Modelling and design of a travelling-wave electro-optic modulator on InP

Based on a rigorous vectorial analysis, a fast travelling-wave Mach–Zehnder modulator is modelled and designed. The cross-section of the semiconductor layer stack and the lossy electrodes are carefully modelled using the method of lines in order to investigate propagation characteristics, velocity and losses. This yields an accurate microwave and optical field distribution to explain the behaviour of the component. In order to enhance the modulation efficiency, design curves are derived and the cross-sectional dimensions for minimum microwave loss are determined. The loss of the optimized modulator agrees very well with small-signal measurements up to 40 GHz and HFSS simulations. The layerstack of the fabricated device is suitable for integration with InP multi-wavelength lasers.     

Metallo‐supramolecular block copolymer micelles: Improved preparation and characterization

Micelles prepared from amphiphilic block copolymers in which a poly(styrene) segment is connected to a poly(ethylene oxide) block via a bis‐(2,2′:6′,2″‐terpyridine‐ruthenium) complex have been intensely studied. In most cases, the micelle populations were found to be strongly heterogeneous in size because of massive micelle/micelle aggregation. In the study reported in this article we tried to improve the homogeneity of the micelle population. The variant preparation procedure developed, which is described here, was used to prepare two “protomer”‐type micelles: PS₂₀‐[Ru]‐PEO₇₀ and PS₂₀‐[Ru]‐PEO₃₇₅. The dropwise addition of water to a solution of the compounds in dimethylformamide was replaced by the controlled addition of water by a syringe pump. The resulting micelles were characterized by sedimentation velocity and sedimentation equilibrium analyses in an analytical ultracentrifuge and by transmission electron microscopy of negatively stained samples. Sedimentation analysis showed virtually unimodal size distributions, in contrast to the findings on micelles prepared previously. PS₂₀‐[Ru]‐PEO₇₀ micelles were found to have an average molar mass of 318,000 g/mol (corresponding to 53 protomers per micelle, which is distinctly less than after micelle preparation by the standard method) and an average hydrodynamic diameter (d_h) of 18 nm. For PS₂₀‐[Ru]‐PEO₃₇₅ micelles, the corresponding values were M = 603,000 g/mol (31 protomers per micelle) and d_h = 34 nm. The latter particles were found to be identical to the “equilibrium” micelles prepared in pure water. Both micelle types had a very narrow molar mass distribution but a much broader distribution of s values and thus of hydrodynamic diameters. This indicates a conformational heterogeneity that is stable on the time scale of sedimentation velocity analysis. The findings from electron microscopy were in disagreement with those from the sedimentation analysis both in average micelle diameter and in the width of the distributions, apparently because of imperfections in the staining procedure. The preparation procedure described also may be useful in micelle formation from other types of protomers. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 4458–4465, 2004     

On Producing Multiple Solutions Using Repeated Trials

The number of trials that is required by an algorithm to produce a given fraction of the problem solutions with a specified level of confidence is analyzed. The analysis indicates that the number of trials required to find a large fraction of the solutions rapidly decreases as the number of solutions obtained on each trial by an algorithm increases. In applications where multiple solutions are sought, this decrease in the number of trials could potentially offset the additional computational cost of algorithms that produce multiple solutions on a single trial. The analysis framework presented is used to compare the efficiency of a homotopy algorithm to that of a Newton method by measuring both the number of trials and the number of calculations required to obtain a specified fraction of the solutions.     

Quantification problems in depth profiling of pwr steels using Ar+ ion sputtering and XPS analysis.

The oxide scales of AISI 304 formed in boric acid solutions at 300 degrees C and pH = 4.5 have been studied using X-ray photoelectron spectroscopy (XPS) depth profiling. The present focus is depth profile quantification both in depth and chemical composition on a molecular level. The roughness of the samples is studied by atomic force microscopy before and after sputtering, and the erosion rate is determined by measuring the crater depth with a surface profilometer and vertical scanning interferometry. The resulting roughness (20-30 nm), being an order of magnitude lower than the crater depth (0.2-0.5 microm), allows layer-by-layer profiling, although the ion-induced effects result in an uncertainty of the depth calibration of a factor of 2. The XPS spectrum deconvolution and data evaluation applying target factor analysis allows chemical speciation on a molecular level. The elemental distribution as a function of the sputtering time is obtained, and the formation of two layers is observed-one hydroxide (mainly iron-nickel based) on top and a second one deeper, mainly consisting of iron-chromium oxides.     

