膜流动电位测试中Ag-AgCl电极的制备及稳定性研究

膜的动电特性研究中,往往采用流动电位方法。该方法中,Ag-Ag Cl测试电极的质量是影响测试准确性的关键要素。本文采用正交试验设计和方差分析,着重考察电解法制备Ag-Ag Cl电极过程中,电流强度(I)、氯化时间(t)、电解质溶液浓度(CHCl)、电极来源(n)、烘烤温度(T)、活化电极溶液浓度(CKCl)等因素对Ag-Ag Cl电极稳定性的影响。得到Ag-Ag Cl电极的最优制备参数为:电流密度3.0m A/cm2,氯化时间50min,盐酸浓度0.1mol·L-1,烘烤温度120℃,活化电极溶液(KCl)浓度0.001mol·L-1;最显著影响因素为电极来源,显著影响因素为氯化时间和烘烤温度。对最优条件组合下制备的AgAg Cl电极,进行了稳定性实验,结果表明:制备的电极具有较好的稳定性,24h内电极电位漂移量小于0.10mv,7天内电极电位漂移量小于0.2mv;在聚偏氟乙烯中空纤维超滤膜流动电位测试中,流动电位与流动压差具有良好的线性和可重复性,回归曲线R20.99,变化规律符合Helmholtz-Smoluehowski公式,可以较好满足膜的流动电位测试要求。     

Ultrasound-assisted nanoscaled supramolecular coordination polymer as an efficient recyclable catalyst for photocatalytic degradation of dye pollutants

An ultrasound-assisted nanoscaled supramolecular coordination polymer (nanosized 1′ ) has been synthesized using a self-assembly reaction of K₃[Cu (CN)₄] and hexamethylenetetramine in the presence of Me₃SnCl under ambient conditions. Nanosized 1′ was examined using elemental analysis, Fourier transform–infrared, transmission electron microscopy, scanning electron microscopy and X-ray powder diffractions. It was structurally compared with the single crystal supramolecular coordination polymer ^∞₃[Cu₆(CN)₇(C₆H₁₂N₄)₂(OH₃)]; SCP 1. The photocatalytic activities of nanosized 1′ and SCP 1 toward different hazardous organic dyes were determined under ambient, UV-light irradiation and ultrasonic conditions. SCP 1 and nanosized 1′ as heterogeneous nanoparticles catalysts exhibited high catalytic activity for degradation of Congo Red, Methyl Violet 2B and Methylene Blue dyes. The effects of operational parameters on catalytic degradation process, identification of the degradation products and recycling of the catalyst were also investigated. SCP 1 and nanosized 1′ are recyclable heterogeneous catalysts and can be reused with efficient activities. The mechanism of degradation using different scavenger techniques iss proposed and discussed. The catalytic oxidation process is mainly caused by ^•OH radicals.     

Development of nanomaterial chemosensors for toxic metal ions sensing

Heavy metal ions are harmful to aquatic life and humans owing to their high toxicity and non‐biodegradability, so their removal from wastewater is an important task. Therefore, this work focuses on designing suitable, simple and economical nanosensors to detect and remove these metal ions with high selectivity and sensitivity. Based on this idea, different types of mesoporous materials such as hexagonal SBA‐15, cubic SBA‐16 and spherical MCM‐41, their chloro‐functionalized derivatives, as well as 4‐(4‐nitro‐phenylazo)‐naphthalen‐1‐ol (NPAN) azo dye have been synthesized, with the aim of designing some optical nanosensors for metal ions sensing applications. The mentioned azo dye has been anchored into the chloro‐functionalized mesoporous materials. The designed nanosensors were characterized using scanning and transmission electron microscopy as well as Fourier transform infrared and UV–visible spectral analysis, nitrogen adsorption–desorption isotherms, low‐angle X‐ray diffraction and thermogravimetric analyses. Their optical sensing to various toxic metal ions such as Cd (II), Hg (II), Mn (II), Fe (II), Zn (II) and Pb (II) at different values of pH (1.1, 4.9, 7 and 12) was investigated. The optimization of experimental conditions, including the effect of pH and metal ion concentration, was examined. The experimental results showed that the solution pH had a major impact on metal ion detection. The optical nanosensors respond well to the tested metal ions, as reflected by the enhancement in both absorption and emission spectra upon adding different concentrations of the metal salts and were fully reversible on adding ethylene diamine tetra acetic acid or citric acid to the formed complexes. High values of the binding constants for the designed nanosensors were observed at pHs 7 and 12, confirming the strong chelation of different metals to the nanosensor at these pHs. Also, high binding constants and sensitivity were observed for NPAN‐MCM‐41 as a nanosensor to detect the different metal ions. From the obtained results, we succeeded in transforming the harmful azo dye into an environmentally friendly form via designing of the optical nanosensors used to detect toxic metal ions in wastewater with high sensitivity.     

