Magnetoelectric effect in cobalt ferrite-barium titanate composites and their electrical properties

CoFe₂O₄-BaTiO₃ composites were prepared using conventional ceramic double sintering process with various compositions. Presence of two phases in the composites was confirmed using X-ray diffraction. The dc resistivity and thermoemf as a function of temperature in the temperature range 300 K to 600 K were measured. Variation of dielectric constant (ɛ′) with frequency in the range 100 Hz to 1 MHz and also with temperature at a fixed frequency of 1 kHz was studied. The ac conductivity was derived from dielectric constant (ɛ′) and loss tangent (tan δ). The nature of conduction is discussed on the basis of small polaron hopping model. The static value of magnetoelectric conversion factor has been studied as a function of magnetic field.     

Analysis of methyl tert.-butyl ether and its degradation products by direct aqueous injection onto gas chromatography with mass spectrometry or flame ionization detection systems.

A method was developed to analyze methyl tert.-butyl ether (MTBE) and its degradation products by gas chromatography with mass spectrometry (GC-MS) or flame ionization detection (FID) with direct aqueous injection. The column had dimensions of 30 m x 0.25 mm with film thickness 0.25 microm and a stationary phase of FFAP (nitroterephthalic acid-modified polyethylene glycol). The optimized GC conditions for non-acid components were as follows: carrier gas flow-rate,l mL/min; oven temperature, 35 degrees C for 5.5 min, ramped to 90 degrees C at 25 degrees C/min, then ramped to 200 degrees C at 40 degrees C/min and held at 200 degrees C for 8 min. The conditions for the acid components were: carrier gas flow-rate, 1 mL/min; oven temperature, 110 degrees C for 2 min, ramped to 150 degrees C at 10 degrees C/min, then ramped to 200 degrees C at 40 degrees C/min. The injection port contained a silanized-glass reverse-cup liner filled with Carbofrit. The minimum concentrations for the linear range for the selective ion monitoring mode were 30 to 100 microg/L, depending on the analytes. The minimum detection limit was 1 mg/L for MTBE and tert.-butanol when using FID. More components could be analyzed with the FFAP-type column than with the cyanopropylphenyl-dimethyl polysiloxane-type column.     

The onset of coulomb explosions in polyatomic molecules

With the development of high intensity femtosecond lasers, the ionisation and dissociation dynamics of molecules has become an area of considerable interest. Using the technique of femtosecond laser mass spectrometry (FLMS), the molecules carbon disulphide, pyrimidine, toluene, cyclohexanone and benzaldehyde are studied with pulse widths of 50 fs in the near infrared (IR) wavelength region (790 nm). Results are presented and contrasted for laser beam intensities around 10(15) and 10(16) W cm(-2). For the lower intensities, the mass spectra yield dominant singly charged parent ions. Additionally, the appearance of doubly charged parent ions is evident for carbon disulphide, toluene and benzaldehyde with envelopes of doubly charged satellite species existing in these local regions. Carbon disulphide also reveals a small triply charged component. Such atomic-like features are thought to be a strong fingerprint of FLMS at these intensities. However, upon increasing the laser intensity to approximately 10(16) W cm(-2), parent ion dominance decreases and the appearance of multiply charged atomic species occurs, particularly carbon. This phenomenon has been attributed to Coulomb explosions in which the fast absorption of many photons may produce transient highly ionised parent species which can subsequently blow apart. Copyright 1999 John Wiley & Sons, Ltd.     

Uniform molecular analysis using femtosecond laser mass spectrometry

The potential of femtosecond laser time-of-flight mass spectrometry (FLMS) for uniform quantitative analysis of molecules has been investigated. Various samples of molecular gases and vapours have been studied, using ultra-fast ( approximately 50 fs) laser pulses with very high intensity (up to 1.6 x 10(16) Wcm(-2)) for non-resonant multiphoton ionisation/tunnel ionisation. Some of these molecules have high ionisation potentials, requiring up to ten photons for non-resonant ionisation. The relative sensitivity factors (RSF) have been determined as a function of the laser intensity and it has been demonstrated that for molecules with very different masses and ionisation potentials, uniform ionisation has been achieved at the highest laser intensities. Quantitative laser mass spectrometry of molecules is therefore a distinct possibility. Copyright 1999 John Wiley & Sons, Ltd.     

Interpreting early land management through compound specific stable isotope analyses of archaeological soils

Compound specific stable isotope analyses of managed soils using isotope ratio mass spectrometry have been undertaken as a means of determining early land use practices. delta (15)N amino acid signals demonstrate differences between manured grassland, unmanured grassland and continuous cereal cultivation under long-term experimental land use control conditions, with delta (15)N in hydrophobic amino acids providing the most distinctive signals. Analysis of early modern/medieval and of Bronze age anthropogenic soils from Orkney demonstrates that such signals are retained in archaeological contexts. delta (13)C analyses of n- alkanoic acid components of the fossil, Bronze Age, anthropogenic soils suggest a major terrestrial input to these soils, with uniform composition of formation materials. Surficial soils demonstrate the assimilation of isotopically lighter carbon, providing a means of assessing the mobility of the n- alkanoic acids within soils and sediments. Copyright 1999 John Wiley & Sons, Ltd.     

Sulfonated diiron complexes as water-soluble models of the [Fe-Fe]-hydrogenase enzyme active site

A series of diiron complexes developed as fundamental models of the two-iron subsite in the [FeFe]-hydrogenase enzyme active site show water-solubility by virtue of a sulfonate group incorporated into the -SCH(2)NRCH(2)S- dithiolate unit that bridges two Fe(I)(CO)(2)L moieties. The sulfanilic acid group imparts even greater water solubility in the presence of β-cyclodextrin, β-CyD, for which NMR studies suggest aryl-sulfonate inclusion into the cyclodextrin cavity as earlier demonstrated in the X-ray crystal structure of 1Na·2 β-CyD clathrate, where 1Na = Na(+)(μ-SCH(2)N(C(6)H(4)SO(3)(-))CH(2)S-)[Fe(CO)(3)](2), (Singleton et al., J. Am. Chem. Soc.2010, 132, 8870). Electrochemical analysis of the complexes for potential as electrocatalysts for proton reduction to H(2) finds the presence of β-CyD to diminish response, possibly reflecting inhibition of structural rearrangements required of the diiron unit for a facile catalytic cycle. Advantages of the aryl sulfonate approach include entry into a variety of water-soluble derivatives from the well-known (μ-SRS)[Fe(CO)(3)](2) parent biomimetic, that are stable in O(2)-free aqueous solutions.