Diversification of shotgun process

Three protocols for shotgun process are put forth in which simultaneous multi-fold reactions occur exclusively to each other. The first one involves simple combination of selective and non-selective reactions. Even if the simple protocol fails to give rise to the high selectivity, satisfactory outcome can be achieved by kinetic control or adjustment of functional groups.     

One‐Shot Double Elimination Process: A Practical and Concise Protocol for Diaryl Acetylenes

A variety of diaryl acetylenes were obtained in good yields when lithium hexamethyldisilazide was added to a solution of arylmethyl sulfone, aryl aldehyde, and chlorodiethylphosphate in THF. In this one‐shot process, a number of transformations such as aldol reaction, phosphorylation of aldolate, and double elimination of the resulting β‐substituted sulfone proceeded successively to afford the desired acetylenes. The one‐shot process was accelerated by the substitution of halogen atoms on the phenyl groups, and unsymmetrically substituted diaryl acetylenes were obtained without contamination of the dehalogenated products. Diaryl acetylenes with other substituents such as CF₃, ethoxycarbonyl, dimethylamino, TMS‐acetylene groups, as well as pyridinyl and thienyl moieties were also accessible with this method. However, methoxy‐substituted compounds were obtained in moderate yields under the same conditions, but the yields were increased when lithium diisopropylamide was used instead.     

Methane partial oxidation to formaldehyde with oxygen over SiO2-supported molybdenum oxide catalysts

The formation rate of formaldehyde increases with increasing surface area of SiO₂ support, but the selectivity does not. From the characterization of catalysts using XRD, SEM and Raman spectroscopy, highly dispersed molybdenum oxide was considered to be much more active for the formation of formaldehyde than crystallite forms of MoO₃.     

Fluorous distannoxane-catalyzed acetylation of alcohols in heterogeneous single fluorous solvent system

Acetylation of alcohols with an equivalent amount of acetic anhydride is feasible in the presence of fluorous distannoxane catalyst in heterogeneous single fluorous system. The fluorous layer containing catalyst can be recycled and reused at least 10 times.     

Studies of NO adsorption on Pt(110)-(1 x 2) and (1 x 1) surfaces using density functional theory

Adsorption of NO on Pt(110)-(1 x 2) and (1 x 1) surfaces has been investigated by density functional theory (DFT) method (periodic DMol(3)) with full geometry optimization and without symmetry restriction. Adsorption energies, structures, and N-O stretching vibrational frequencies of NO are studied by considering multiple possible adsorption sites and comparing with the experimental data. Adsorption is strongly dependent on both coverage and surface phase. The assignment of adsorption sites has been carried out with precise calculation of vibrational frequencies for NO on various sites. We clearly show the NO site switching on both of the surfaces as found in the experiments: at low coverages, bridge species is formed on the surface, and at high coverages, NO switches to atop sites.     

Metallocene bis(perfluoroalkanesulfonate)s as air-stable cationic Lewis acids

Zirconocene and titanocene bis(perfluorooctanesulfonate)s were synthesized. In contrast to the corresponding triflates and perchlorates, these compounds are air- and water-stable. They were proved to be ionic on the basis of conductivity measurements and X-ray analysis, allowing these complexes to be stored for months. The strong Lewis acidity of these cationic metallocene species, which was proved by ESR study, enabled catalytic glycosylation.     

Study of quantitative evaluation of liver volume and accumulation rate of radioactive agent with single photon emission computed tomography

The quantitative evaluation on measurement of liver volume and the hepatic accumulation rate of the radioactive agent were studied with respect to body constitution, background activity and splenic consumption rate, using single photon emission computed tomography (SPECT). The optical cut-off level for liver volume determination was proved to be reasonable as 35%. The background less than 5% had no influence to their clinical estimation with the error of less than 1.6%. The estimation of liver volume was mostly influenced by the splenic activity. When the splenic activity was increased two times of the hepatic activity, the liver volume was determined as 4.2% larger. Calculated counts by SPECT was well correlated with the hepatic activity. This study proved that SPECT was useful for the quantitative evaluation of the liver volume and the hepatic accumulation rate.