Oxidation of nitrided si(100) by gaseous atomic and molecular oxygen

The nitridation of Si(100) by ammonia and the subsequent oxidation of the nitrided surface by both gaseous atomic and molecular oxygen was investigated under ultrahigh vacuum (UHV) conditions using X-ray photoelectron spectroscopy (XPS). Nitridation of Si(100) by the thermal decomposition of NH3 results in the formation of a subsurface nitride and a decrease in the concentration of surface dangling bond sites. On the basis of changes in the N1s spectra obtained after NH3 adsorption and decomposition, we estimate that the nitride resides about four to five layers below the vacuum-solid interface and that the concentration of surface dangling bonds after nitridation is only 59% of its value on Si(100)-(2 x 1). Oxidation of the nitrided surface is found to produce an oxide phase that remains in the outer layers of the solid and interacts only weakly with the underlying nitride for oxygen coverages up to 2.5 ML. Slight changes in the N1s spectra observed after oxidizing at 300 K are suggested to arise primarily from the introduction of strain within the nitride, and by the formation of a small amount of Si2=N-O species near the nitride-oxide interface. The nitrogen bonding environment changes negligibly after oxidizing at 800 K, which is indicative of greater phase separation at elevated surface temperature. Nitridation is also found to significantly reduce the reactivity of the Si(100) surface toward both atomic and molecular oxygen. A comparison of the oxygen uptake on the clean and nitrided surfaces shows quantitatively that the decrease in dangling bond concentration is responsible for the reduced activity of the nitrided surface toward oxidation, and therefore that dangling bonds are the initial adsorption site for both gaseous oxygen atoms and molecules. Increasing the surface temperature is found to promote the uptake of oxygen when O2 is used as the oxidant, but brings about only a small enhancement in the uptake of gaseous O-atoms. The different effects of surface temperature on the uptake of O versus O2 are interpreted in terms of the efficiency at which dangling bond pairs are regenerated on the surface at elevated temperature and the different site requirements for the adsorption of O and O2.     

Novel approaches to the analysis of the Maillard reaction of proteins

The Maillard reaction comprises a complex network of reactions which has proven to be of great importance in both food science and medicine. The majority of methods developed for studying the Maillard reaction in food have focused on model systems containing amino acids and monosaccharides. In this study, a number of electrophoretic techniques, including two-dimensional gel electrophoresis and capillary electrophoresis, are presented. These have been developed specifically for the analysis of the Maillard reaction of food proteins, and are giving important insights into this complex process.     

Heterocyclic compounds from 3-(4-phenyl) benzoyl propionic acid

3-(4-Phenyl) benzoyl propionic acid was used as the starting material for the synthesisof furanones (2), pyrrolinones (5), pyridazinones (7), benzoxazinones (8) and quinazolinones (9-11). The behaviour of the derivatives of furanones and benzoxazinones toward different nucleophiles is reported.     

Propane‐1,2‐diammonium tetrafluoroberyllate

Cocrystallization of the inorganic [BeF₄]^2? unit with the organic moiety [NH₃CH₂CH(NH₃)CH₃]²⁺ results in the three‐dimensional network of the title compound, (C₃H₁₂N₂)[BeF₄] or C₃H₁₂N₂²⁺·BeF₄^2?, created by hydrogen bonds between the protonated ammonium groups and the highly electronegative F atoms of the anion. The structure is described in terms of layers related to each other by crystallographic centres of symmetry.     

Kinetics of CO oxidation on high-concentration phases of atomic oxygen on Pt(111)

