镁掺杂氧化铈整体式催化剂催化CO2和CH3OH直接合成碳酸二甲酯

采用共沉淀法成功地合成了不同Mg掺杂量的Ce_1-xMg_xO₂(x=0.05、0.10、0.15、0.20)固溶体催化材料,并运用透射电子显微镜(TEM)、X射线衍射(XRD)、氮气吸附-脱附测试、拉曼光谱、X射线光电子能谱(XPS)、CO₂程序升温脱附(CO₂-TPD)等技术对这些材料进行了表征。结果发现,通过调控CeO₂晶格中Mg的含量,可以调控所制备的Ce_1-xMg_xO₂催化材料的粒径、比表面积、表面缺陷等。其中Ce_0.90Mg_0.10O₂展现了最佳的表面性质,具有最小的平均粒径(约5.8 nm),最大的比表面积(约136 m2·g^-1)以及最高的表面氧含量(31.98%)。将Ce_1-xMg_xO₂催化材料涂覆在堇青石蜂窝陶瓷上制成整体催化剂,考察其对CO₂和CH₃OH直接合成碳酸二甲酯的催化性能。在140℃、2.4 MPa、反应2 h的条件下,Ce_0.90Mg_0.10O₂整体催化剂上碳酸二甲酯的收率高达20.21%,催化效果明显优于CeO₂和其余的Ce_1-xMg_xO₂(x=0.05、0.15、0.20)催化材料。     

金的化学状态对Au／CoCeOx催化剂CO氧化性能的影响

以CoCeOx复合氧化物为载体,采用沉积沉淀法制备了负载型的金催化剂,并通过不同温度的预处理控制Au的化学状态. 使用粉末X射线衍射、高分辨透射电子显微镜、程序升温还原和X射线光电子能谱对催化剂进行了表征,考察了在室温条件下该系列催化剂的一氧化碳氧化性能. 结果表明, Au/CoCeOx催化剂的CO氧化性能与催化剂表面Au 的含量成正比, Au 可能是反应的主要活性物种. 添加水汽对反应有一定的促进作用,但由于Au 不能稳定存在,特别是当催化剂表面Au 的含量过高时,在水汽的作用下Au 迅速发生歧化反应,使得催化剂的性能下降.     

4-氨基-7-硝基苯并-2-氧杂-1,3-二唑类衍生物的合成及其对汞离子的识别研究

以4-氯-7-硝基苯并-2-氧杂-1,3-二唑、乙二胺和溴乙酸乙酯等为原料,合成4-氨基-7-硝基苯并-2-氧杂-1,3-二唑类衍生物(NBD-OEt),通过IR、NMR和MS对其进行结构表征。研究NBD-OEt的吸收光谱和荧光光谱性质,探讨其在H2O/EtOH(60/40, V/V) pH 7.40的HEPES缓冲体系中对Hg₂ 的响应,以及NBD-OEt与Hg₂ 的结合模式。结果表明, 随Hg₂ 的不断加入可诱使NBD-OEt在476nm的吸收峰红移至514nm,并有两个等吸收点(347nm、482nm);其荧光发射峰由536nm红移至559nm,且在525nm出现等发射点;通过Job plot法测定NBD-OEt与Hg₂ 以1:1的计量比结合。     

Characterization of solid standards prepared by freeze‐drying

Solid standards prepared by freeze‐drying consistently showed a high degree of homogeneity. The freezing process, completed in fractions of a second, preserves the original homogeneous distribution of the dopants, and the subsequent sublimation step would minimize any disturbance. Compared to those prepared by conventional methods such as blending and spiking, freeze‐dried standards exhibited superior lateral distribution and better uniform depth distribution. There is, however, a concentration constraint for achieving homogeneity. At 5% doping, segregation was observed in both lateral and depth distribution. Many tungsten standards doped with 10–28 elements ranging from 10 to 200 ppm were successfully prepared and used as controls for a number of analytical techniques including glow discharge mass spectrometry (GDMS) and d.c.‐arc optical emission spectroscopy (OES). Copyright © 2009 John Wiley & Sons, Ltd.     

Analysis of ultrasonic guided waves propagating in long bones and cortical thickness based on time-frequency methods

The ultrasonic signals in long bones contain multiple guided modes which are mutual superposed.The velocities of guided waves in long bones are very sensitive to cortical thickness (CTh).In this paper,Hilbert-Huang transform(HHT) was proposed to analyze multi-mode guided waves,which can decompose superposed waves into many independent modes.Then the group velocity of each mode was obtained at corresponding frequency,which was compared with the results of short time Fourier transform(STFT).The CTh was also obtained by comparing with the theoretical calculation.The results showed that the experimental determined thickness was in agreement with the actual CTh,indicating that measuring the velocity of the guided mode can be used to estimate the CTh.The HHT is an effective method to identify multimode guided waves.     

The impact of water column variability on horizontal wave number estimation and mode based geoacoustic inversion results

The influence of water column variability on low-frequency, shallow water geoacoustic inversion results is considered. The data are estimates of modal eigenvalues obtained from measurements of a point source acoustic field using a horizontal aperture array in the water column. The inversion algorithm is based on perturbations to a background waveguide model with seabed properties consistent with the measured eigenvalues. Water column properties in the background model are assumed to be known, as would be obtained from conductivity, temperature, and depth measurements. The scope of this work in addressing the impact of water column variability on inversion is twofold. Range-dependent propagation effects as they pertain to eigenvalue estimation are first considered. It is shown that mode coupling is important even for weak internal waves and can enhance modal eigenvalue estimates. Second, the effect of the choice of background sound speed profile in the water column is considered for its impact on the estimated bottom acoustic properties. It is shown that a range-averaged sound velocity profile yields the best geoacoustic parameter estimates.     

基于时频分布的盲信号分离方法研究长骨中的多模式导波信号

由于超声导波对长骨皮质骨的材料特性及厚度变化非常敏感,因此用导波评价长骨状况的研究已成为近年来的一个研究热点。在接收到的导波中,往往多种模式混叠在一起,使得进一步求取每种导波模式的群速度等与骨质状况密切相关的参数时遇到困难。本文采用基于时频分布的盲信号分离(TFBSS)方法对长骨中混叠的多模式进行分离,然后对分离后的单一导波模式求取群速度。研究结果表明TFBSS方法能够准确的分离出混叠的多模式导波,且实验测量的群速度与其理论值吻合。利用导波的群速度就可以得到长骨皮质骨的厚度,这对诊断其骨质状况具有重要意义。     

ON THE SUSTAINABLE GROWTH IN AN ECONOMY WITH PERFECTLY SUBSTITUTABLE EXHAUSTIBLE RESOURCES

Abstract A model of sustainable economic growth in an economy with two types of exhaustible resources is analyzed. The resources are assumed to be perfect substitutes with marginal rate of substitution varying over time. The optimal control framework is used to characterize the optimal paths under the maximin criterion. It is shown that the resource with increasing productivity is not used before the constant productivity resource is depleted. Afterwards the resource with an increasing productivity is asymptotically depleted as well. The results are based on an assumption that transversality conditions hold. A new sufficient condition for the transversality conditions is derived. Finally, an analogue of Hartwick’s rule for this non‐autonomous case is established.