镁掺杂氧化铈整体式催化剂催化CO2和CH3OH直接合成碳酸二甲酯

采用共沉淀法成功地合成了不同Mg掺杂量的Ce_1-xMg_xO₂(x=0.05、0.10、0.15、0.20)固溶体催化材料,并运用透射电子显微镜(TEM)、X射线衍射(XRD)、氮气吸附-脱附测试、拉曼光谱、X射线光电子能谱(XPS)、CO₂程序升温脱附(CO₂-TPD)等技术对这些材料进行了表征。结果发现,通过调控CeO₂晶格中Mg的含量,可以调控所制备的Ce_1-xMg_xO₂催化材料的粒径、比表面积、表面缺陷等。其中Ce_0.90Mg_0.10O₂展现了最佳的表面性质,具有最小的平均粒径(约5.8 nm),最大的比表面积(约136 m2·g^-1)以及最高的表面氧含量(31.98%)。将Ce_1-xMg_xO₂催化材料涂覆在堇青石蜂窝陶瓷上制成整体催化剂,考察其对CO₂和CH₃OH直接合成碳酸二甲酯的催化性能。在140℃、2.4 MPa、反应2 h的条件下,Ce_0.90Mg_0.10O₂整体催化剂上碳酸二甲酯的收率高达20.21%,催化效果明显优于CeO₂和其余的Ce_1-xMg_xO₂(x=0.05、0.15、0.20)催化材料。     

金的化学状态对Au／CoCeOx催化剂CO氧化性能的影响

以CoCeOx复合氧化物为载体,采用沉积沉淀法制备了负载型的金催化剂,并通过不同温度的预处理控制Au的化学状态. 使用粉末X射线衍射、高分辨透射电子显微镜、程序升温还原和X射线光电子能谱对催化剂进行了表征,考察了在室温条件下该系列催化剂的一氧化碳氧化性能. 结果表明, Au/CoCeOx催化剂的CO氧化性能与催化剂表面Au 的含量成正比, Au 可能是反应的主要活性物种. 添加水汽对反应有一定的促进作用,但由于Au 不能稳定存在,特别是当催化剂表面Au 的含量过高时,在水汽的作用下Au 迅速发生歧化反应,使得催化剂的性能下降.     

Synthesis and Properties of Mononuclear and Homobinuclear Chelates of Mn(II), Co(II), Ni(II), and Cu(II) with Phthalein Purple

Mono- and homobinuclear complexes of Mn(II), Co(II), Ni(II), and Cu(II) with phthalein purple are prepared and characterized by elemental analysis, thermal studies (TGA and DTA), spectral methods (IR, UV/Vis, and ESR), magnetic moment determination, and electrochemical reduction (DC polarography at DME and CV at HMDE). Thermal degradation of the complexes was studied by TGA and DTA where some thermodynamic parameters were determined. The mode of bonding and geometry of the complexes were determined from the spectral studies. Magnetic moment values showed some antiferromagnetism in the homobinuclear complexes. The reduction of the metal ions proceeds to the metallic state along an irreversible process.     

UV-vis, IR and 1H NMR spectroscopic studies of some mono- and bis-azo-compounds based on 2,7-dihydroxynaphthalene and aniline derivatives

The absorption spectra of mono- and bis-azo-derivatives obtained by coupling the diazonium salts of aromatic amines and 2,7-dihydroxynaphthalene have been studied in six organic solvents. The different absorption bands have been assigned and the effect of solvents on the charge transfer band is also discussed. The diagnostic IR spectral bands and 1H NMR signals are assigned and discussed in relation to molecular structure. Also, semi-empirical molecular orbital calculations using the atom superposition and electron delocalization molecular orbital (ASED-MO) theory have been performed to investigate the molecular and electronic structures of these compounds. According to these calculations, an intramolecular hydrogen bonding is essential for stabilization of such molecules.     

Determination of Tedizolid Phosphate Using Graphene Nanocomposite Based Solid Contact Ion Selective Electrode; Green Profile Assessment by Eco-scale and GAPI Approach

Antibiotics determination plays a major role in minimizing antimicrobial resistance starting from quality control of pharmaceutical formulations to therapeutic drug monitoring. Green modified glassy carbon electrode has been developed for determination of tedizolid phosphate; new antibiotic prodrug; in presence of its active metabolite. The graphene transducer interlayer, dispersed with PVC, improved the electrode stability and standard potential reproducibility. Graphene hydrophobicity prevented the water layer formation between the sensing layers that decreased the potential drift down to 267 μV h⁻¹. Electrochemical impedance showed a low resistance value for graphene containing sensor due to its high electron transfer ability.     

4-氨基-7-硝基苯并-2-氧杂-1,3-二唑类衍生物的合成及其对汞离子的识别研究

以4-氯-7-硝基苯并-2-氧杂-1,3-二唑、乙二胺和溴乙酸乙酯等为原料,合成4-氨基-7-硝基苯并-2-氧杂-1,3-二唑类衍生物(NBD-OEt),通过IR、NMR和MS对其进行结构表征。研究NBD-OEt的吸收光谱和荧光光谱性质,探讨其在H2O/EtOH(60/40, V/V) pH 7.40的HEPES缓冲体系中对Hg₂ 的响应,以及NBD-OEt与Hg₂ 的结合模式。结果表明, 随Hg₂ 的不断加入可诱使NBD-OEt在476nm的吸收峰红移至514nm,并有两个等吸收点(347nm、482nm);其荧光发射峰由536nm红移至559nm,且在525nm出现等发射点;通过Job plot法测定NBD-OEt与Hg₂ 以1:1的计量比结合。     

Analysis of ultrasonic guided waves propagating in long bones and cortical thickness based on time-frequency methods

The ultrasonic signals in long bones contain multiple guided modes which are mutual superposed.The velocities of guided waves in long bones are very sensitive to cortical thickness (CTh).In this paper,Hilbert-Huang transform(HHT) was proposed to analyze multi-mode guided waves,which can decompose superposed waves into many independent modes.Then the group velocity of each mode was obtained at corresponding frequency,which was compared with the results of short time Fourier transform(STFT).The CTh was also obtained by comparing with the theoretical calculation.The results showed that the experimental determined thickness was in agreement with the actual CTh,indicating that measuring the velocity of the guided mode can be used to estimate the CTh.The HHT is an effective method to identify multimode guided waves.