Temperature-programmed reaction spectroscopy (TPRS) and direct, isothermal reaction-rate measurements were employed to investigate the oxidation of CO on Pt(111) covered with high concentrations of atomic oxygen. The TPRS results show that oxygen atoms chemisorbed on Pt(111) at coverages just above 0.25 ML (monolayers) are reactive toward coadsorbed CO, producing CO(2) at about 295 K. The uptake of CO on Pt(111) is found to decrease with increasing oxygen coverage beyond 0.25 ML and becomes immeasurable at a surface temperature of 100 K when Pt(111) is partially covered with Pt oxide domains at oxygen coverages above 1.5 ML. The rate of CO oxidation measured as a function of CO beam exposure to the surface exhibits a nearly linear increase toward a maximum for initial oxygen coverages between 0.25 and 0.50 ML and constant surface temperatures between 300 and 500 K. At a fixed CO incident flux, the time required to reach the maximum reaction rate increases as the initial oxygen coverage is increased to 0.50 ML. A time lag prior to the reaction-rate maximum is also observed when Pt oxide domains are present on the surface, but the reaction rate increases more slowly with CO exposure and much longer time lags are observed, indicating that the oxide phase is less reactive toward CO than are chemisorbed oxygen atoms on Pt(111). On the partially oxidized surface, the CO exposure needed to reach the rate maximum increases significantly with increases in both the initial oxygen coverage and the surface temperature. A kinetic model is developed that reproduces the qualitative dependence of the CO oxidation rate on the atomic oxygen coverage and the surface temperature. The model assumes that CO chemisorption and reaction occur only on regions of the surface covered by chemisorbed oxygen atoms and describes the CO chemisorption probability as a decreasing function of the atomic oxygen coverage in the chemisorbed phase. The model also takes into account the migration of oxygen atoms from oxide domains to domains with chemisorbed oxygen atoms. According to the model, the reaction rate initially increases with the CO exposure because the rate of CO chemisorption is enhanced as the coverage of chemisorbed oxygen atoms decreases during reaction. Longer rate delays are predicted for the partially oxidized surface because oxygen migration from the oxide phase maintains high oxygen coverages in the coexisting chemisorbed oxygen phase that hinder CO chemisorption. It is shown that the time evolution of the CO oxidation rate is determined by the relative rates of CO chemisorption and oxygen migration, R(ad) and R(m), respectively, with an increase in the relative rate of oxygen migration acting to inhibit the reaction. We find that the time lag in the reaction rate increases nearly exponentially with the initial oxygen coverage [O](i) (tot) when [O](i) (tot) exceeds a critical value, which is defined as the coverage above which R(ad)R(m) is less than unity at fixed CO incident flux and surface temperature. These results demonstrate that the kinetics for CO oxidation on oxidized Pt(111) is governed by the sensitivity of CO binding and chemisorption on the atomic oxygen coverage and the distribution of surface oxygen phases.     

Influence of vanadium doping on the behavior of YBa_2Cu_3O_7-y

YBa2Cu3-xVxO7-y(x=0, 0.1, 0.2, 0.3, 0.4, 0.5 and 0.6) superconductors have been prepared. X-ray diffraction shows that the system remains orthorhombic for all compositions studied, but for x > 0.4 V2O5 was detected as an impurity phase. Substitution of V5+ for Cu2+ occurs in the Cu(2) sites on the Cu(2)-O planes. The introduction of the high valence element, vanadium, produces the extra free-electrons. These electrons recombine with the positive carrier of the system. It makes depression of the mobility and the Hall number of YBa2Cu3-xVxO7-v and also results in a depression of TC.     

Linear dependence in basis-set calculations for extended systems

The problem of linear dependence in basis-set calculations for extended systems is discussed. We show that the problem is intrinsic in three-dimensionally extended systems, but is not as serious in systems with extension in fewer dimensions. The possibility of choosing suitable basis sets that avoid linear dependence is discussed. It is shown that for systems extended in three dimensions in which the orbitals near the Fermi-level are well described by plane waves a mixed atomicorbital/plane-wave (AO –PW ) basis set with tight orbitals to describe the cores avoids the problem in the most efficient way. Numerical experiments with 1s Slater-type orbitals and plane waves on a simple cubic lattice are presented for illustration. © 1992 John Wiley & Sons, Inc.     

CHEMILUMINESCENCE AND FLUORESCENCE OF THE EUROPIUM IONS-ADENINE NUCLEOTIDES SYSTEM AND ITS POSSIBLE BIOLOGICAL SIGNIFICANCE

Abstract— Chemiluminescence of the Eu(II)/Eu(III)-adenine nucleotide-H₂O₂ system and fluorescence of the Eu(III)-adenosine triphosphate system have been investigated. The spectral distribution of the chemiluminescence emission has shown an occurrence of three main bands (Λ=470–480,590–620 and ca. 700 nm). The energy transfer process from the adenosine triphosphate molecules to the Eu(III) ions has been observed in the fluorescence spectrum. The examined chemiluminescence and fluorescence spectra show that these both kinds of emission originate from the ⁵ D _***τ⁷F_*** ( n =1–4) transitions in the Eu(III) ions.     

微米铜丝的低温力学性能测试

针对纤维材料变温环境力学性能测试的需要,在华中科技大学研制的纤维材料试验机的基础上引入了温控装置,从而实现纤维材料在高低温环境下的力学性能测试。采用该装置对不同直径微米铜丝在不同温度、不同拉伸速率条件下的力学性能开展实验研究,测试结果表明弹性模量和抗拉强度随温度的降低而线性增加,屈服强度的变化不太明显。另外,低温环境下微米铜丝的力学性能表现出与其直径相关的尺度效应,而这一现象在常温下一直没有观测到。最后,还研究了拉伸速率对微米铜丝的力学性能影响,结果表明,在现有装置的许用范围之内,拉伸速率对其力学性能的影响不大。