Strategies for the development of a voltammetric sensor for the determination of hydrogen peroxide at high concentrations

Different strategies are presented for the development of a voltammetric sensor for in-line measurement and monitoring of H₂O₂ in high concentrations (up to 30 g/l) as used in textile bleaching systems. When using macroelectrodes, signal saturation is observed even at medium concentrations. Some improvement can be achieved by hydrodynamic electrodes like ring-disk electrodes. Satisfactory results up to the desired level in practical solutions (possessing only limited conductivity) are obtained with Pt-microelectrodes.     

Synthese von ungesättigten und gesättigten Aminosäurederivaten durch kathodische Reduktion von Azidozimtsäureester

Cathodic reduction of -azidocinnamic ester under aprotic conditions on Hg, Pt, or graphite electrodes can be directed to high yields of N,N-diacylated dehydroaminoacid derivates (f.i. addition of acetic anhydride) or to almost quantitative yields of -aminocinnamic ester in very pure form by careful addition of H⁺-donors. The dehydroamino compounds in turn can be further reduced to the corresponding saturated compounds by following H⁺-addition and changed electrolysis potential. Almost no dimerization occurs.

     

Investigation of the pharmacokinetics of celecoxib by liquid chromatography-mass spectrometry

A new method for the quantification of celecoxib in human plasma based on reversed-phase high-performance liquid chromatography (HPLC) coupled to atmospheric pressure chemical ionization (APCI) mass spectrometry (MS) after liquid-liquid extraction is presented. The method is rapid, sensitive and highly selective. The retention time of celecoxib was 2.3 min. The limit of quantification was 5 microg/L. Rofecoxib was used as internal standard. After validation, the method was used to study the pharmacokinetic profile of celecoxib following administration of a single oral dose (200 mg) in 12 healthy volunteers. Since celecoxib should be metabolized primarily by cytochrome 2C9 (CYP2C9), a poor metabolizer (PM) for this cytochrome P450 enzyme was included in the study. Pharmacokinetic characteristics (mean +/- SD) of extensive metabolizers (EM) were t(max) 2.9+/-1.2h, c(max) 842+/-280 microg/L, AUC(infinity) 6246+/-2147 microg h/L and t(1/2) 7.8+/-2.7h. The area under the curve (AUC(infinity)) for the PM was 12561 microg h/L. However, we found no noticeable increase in half life in the PM (11.5 h) after a single dose of celecoxib.     

The μSR facilities at PSI

TheSR Facility Instruments presently available at PSI and the envisaged medium- and long-term developments are presented. The plans focus on further upgrades of the existing instruments and the development of new techniques using the very high fluxes becoming available at PSI, in particular the setup of a beamline with a fast kicker for muons on request (MORE) and the development of very low energy muon beams.     

A liquid chromatography-mass spectrometry method for the quantification of both etoricoxib and valdecoxib in human plasma

A practicable and selective liquid chromatography-mass spectrometry assay for the determination of two cyclooxygenase-2 inhibitors, etoricoxib and valdecoxib, in human plasma is presented. The analytical technique is based on reversed-phase high-performance liquid chromatography (HPLC) coupled to atmospheric pressure chemical ionisation (APCI) mass spectrometry (Finnigan Mat LCQ ion trap). Mass analysis was performed in the positive ion mode. The ion trap was operated in the tandem MS mode (MS2) and the transitions of etoricoxib (m/z 359.2 --> 280.3) and valdecoxib (m/z 315.1 --> 235.1) were followed by selected reaction monitoring. Retention times of etoricoxib and valdecoxib were 1.05 and 1.08 min, respectively. The method was validated over a linear range 10-2500 and 5-1000 microg/L using the other substrate as internal standard. After validation, the method was used to study the pharmacokinetic pro fi le of etoricoxib or valdecoxib in a healthy volunteer after administration of a single oral dose (valdecoxib, 20 mg; etoricoxib, 90 mg). The presented method was suf fi cient to cover more than 90% of the area under the plasma concentration time curve.     

