the layer/cap interface dominates. This phenomenon saturates after an initial period (2–4 h), which depends on the C concentration. This saturation is due to the formation and growth of C-containing precipitates that are promoted by the I injection and act as a sink for mobile C atoms. The influence of carbon concentration on the competition between precipitation and diffusion is discussed. Received: 19 October 2001 / Accepted: 19 December 2001 / Published online: 20 March 2002 / Published online: 20 March 2002     

Modulation of the distance dependence of paramagnetic relaxation enhancements by CSA × DSA cross-correlation

Paramagnetic metal ions with fast-relaxing electronic spin and anisotropic susceptibility tensor provide a rich source of structural information that can be derived from pseudo-contact shifts, residual dipolar couplings, dipole-dipole Curie spin cross-correlation, and paramagnetic relaxation enhancements. The present study draws attention to a cross-correlation effect between nuclear relaxation due to anisotropic chemical shielding (CSA) and due to the anisotropic dipolar shielding (DSA) caused by the electronic Curie spin. This CSA x DSA cross-correlation contribution seems to have been overlooked in previous interpretations of paramagnetic relaxation enhancements. It is shown to be sufficiently large to compromise the 1/r6 distance dependence usually assumed. The effect cannot experimentally be separated from auto-correlated DSA relaxation. It can increase or decrease the observed paramagnetic relaxation enhancement. Under certain conditions, the effect can dominate the entire paramagnetic relaxation, resulting in nuclear resonances narrower than in the absence of the paramagnetic center. CSAxDSA cross-correlation becomes important when paramagnetic relaxation is predominantly due to the Curie rather than the Solomon mechanism. Therefore the effect is most pronounced for relaxation by metal ions with large magnetic susceptibility and fast-relaxing electron spin. It most strongly affects paramagnetic enhancements of transverse relaxation in macromolecules and of longitudinal relaxation in small molecules.     

Metallo‐supramolecular block copolymer micelles: Improved preparation and characterization

Micelles prepared from amphiphilic block copolymers in which a poly(styrene) segment is connected to a poly(ethylene oxide) block via a bis‐(2,2′:6′,2″‐terpyridine‐ruthenium) complex have been intensely studied. In most cases, the micelle populations were found to be strongly heterogeneous in size because of massive micelle/micelle aggregation. In the study reported in this article we tried to improve the homogeneity of the micelle population. The variant preparation procedure developed, which is described here, was used to prepare two “protomer”‐type micelles: PS₂₀‐[Ru]‐PEO₇₀ and PS₂₀‐[Ru]‐PEO₃₇₅. The dropwise addition of water to a solution of the compounds in dimethylformamide was replaced by the controlled addition of water by a syringe pump. The resulting micelles were characterized by sedimentation velocity and sedimentation equilibrium analyses in an analytical ultracentrifuge and by transmission electron microscopy of negatively stained samples. Sedimentation analysis showed virtually unimodal size distributions, in contrast to the findings on micelles prepared previously. PS₂₀‐[Ru]‐PEO₇₀ micelles were found to have an average molar mass of 318,000 g/mol (corresponding to 53 protomers per micelle, which is distinctly less than after micelle preparation by the standard method) and an average hydrodynamic diameter (d_h) of 18 nm. For PS₂₀‐[Ru]‐PEO₃₇₅ micelles, the corresponding values were M = 603,000 g/mol (31 protomers per micelle) and d_h = 34 nm. The latter particles were found to be identical to the “equilibrium” micelles prepared in pure water. Both micelle types had a very narrow molar mass distribution but a much broader distribution of s values and thus of hydrodynamic diameters. This indicates a conformational heterogeneity that is stable on the time scale of sedimentation velocity analysis. The findings from electron microscopy were in disagreement with those from the sedimentation analysis both in average micelle diameter and in the width of the distributions, apparently because of imperfections in the staining procedure. The preparation procedure described also may be useful in micelle formation from other types of protomers. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 4458–4465, 2004     

On Certain Perturbations of the Erdös–Renyi Random Graph

We study perturbations of the Erdös–Renyi model for which the statistical weight of a graph depends on the abundance of certain geometrical patterns. Using the formal correspondance with an exactly solvable effective model, we show the existence of a percolation transition in the thermodynamical limit and derive perturbatively the expression of the threshold. The free energy and the moments of the degree distribution are also computed perturbatively in that limit and the percolation criterion is compared with the Molloy–Reed criterion.     

Stochastic control problems with delay

We consider optimal control problems for systems described by stochastic differential equations with delay. We state conditions for certain classes of such systems under which the stochastic control problems become finite-dimensional. These conditions are illustrated with three applications. First, we solve some linear quadratic problems with delay. Then we find the optimal consumption rate in a financial market with delay. Finally, we solve explicitly a deterministic fluid problem with delay which arises from admission control in ATM communication networks.