C^＊—模理论的若干结果

本文把代数结构与分析体系结合起来，运用同调的方法，较系统地确定了A上C^*－模的部分理论，这里A为复数域C上的交换C^*－代数。即不仅定义了与C^*－模有关的某些新概念，而且还得到了有关C^*－模的若干结果。     

Metallo‐supramolecular micelles: Studies by analytical ultracentrifugation and electron microscopy

In aqueous solutions, amphiphilic block copolymers in which a polystyrene (PS) segment is connected to a poly(ethylene oxide) (PEO) block via a bis(2,2′:6′,2″‐ terpyridine ruthenium) complex can form micelles. Such micelles of the protomer type PS₂₀‐[Ru]‐PEO₇₀, according to the preparation procedure representing frozen micelles, were studied by sedimentation velocity and sedimentation equilibrium analysis in an analytical ultracentrifuge and by transmission electron microscopy, with different techniques applied for the sample preparation. The particles obtained were surprisingly multifarious in size. In ultracentrifugation experiments performed at relatively low salt concentrations, the distributions of the sedimentation coefficient s_20,w showed a pronounced peak at 9.6 S and a broad, only partly separated second peak around 14 S. The molar mass of the particles at the peak was around 430,000 g/mol, corresponding to an aggregation number of approximately 85. The average hydrodynamic diameter of the particles in the peak fraction was approximately 13 nm. In electron micrographs of negatively stained samples, spheres of diameters between 10 and 25 nm were the most abundant particles, but larger ones with a wide size range were also visible. The latter particles apparently were composed of smaller ones. The data from both sedimentation analysis and electron microscopy showed that (1) the studied compound formed primary micelles of diameters around 20 nm and (2) the primary micelles had a tendency toward aggregation. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 3159–3168, 2003     

3—磺基—4—羟基香豆素希土化合物的合成及性质

在不同条件下制得三种类型的希土与3-磺基-4-羟基香豆素(H_2SHC)化合物,元素分析确定了它们的组成分别为Ln(HSHC)_3·9H_2(Ln=La,Pr,Nd,Gd,Dy,Er,Yb,Y),Ln_2(SHC)_3.nH_2O(Ln:La,Pr,Nd,Sm,Gd,N:4或6)和Na,Ln(3HC),·H:O(Ln:Er,Yb).并通过它们的摩尔电导戌\重,溶解度,红外光谱和电子吸收光谱对各种化合物进行了结构和性质的研究。     

Photophysical properties of borondipyrromethene analogues in solution

The photophysical properties of seven new 8-(p-substituted)phenyl analogues of 4,4-difluoro-3,5-dimethyl-8-(aryl)-4-bora-3a,4a-diaza-s-indacene (derivatives of the well-known fluorophore BODIPY) in several solvents have been studied by means of absorption and steady-state and time-resolved fluorimetry. For each compound, the fluorescence quantum yield and lifetime are lower in solvents with higher polarity owing to an increase in the rate of nonradiative deactivation. Increasing the electron withdrawing strength of the p-substituent on the phenyl group in position 8 also leads to lower fluorescence quantum yields and lifetimes. When the p-substituent on the phenyl group in position 8 is a tertiary amine [8-(4-piperidinophenyl), 8-(4-N,N-dimethylaminophenyl), and 8-(4-morpholinophenyl)], the low quantum yields of these compounds in more polar solvents can be rationalized by the inversion of the energy levels of an apolar, highly fluorescent and a polar, nonfluorescent excited state, where charge transfer from the tertiary amine to the BODIPY unit occurs. These amine analogues can be protonated at low pH in aqueous solution. Fluorescence titrations yielded pK(a) values of their conjugate ammonium salts which are in agreement with the electron donating tendency of the amine group: piperidino (4.15) > dimethylamino (2.37) > morpholino (1.47), with the pK(a) values in parentheses. The rate constant of radiative deactivation (k(f)) is the same for all compounds in all solvents studied (k(f) = 1.4 x 10(8) s(-1)).