TEXTURE AND CRYSTALLINITY EVOLUTION IN ISOTACTIC POLYPROPYLENE INDUCED BY ROLLING AND THEIR INFLUENCE ON MECHANICAL PROPERTIES

The orientation and crystallinity evolution of isotactic polypropylene （iPP） induced by rolling were studied using wide angle X-ray scattering with an area detector. The tensile mechanical properties of rolled isotactic polypropylene sheets were also measured in this work. The texture component method was used to analyze the rolling texture. The rolling texture consists mainly of （010）[001], （130）[001] and [001]//RD fiber components in the sample with a rolling true strain of 1.5. The results reveal that crystallinity drastically decreases during rolling. It is suggested that amorphization is a deformation mechanism which takes place as an alternative to crystallographic intralamellar slip depending on the orientation of the lamellae. Both the orientation and crystallinity affect the tensile mechanical properties of rolled polypropylene. Crystallinity influences the elastic modulus on both directions and yield strength on transverse direction at the first stage of deformation. Orientation is the main reason for the changes of mechanical properties, especially at the latter part of deformation. The changes of both tensile strength and elongation percentage on rolling direction are larger than those on transverse direction, which results from the orientation. At last, the anisotropic mechanical properties occur on the rolling and transverse direction： high tensile strength with low elongation percentage on rolling direction and low tensile strength with high elongation percentage on transverse direction.     

Cathodic reduction of SO2 in the presence of organic dihalides

The reaction of the electrolytically generated SO ₂ ^– anion radical with 1,-dihalides is used for the synthesis of sulfur containing heterocycles like oxathiolane-, oxathiane-, thiane- and thiepane-oxides. 1,2-Dihalides are reductively deblocked to give olefines.

---

Kathodische Reduktion von SO₂ in Gegenwart organischer Dihalogenide

Zusammenfassung Die Reaktion des elektrolytisch erzeugten SO ₂ ^– -Anionradikals mit 1,-Dihalogeniden führt zu schwefelhaltigen Heterocyclen wie Oxathiolan-, Oxathian-, Thian- und Thiepanoxiden. 1,2-Dihalogenide geben durch reduktive Eliminierung Olefine.

     

Pd@SnO2 and SnO2@Pd Core@Shell Nanocomposite Sensors

Pd@SnO₂ and SnO₂@Pd core@shell nanocomposites are prepared via a microemulsion approach. Both nanocomposites exhibit high‐surface, porous matrices of SnO₂ shells (>150 m² g^?1) with very small SnO₂ crystallites (<10 nm) and palladium (Pd) nanoparticles (<10 nm) that are uniformly distributed in the porous SnO₂ matrix. Although similar by first sight, Pd@SnO₂ and SnO₂@Pd are significantly different in view of their structure with Pd inside or outside the SnO₂ shell and in view of their sensor performance. As SMOX‐based sensors (SMOX: semiconducting metal oxide), both nanocomposites show a very good sensor performance for the detection of CO and H₂. Especially, the Pd@SnO₂ core@shell nanocomposite is unique and shows a fast response time (τ₉₀ < 30 s) and a very good response at low temperature (<250 °C), especially under humid‐air conditions. Extraordinarily high sensor signals are observed when exposing the Pd@SnO₂ nanocomposite to CO in humid air. Under these conditions, even commercial sensors (Figaro TGS 2442, Applied Sensor MLC, E2V MICS 5521) are outperformed.     

Irreversible Structural Changes of Copper Hexacyanoferrate Used as a Cathode in Zn-Ion Batteries

The structural changes of copper hexacyanoferrate (CuHCF), a Prussian blue analogue, which occur when used as a cathode in an aqueous Zn-ion battery, are investigated using electron microscopy techniques. The evolution of Zn_xCu_1−xHCF phases possessing wire and cubic morphologies from initial CuHCF nanoparticles are monitored after hundreds of cycles. Irreversible introduction of Zn ions to CuHCF is revealed locally using scanning transmission electron microscopy. A substitution mechanism is proposed to explain the increasing Zn content within the cathode material while simultaneously the Cu content is lowered during Zn-ion battery cycling. The present study demonstrates that the irreversible introduction of Zn ions is responsible for the decreasing Zn ion capacity of the CuHCF cathode in high electrolyte concentration.