Study of the reactione + e −→K + K − in the energy range1350 \leqq \sqrt s \leqq 2400 MeV

Thee ⁺ e ^?→K ⁺ K ^? cross section has been measured from about 750 events in the energy interval \(1350 \leqq \sqrt s \leqq 2400 MeV\) with the DM2 detector at DCI. TheK ^± form factor |F _F ^±| cannot be explained by the ρ, ω, ? and ρ′(1600). An additional resonant amplitude at 1650 MeV has to be added as suggested by a previous experiment.     

Photoelectrochemistry on Ru(II)-2,2'-bipyridine-phosphonate-derivatized TiO2 with the I3-/I- and quinone/hydroquinone relays. Design of photoelectrochemical synthesis cells

Photocurrent measurements have been made on nanocrystalline TiO2 surfaces derivatized by adsorption of a catalyst precursor, [Ru(tpy)(bpy(PO3H2)2)(OH2)]2+, or chromophore, [Ru(bpy)2 (bpy(PO3H2)2)]2+ (tpy is 2,2':6',2' '-terpyridine, bpy is 2,2'-bipyridine, and bpy(PO3H2)2 is 2,2'-bipyridyl-4,4'-diphosphonic acid), and on surfaces containing both complexes. This is an extension of earlier work on an adsorbed assembly containing both catalyst and chromophore. The experiments were carried out with the I3-/I- or quinone/hydroquinone (Q/H2Q) relays in propylene carbonate, propylene carbonate-water mixtures, and acetonitrile-water mixtures. Electrochemical measurements show that oxidation of surface-bound Ru(III)-OH2(3+) to Ru(IV)=O(2+) is catalyzed by the bpy complex. Addition of aqueous 0.1 M HClO4 greatly decreases photocurrent efficiencies for adsorbed [Ru(tpy)(bpy(PO3H2)2)(OH2)]2+ with the I3-/I- relay, but efficiencies are enhanced for the Q/H2Q relay in both propylene carbonate-HClO4 and acetonitrile-HClO4 mixtures. The dependence of the incident photon-to-current efficiency (IPCE) on added H2Q in 95% propylene carbonate and 5% 0.1 M HClO4 is complex and can be interpreted as changing from rate-limiting diffusion to the film at low H2Q to rate-limiting diffusion within the film at high H2Q. There is no evidence for photoelectrochemical cooperativity on mixed surfaces containing both complexes with the IPCE response reflecting the relative surface compositions of the two complexes. These results provide insight into the possible design of photoelectrochemical synthesis cells for the oxidation of organic substrates.     

Application of time-resolved infrared spectroscopy to electronic structure in metal-to-ligand charge-transfer excited states

Infrared data in the nu(CO) region (1800-2150 cm(-1), in acetonitrile at 298 K) are reported for the ground (nu(gs)) and polypyridyl-based, metal-to-ligand charge-transfer (MLCT) excited (nu(es)) states of cis-[Os(pp)2(CO)(L)](n)(+) (pp = 1,10-phenanthroline (phen) or 2,2'-bipyridine (bpy); L = PPh3, CH(3)CN, pyridine, Cl, or H) and fac-[Re(pp)(CO)3(4-Etpy)](+) (pp = phen, bpy, 4,4'-(CH3)2bpy, 4,4'-(CH3O)2bpy, or 4,4'-(CO2Et)2bpy; 4-Etpy = 4-ethylpyridine). Systematic variations in nu(gs), nu(es), and Delta(nu) (Delta(nu) = nu(es) - nu(gs)) are observed with the excited-to-ground-state energy gap (E(0)) derived by a Franck-Condon analysis of emission spectra. These variations can be explained qualitatively by invoking a series of electronic interactions. Variations in dpi(M)-pi(CO) back-bonding are important in the ground state. In the excited state, the important interactions are (1) loss of back-bonding and sigma(M-CO) bond polarization, (2) pi(pp*-)-pi(CO) mixing, which provides the orbital basis for mixing pi(CO)- and pi(4,4'-X(2)bpy)-based MLCT excited states, and (3) dpi(M)-pi(pp) mixing, which provides the orbital basis for mixing pipi- and pi(4,4'-X(2)bpy*-)-based MLCT states. The results of density functional theory (DFT) calculations on the ground and excited states of fac-[Re(I)(bpy)(CO)3(4-Etpy)](+) provide assignments for the nu(CO) modes in the MLCT excited state. They also support the importance of pi(4,4'-X2bpy*-)-pi(CO) mixing, provide an explanation for the relative intensities of the A'(2) and A' ' excited-state bands, and provide an explanation for the large excited-to-ground-state nu(CO) shift for the A'(2) mode and its relative insensitivity to variations in X.     

