排序方式: 共有40条查询结果,搜索用时 15 毫秒
1.
B. Schoofs T. Mouganie B. A. Glowacki V. Cloet S. Hoste I. Van Driessche 《Journal of Sol-Gel Science and Technology》2007,41(2):113-122
Today, the deposition of coated conductors on a variety of substrates is often performed using a vacuum or low pressure technique.
However, obtaining uninterrupted deposition at high speed, increasing flexibility in composition and attaining independence
of geometric constraints of the substrates are areas in which vacuum techniques will need sustained development in order to
answer industrial demands. The development of the next generation of deposition methods, based on deposition under atmospheric
environment and from aqueous precursor solutions is a real challenge. This work describes the deposition of thin NdBa2Cu3O7-y layers on SrTiO3 single crystals based on a new sol-gel dip coating process using aqueous precursor solutions. Two inorganic aqueous sol-gel
routes were investigated, a metal nitrate–citric acid based and a metal acetate–triethanol amine based solution. Using detailed
thermal analysis, it is shown that adjusting the different parameters during thermal treatment can be used to control the
morphology of the films. Also special attention is given to the microstructure of the thin film because of its relevance to
the superconducting transport properties of the coated conductor system. 相似文献
2.
Homocysteine present in human blood plasma is derivatized with thiol selective ultraviolet labelling reagent, 2-chloro-1-methylpyridinium iodide, and separated from other plasma thiol derivatives by high-performance liquid chromatography (HPLC) with detection at 312 nm. The separation is carried out isocratically on LiChrospher RP-18 column using mobile phase consisting of pH 2.5 0.04 M trichloroacetic acid buffer and methanol in the ratio 9:1 (v/v) pumped at 0.5 ml min−1 at 40°C. The homocysteine S-pyridinium derivative elutes at 6.5 min. To determine total and protein-bound homocysteine it is necessary to cleave disulphide bounds by the use of tri-n-butylphosphine in order to form free sulfhydryl group. The method provides quantitative information on total and protein-bound homocysteine based on assays with derivatization after reduction of whole plasma, and derivatization after reduction of acid precipitated proteins. The calibration graph is linear over the concentration range covering most experimental and clinical cases. The assay has a low pmol sensitivity and is reproducible; intra- and inter-day, relative standard deviation range from 1.79 to 5.09% and from 2.80 to 5.60%, respectively. The method is applied to the determination of total and protein-bound homocysteine in the plasma of healthy individuals. 相似文献
3.
Determination by liquid chromatography of free and total cysteine in human urine in the form of its S-quinolinium derivative 总被引:1,自引:0,他引:1
A reversed-phase high-performance liquid chromatographic method for the determination of free and total cysteine in urine is described. The method involves reductive conversion of cysteine dimer and cysteine mixed disulphides to their reduced counterpart with the use of tri-n-butylphosphine, ultraviolet-labeling with 2-chloro-1-methylquinolinium tetrafluoroborate, and liquid chromatographic separation with isocratic conditions. In developing this method the following parameters were investigated and optimized: the time, pH and reagent excess in the derivatization step, and mobile phase buffer concentration, pH, organic modifier and column temperature in the separation step. The method provides quantitative information on free and total cysteine based on assays with derivatization before and after reduction with tri-n-butylphosphine. The calibration graph, obtained with the use of normal urine spiked with growing amounts of cystine, was linear over the concentration range covering most experimental and clinical cases. The assay has a low pmol detection and quantitation limits, low imprecision and high recovery. The method was validated for urine samples received from several donors. Cystine was chosen as a primary calibrator for these assays. 相似文献
4.
Trent D Lund Timothy W West Lilyan Y Tian Lihong H Bu Daniel L Simmons Kenneth DR Setchell Herman Adlercreutz Edwin D Lephart 《BMC neuroscience》2001,2(1):20-13
Background
In learning and memory tasks, requiring visual spatial memory (VSM), males exhibit superior performance to females (a difference attributed to the hormonal influence of estrogen). This study examined the influence of phytoestrogens (estrogen-like plant compounds) on VSM, utilizing radial arm-maze methods to examine varying aspects of memory. Additionally, brain phytoestrogen, calbindin (CALB), and cyclooxygenase-2 (COX-2) levels were determined. 相似文献5.
Carr SA Glowacki DR Liang CH Baeza-Romero MT Blitz MA Pilling MJ Seakins PW 《The journal of physical chemistry. A》2011,115(6):1069-1085
The acetyl + O(2) reaction has been studied by observing the time dependence of OH by laser-induced fluorescence (LIF) and by electronic structure/master equation analysis. The experimental OH time profiles were analyzed to obtain the kinetics of the acetyl + O(2) reaction and the relative OH yields over the temperature range of 213-500 K in helium at pressures in the range of 5-600 Torr. More limited measurements were made in N(2) and for CD(3)CO + O(2). The relative OH yields were converted into absolute yields by assuming that the OH yield at zero pressure is unity. Electronic structure calculations of the stationary points of the potential energy surface were used with a master equation analysis to fit the experimental data in He using the high-pressure limiting rate coefficient for the reaction, k(∞)(T), and the energy transfer parameter, (ΔE(d)), as variable parameters. The best-fit parameters obtained are k(∞) = 6.2 × 10(-12) cm(-3) molecule(-1) s(-1), independent of temperature over the experimental range, and (ΔE(d))(He) = 160(T/298?K) cm(-1). The fits in N(2), using the same k(∞)(T), gave (ΔE(d))(N(2)) = 270(T/298?K) cm(-1). The rate coefficients for formation of OH and CH(3)C(O)O(2) are provided in parametrized form, based on modified Troe expressions, from the best-fit master equation calculations, over the pressure and temperature ranges of 1 ≤ p/Torr ≤ 1.5 × 10(5) and 200 ≤ T/K ≤ 1000 for He and N(2) as the bath gas. The minor channels, leading to HO(2) + CH(2)CO and CH(2)C(O)OOH, generally have yields <1% over this range. 相似文献
6.
