Photodiffraction in InGaAs/InGaAsP multiple quantum wells enclosed in a microcavity

We report new results on the diffraction properties of photoinduced gratings in InGaAs/InGaAsP MQW structures. The original feature of this device is that the QWs are enclosed in an asymmetric Fabry–Perot microcavity in order to increase the diffraction efficiency. We observe oscillations in the diffraction efficiency due to resonant effects in the microcavity. The experimental spectra are compared with theory. Diffraction efficiency at 1.55 μm attains a maximum value of 2.7% at a write beam fluence of 260 μ J cm⁻², and then decreases at higher fluences. We explain this phenomenon by an absorption saturation at high excitation.     

Mode beating in spot-size converter lasers

An anomalous modulation in the wavelength spectrum has been observed in lasers with spot-size converters. This intensity modulation is shown to be caused by beating between the fundamental lasing mode and radiation modes in the taper. This results in a periodic modulation in the net gain spectrum, which causes wavelength jumps between adjacent net gain maxima, and a drive current dependent spectral width that is expected to affect system performance. The amplitude of this spectral modulation is reduced significantly by either using an angled rear-facet which reflects the beating radiation modes away from the laser axis, or by using a nonlinear, adiabatic taper.     

Amphoteric trap modeling of multidielectric scaled SONOS nonvolatile memory structures

We have characterized multidielectric scaled SONOS nonvolatile memory structures with the quasi-static linear voltage ramp (LVR) technique and dynamic pulse measurements. We have formulated physically-based ERASE/WRITE and retention methods with deep level amphoteric traps which capture and emit carriers to the bands in the silicon nitride film. Amphoteric trap parameters are extracted by the LVR technique. ERASE/WRITE and retention amphoteric trap model simulations agree well with the experimental dynamic pulse measurements. Experimental scaled SONOS structures have been fabricated with tunnel oxide X_OT=20 Å, nitride X_N=30 Å and blocking oxide X_OB=55 Å and demonstrated a static flatband shift of 3.6 V with ±5 V programming voltages. These structures may be used as the nonvolatile memory element in high density VLSI circuits.     

Inhibition of the reduction of Cr(VI) at the magnetite–water interface by calcium carbonate coatings

The effect of calcium carbonate coatings on the reduction of aqueous chromate on the magnetite(1 1 1) surface has been investigated using a combination of synchrotron based X-ray photoemission spectroscopy (PES) and X-ray absorption near edge structure (XANES) spectroscopy, along with laboratory-based powder X-ray diffraction (XRD) and scanning electron microscopy (SEM). CaCO₃ coatings (dominantly calcite with minor quantities of aragonite and vaterite) of thicknesses ranging from 10 Å to 20 m were grown on magnetite(1 1 1) surfaces by exposure to supersaturated aqueous solutions followed by evaporation of the solution—a process that mimics pore-water evaporation in vadose zones leading to the formation of caliche and calcium carbonate coatings on mineral grains. Coating thicknesses were determined from attenuation of the Fe 2p photoemission signal by the carbonate coating. For coatings less than 15 Å thick, Cr 2p photoemission and Cr L_II, L_III-edge XANES spectra show that chromate is reduced by the underlying magnetite surface; however, as the minimum coating thickness increases beyond 15 Å, the magnetite surface becomes passivated and further chromate reduction ceases. Our findings suggest that carbonate coatings on natural magnetite grains can significantly reduce or eliminate their ability to reduce Cr(VI), which is a toxic and highly mobile environmental contaminant.     

Fluorinations with complex metal fluorides. Part 6 [1] fluorination of yridine and related compounds with caesium tetrafluorocobaltate(III) [2]

Pyridine has been fluorinated over caesium tetrafluorocobaltate(III) (CsCo^IIIF₄) at 300–400°C to give a mixture of undecafluoro-N-methylpyrrolidine, bis(trifluoromethyl)amine, pentafluoropyridine and several polyfluoropyridines; the product composition depended to some extent on the geometry of the reactor. The fluorinations of pentafluoropyridine, piperidine and undecafluoropiperidine were also investigated.