Pressure-dependent Fourier transform infrared spectroscopy of a poly (ester urethane)

The effects of hydrostatic pressure upon (1) a segmented poly (ester urethane), (2) a hydrolytically degraded sample of the same polymer, and (3) models for the polyurethane and polyester segments in this polymer have been studied by Fourier transform infrared spectroscopy using high-pressure diamond anvil cells (DACs). The pressure responses of the vibrational frequencies of specific functional groups of the poly (ester urethane) in the 0-100-kbar range are compared with data for individual segment models and the partially degraded sample. The results indicated that the polymer is highly stable in this pressure regime, with no measurable degradation or phase changes. Differences in the pressure dependency of specific infrared bands between the poly (ester urethane) sample and the partially degraded sample are slight and consistent with changes in hydrogen-bonding interactions and shorter chain lengths in the degraded sample.     

Radiative decay ofJ/ψ into γ π+ π−

The radiative decayJ/ψ → γ π⁺ π^? has been studied using the 8.6 millionJ/ψ produced in the DM2 experiment at the DCIe ⁺e^? storage rings at Orsay. The π⁺ π^? mass spectrum shows a cleanf ₂ (1270) signal, and the possible presence of two other states at thef ₂ (1720) andf ₄ (2030) masses. For thef ₂ (1270), the branching ratio BR(J/ψ →γf)xBR(f→π⁺ π^?) is measured to be (7.50±0.30±1.12)×10^?4, and the spin analysis prefers theJ=2 assignment, with helicity parametersx=0.83±0.06 andy=0.01±0.06. The existence of higher mass states is discussed.     

Three-photon-induced fluorescence of diphenylhexatriene in solvents and lipid bilayers

We observed the emission of l,6-diphenyl-l,3,5-hexatriene (DPH) when excited with the fundamental output of a fs Ti:sapphire laser at 860 nm. The emission spectra of DPH were identical to that observed for one-photon excitation at 287 nm. The dependence of the DPH emission intensity on laser power was cubic, indicating three-photon excitation of DPH at 860 nm. At a shorter wavelength of 810 nm, the dependence on laser power was quadratic, indicating a two-photon process. At an intermediate wavelength of 830 nm the mode of excitation was a mixture of two- and three-photon excitation. At 830 nm the anisotropy is no longer a molecular parameter, and the mode of excitation and anisotropy of DPH depends on laser power. Frequency-domain anisotropy decays of DPH in triacetin revealed the same rotational correlation times for two- and three-photon excitation. However, the time 0 anisotropy of DPH was larger for three-photon excitation than for two-photon excitation. Steady-state anisotropy data for DPH-labeled membranes revealed the same transition temperature for one- and three-photon excitation. These anisotropy data indicate that membrane heating was not significant with three-photon excitation and that three-photon excitation may thus be of practical usefulness in fluorescence spectroscopy and microscopy of membranes.     

