Formation of porous polymer morphology by microsyneresis during divinylbenzene polymerization

This article describes the investigation of the importance of various reaction conditions on microsyneretic pore formation during polymerization of divinylbenzene (DVB) under so‐called “solvothermal” conditions. To induce microsyneretic pore formation, the most important parameter is an unusually high dilution of monomers with a “good” porogen solvating the polymer chains. High dilution and solvation of the growing poly(DVB) chains promote the prolongation of the polymer chains rather than their interconnection by crosslinking. Consequently, when the polymer gel density reaches the point where syneresis starts, the polymer network is geometrically too extensive to be broken up into precipitating entities and, instead, porogen droplets are formed within the continuous polymer gel. The pore geometry created by microsyneresis offers high surface area in wide mesopores and hence, high capacity for supporting functional groups or reactions with much better accessibility than narrow pores between polymer microspheres produced by macrosyneresis in conventional styrenic polymer supports. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 774–781     

FEM study of palladium and molybdenum clusters on an alumina covered field emitter

Palladium and molybdenum polycrystalline layers (clusters) have been deposited in a stainless steel UHV system onto a layer of alumina (Al₂O₃). This layer has been prepared by high temperature oxidation of an aluminium layer. The interaction of this system with nitrogen has been investigated at room temperature by an FEM technique. Under these conditions nitrogen spillover from molybdenum to palladium has been observed.     

Prediction of chromatographic retention of metal complexes from stability constants measured by ion chromatography

Chromatographia - A theoretical model is used to predict retention times of divalent metal cations in single-column ion chromatography using one or more ligands in the eluent. Stability constants...     

On a conjecture of Cox and Katz

This note shows that a certain toric quotient of the quintic Calabi-Yau threefold in provides a counterexample to a recent conjecture of Cox and Katz concerning nef cones of toric hypersurfaces. Received: 8 February 2001; in final form: 17 September 2001 / Published online: 1 February 2002     

Diffusion Structural Analysis Study of Titania Films Deposited by Sol-Gel Technique on Silica Glass

The diffusion structural analysis (DSA) was used to characterize microstructure changes of hydrous titania gel films under in situ conditions of heating. TG and DTA were used in order to elucidate the processes controlling the formation of anatase film during heating of hydrous titania gel film. The annealing of porosity and near surface structure defects of the dehydrated titania films was indicated by DSA in the temperature range 255–700°C as the decrease of radon release rate. It was demonstrated that the annealing was enhanced on heating in oxygen in comparison with heating in argon. The DSA experimental results were compared with model curves describing the radon diffusion mobility and the annealing of radon diffusion paths.     

The kinetics of the light-induced defect creation in hydrogenated amorphous silicon – Stretched exponential relaxation

Our model for light-induced defect creation in hydrogenated amorphous silicon is applied to its kinetics, i.e., the growing curve of light-induced dangling bond density as a function of illumination time, which is fitted to a stretched exponential function. Two parameters β and τ involved in the function are estimated as functions of saturated dangling bond density in terms of our model. These are compared with two experimental results, i.e., our results obtained from ESR measurements and Shimakawa et al.’s results obtained from photoconductivity measurements. The saturated dangling bond density is also measured as a function of the generation rate of free carriers. The experimental results are compared with calculated results and discussed.