7.
JM Plane CL Whalley L Frances-Soriano A Goddard JN Harvey DR Glowacki AA Viggiano 《The Journal of chemical physics》2012,137(1):014310
The first excited electronic state of molecular oxygen, O(2)(a(1)Δ(g)), is formed in the upper atmosphere by the photolysis of O(3). Its lifetime is over 70 min above 75 km, so that during the day its concentration is about 30 times greater than that of O(3). In order to explore its potential reactivity with atmospheric constituents produced by meteoric ablation, the reactions of Mg, Fe, and Ca with O(2)(a) were studied in a fast flow tube, where the metal atoms were produced either by thermal evaporation (Ca and Mg) or by pulsed laser ablation of a metal target (Fe), and detected by laser induced fluorescence spectroscopy. O(2)(a) was produced by bubbling a flow of Cl(2) through chilled alkaline H(2)O(2), and its absolute concentration determined from its optical emission at 1270 nm (O(2)(a(1)Δ(g) - X(3)Σ(g) (-)). The following results were obtained at 296 K: k(Mg + O(2)(a) + N(2) → MgO(2) + N(2)) = (1.8 ± 0.2) × 10(-30) cm(6) molecule(-2) s(-1); k(Fe + O(2)(a) → FeO + O) = (1.1 ± 0.1) × 10(-13) cm(3) molecule(-1) s(-1); k(Ca + O(2)(a) + N(2) → CaO(2) + N(2)) = (2.9 ± 0.2) × 10(-28) cm(6) molecule(-2) s(-1); and k(Ca + O(2)(a) → CaO + O) = (2.7 ± 1.0) × 10(-12) cm(3) molecule(-1) s(-1). The total uncertainty in these rate coefficients, which mostly arises from the systematic uncertainty in the O(2)(a) concentration, is estimated to be ±40%. Mg + O(2)(a) occurs exclusively by association on the singlet surface, producing MgO(2)((1)A(1)), with a pressure dependent rate coefficient. Fe + O(2)(a), on the other hand, shows pressure independent kinetics. FeO + O is produced with a probability of only ~0.1%. There is no evidence for an association complex, suggesting that this reaction proceeds mostly by near-resonant electronic energy transfer to Fe(a(5)F) + O(2)(X). The reaction of Ca + O(2)(a) occurs in an intermediate regime with two competing pressure dependent channels: (1) a recombination to produce CaO(2)((1)A(1)), and (2) a singlet∕triplet non-adiabatic hopping channel leading to CaO + O((3)P). In order to interpret the Ca + O(2)(a) results, we utilized density functional theory along with multireference and explicitly correlated CCSD(T)-F12 electronic structure calculations to examine the lowest lying singlet and triplet surfaces. In addition to mapping stationary points, we used a genetic algorithm to locate minimum energy crossing points between the two surfaces. Simulations of the Ca + O(2)(a) kinetics were then carried out using a combination of both standard and non-adiabatic Rice-Ramsperger-Kassel-Marcus (RRKM) theory implemented within a weak collision, multiwell master equation model. In terms of atmospheric significance, only in the case of Ca does reaction with O(2)(a) compete with O(3) during the daytime between 85 and 110 km. 相似文献
8.
Chemical and Physical Analysis of Acetate-Oxide Sol-Gel Processing Routes for the Y-Ba-Cu-O System 总被引:2,自引:0,他引:2
Tarek?MouganieEmail author Michelle?A.?Moram Joy?Sumner Bartek?A.?Glowacki Bart?Schoofs Isabel?Van?Driessche Serge?Hoste 《Journal of Sol-Gel Science and Technology》2005,36(1):87-94
The formation of three sols by fluorine-free aqueous and non-aqueous processes were analyzed and modified to vary the chemical properties of the sols (inks) to suit a variety of deposition processes such as dip-coating and ink-jet coating/printing. Ink-jet printing requires high wetting angles; choosing the right complexing agents to modify the ink allows the formation of droplets with high wetting angles on the surface. Dip-coating and ink-jet coating require low wetting angles; additives added to the sols reduce wetting angles to 10∘ and allow complete coverage of the substrate surface. The deposition theories and requirements are briefly discussed, as are some initial tests with the printing and converting of the developed superconducting inks. 相似文献
9.
10.
M. Mosiadz R. I. Tomov S. C. Hopkins G. Martin D. Hardeman B. Holzapfel B. A. Glowacki 《Journal of Sol-Gel Science and Technology》2010,54(2):154-164
The successful inkjet printing of a cerium gadolinium oxide (Ce0.8Gd0.2O2) precursor solution on highly textured Ni-5%W is reported. A stable ink was synthesised from metal acetates and propionic
acid with rheological properties suitable for inkjet printing and also the development of solid–liquid interface comparable
with thin film formation by dip coating. Two different drop-on-demand print heads were used for deposition: a 16-nozzle piezoelectric
cartridge and a single electromagnetic nozzle. Two different rastering patterns with different droplet sizes and spacing were
compared. Thermogravimetry and X-ray diffractometry were used to study the thermal decomposition of the metal oxide precursors
and to determine the shortest possible heat treatment of the deposited layers, potentially suitable for continuous large scale
production. The results from X-ray diffraction show that the single phase Ce0.8Gd0.2O2 was obtained in all cases, but only piezoelectric inkjet printing with optimised drop overlapping produces a highly textured
buffer layer. Optical micrographs and atomic force microscopy also indicate the good quality of deposited films after heat
treatment. 相似文献