Non-planar smoulder propagation governed by diffusion

The steady propagation of a thin smouldering front in a half-spacehas been considered. A suitable coordinate transformation hasallowed the region near the leading edge of the front to beexamined for both a maintained planar surface and with surfacecollapse due to material shrinkage. The change in the oxidizerconcentration for a small increment in the propagation speedfor large time and surface collapse has been determined. Theinfluence of two types of nonlinear diffusion on the shape ofthe smouldering front has been found; other cases can be dealtwith in a similar manner.     

Synthesis, structure, and electronic properties of a dimer of Ru(bpy)2 doubly bridged by methoxide and pyrazolate

The heterobridged dinuclear complex cis,cis-[(bpy) 2Ru(mu-OCH 3)(mu-pyz)Ru(bpy) 2] (2+) ( 1; bpy = 2,2'-bipyridine; pyz = pyrazolate) was synthesized and isolated as a hexafluorophosphate salt. Its molecular structure was fully characterized by X-ray crystallography, (1)H NMR spectroscopy, and ESI mass spectrometry. The compound 1.(PF 6) 2 (C 44H 38F 12N 10OP 2Ru 2) crystallizes in the monoclinic space group P2 1/ c with a = 13.3312(4) A, b = 22.5379(6) A, c = 17.2818(4) A, beta = 99.497(2) degrees , V = 5121.3(2) A (3), and Z = 4. The meso diastereoisomeric form was exclusively found in the crystal structure, although the NMR spectra clearly demonstrated the presence of two stereoisomers in solution (rac and meso forms at approximately 1:1 ratio). The electronic properties of the complex in acetonitrile were investigated by cyclic voltammetry and UV-vis and NIR-IR spectroelectrochemistries. The stepwise oxidation of the Ru (II)-Ru (II) complex into the mixed-valent Ru (II)-Ru (III) and fully oxidized Ru (III)-Ru (III) states is fully reversible on the time scale of the in situ (spectro)electrochemical measurements. The mixed-valent species displays strong electronic coupling, as evidenced by the large splitting between the redox potentials for the Ru(III)/Ru(II) couples (Delta E 1/2 = 0.62 V; K c = 3 x 10 (10)) and the appearance of an intervalence transfer (IT) band at 1490 nm that is intense, narrow, and independent of solvent. Whereas this salient band in the NIR region originates primarily from highest-energy of the three IT transitions predicted for Ru(II)-Ru(III) systems, a weaker absorption band corresponding to the lowest-energy IT transition was clearly evidenced in the IR region ( approximately 3200 cm (-1)). The observation of totally coalesced vibrational peaks in the 1400-1650 cm (-1) range for a set of five bpy spectator vibrations in Ru (II)-Ru (III) relative to Ru (II)-Ru (II) and Ru (III)-Ru (III) provided evidence for rapid electron transfer and valence averaging on the picosecond time scale. Other than a relatively short Ru...Ru distance (3.72 A for the crystalline Ru (II)-Ru (II) complex), the extensive communication between metal centers is attributed mostly to the pi-donor ability of the bridging ligands (pyz, OMe) combined with the pi-acceptor ability of the peripheral (bpy) ligands.     

Synthesis and characterization of oligoproline-based molecular assemblies for light harvesting

Helical oligoproline arrays provide a structurally well-defined environment for building photochemical energy conversion assemblies. The use of solid-phase peptide synthesis (SPPS) to prepare four such arrays, consisting of 16, 17, 18, and 19 amino acid residues, is described here. Each array contains the chromophore [Rub'(2)m](PF(6))(2) (b' = 4,4'-diethylamidocarbonyl-2,2'-bipyridine; m = 4-methyl-2,2'-dipyridine-4'-carboxylic acid) and the electron transfer donor PTZ (phenothiazine). The arrays differ systematically in the distance between the redox-active metal complex and PTZ sites. They have been used in photophysical studies to provide insight into the distance dependence of electron transfer. (J. Am. Chem. Soc. 2004, 126, 14506-14514). This work describes the synthesis, purification, and characterization of the oligoproline arrays, including a general procedure for the synthesis of related arrays.